Search USGS⌕ Search

USGS · sir20245079

Geomorphic change, hydrology, and hydraulics of Caulks Creek, Wildwood, Missouri

Abstract

Caulks Creek is a small stream that flows through the city of Wildwood in western St. Louis County, Missouri. The U.S. Geological Survey, in cooperation with the city of Wildwood, has documented historical and recent geomorphic change along Caulks Creek, simulated the hydrologic and hydraulic response of Caulks Creek to a variety of design storm scenarios, and simulated bank retreat resulting from fluvial erosion and mass failure processes. Six study reaches were selected for monitoring geomorphic change based on known locations of erosion issues documented by the city of Wildwood. Recent short-term rates and patterns of geomorphic change in the study reaches, with a focus on bank retreat, were determined from repeat terrestrial light detection and ranging surveys and field observations of the six study reaches. Historical aerial photographs of the study reaches were analyzed to determine long-term rates of bank retreat and channel widening. In general, rapid bank retreat and widening was observed at the outer banks of meander bends and where banks are unforested. Short-term bank retreat varied substantially within individual study reaches, across the study area, and during the study period from no change to as much as 16 feet of retreat between consecutive surveys (5 to 8 months). The field surveys and visual observations indicated that bank retreat occurs episodically owing to a combination of fluvial erosion and mass failure processes, as well as freezing and thawing cycles. Long-term rates of bank retreat ranged from 0.6 to 4.4 feet per year. Hydrologic and hydraulic models of Caulks Creek were used to quantify the peak, volume, and timing of the flow response and the spatial distribution of hydraulic drivers of erosion (velocity and shear stress) along Caulks Creek for design storm scenarios that represent current (as of this publication) and projected future climate. The projected climate conditions resulted in higher peak flows compared to current conditions, including 6 to 21 percent for the year 2050 and 10 to 42 percent for the year 2099 at the downstream end of the study area. Additionally, for a given design storm, projected climate change is predicted to result in faster flows with greater shear stress, as well as more within-stream variability in velocity and shear stress. Many factors affect the velocity and shear stress at a given location, but in general, somewhat fast velocities and high shear stresses tended to occur where the channel is relatively narrow and straight. The velocity and shear stress in the study reaches (known areas of widening and bank retreat) were not particularly high, at least in part owing to the relatively large widths and high sinuosity of the present-day channel in these reaches. The potential mitigating effect of adding runoff storage to the basin also was examined for a selection of design storm scenarios. Additional runoff storage was more effective at mitigating peak flows and total runoff volumes for higher-frequency, lower-intensity storms than for lower-frequency, higher-intensity storms. The additional storage also resulted in an overall reduction in velocity (by as much as 28 percent) and shear stress (by as much as 40 percent) in the study area. However, the effect of the additional storage on peak flows, total runoff volumes, velocity, and shear stress decreased with distance downstream through the study area. For the simulated scenarios, added runoff storage was effective at mitigating the increases in peak flows, total runoff volumes, velocity, and shear stress caused by projected climate change. Lastly, the bank stability and toe erosion model (BSTEM) was used to predict bank erosion and potential bank failure surfaces at five locations along Caulks Creek for a selection of design storm scenarios. The lower-frequency, higher-magnitude design storms resulted in more bank retreat than the higher-frequency, lower-magnitude design storms, though the magnitude of the difference was site dependent. Although scenarios with additional storage were not directly simulated in BSTEM, it is likely that the additional storage would result in reduced bank retreat compared to the same design storm with existing storage, based on the hydraulic modeling results for scenarios with added runoff storage.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 38.5667° to 38.66° latitude; -90.66° to -90.5° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Jessica Z. LeRoy, David C. Heimann, Kyle D. Hix, Charles V. Cigrand, Tyler J. Burk. 2024-09-18. Geomorphic change, hydrology, and hydraulics of Caulks Creek, Wildwood, Missouri. https://doi.org/10.3133/sir20245079

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Evaluating the number of realizations (train-test splits) necessary to ensure robust estimates of conventional hydrothermal resource favorability using Monte Carlo cross-validation, the Great Basin, Western USA

Supervised machine learning approaches used to produce favorability maps in resource assessments commonly partition an input dataset into training and testing subsets (that is, through train-test splits). However, if a single split is not representative of underlying resource conditions, the resulting favorability map may be biased, particularly with sparse or heterogeneous datasets. To mitigate the potential for unrepresentative favorability maps, recent works by U.S. Geological Survey researchers have used Monte Carlo cross-validation to implement a large number ( n) of randomized train-test splits to produce n realizations. The realizations are then aggregated using cell-wise median predictions to produce the resulting final favorability map, recognizing that the median will remove extreme values that might have been estimated from a comparatively few unrepresentative realizations. Theoretically, the median prediction at every cell converges to a single estimate as n approaches infinity, and the question addressed herein is: How many realizations are necessary to get a robust estimate (that is, an estimate unaffected by additional realizations)? Therefore, convergence metrics are described to identify the number of train-test splits and realizations needed to make a reliable map using the data and supervised machine learning workflow for conventional hydrothermal resource assessment of the Great Basin of the Western United States. For this study, robust prediction occurs with n approximately equal to 600 realizations, and smaller ensembles (for example, n is approximately equal to 200 or even 100) may be suitable during preliminary or exploratory analyses. Although the resulting threshold numbers will vary depending on the data and modeling approach used, the convergence metrics proposed and applied herein are applicable to other supervised machine learning studies that use Monte Carlo cross-validation.

Scientific Investigations Report↗

Groundwater budget for the Portneuf River Basin, southeastern Idaho

The U.S. Geological Survey, in cooperation with the Idaho Department of Water Resources, developed the first groundwater budget for the upper Portneuf River Basin in southeastern Idaho, a tributary of the Snake River. A groundwater budget for the Portneuf River Basin supports water resource and administrative management decisions within the basin and for downstream users of the eastern Snake River Plain aquifer. The analysis quantifies inflows, outflows, and residuals for an aquifer system defined by the Idaho Department of Water Resources under three recent precipitation conditions: an average year (2016), a dry year (2021), and a wet year (2023). The budget was calculated for the basin and for two subbasins delineated by the U.S. Geological Survey streamgage Portneuf River at Topaz, Idaho (13073000): the above Topaz subbasin, which includes the Portneuf-Gem valley, and the below Topaz subbasin, which includes Marsh Valley. Aquifer inflows include mountain-front recharge; areal recharge; recharge from applied water, including recharge from irrigation, canal seepage, and effluent returns; groundwater flow into the basin; and reservoir seepage. Outflows include groundwater pumping for agricultural, municipal, and domestic uses; subsurface outflow through the Portneuf gap; and discharge to streams as base flow. Estimated annual inflows for the full basin ranged from 116,880 acre-feet in 2021 to 154,880 acre-feet in 2023, and outflows ranged from 132,190 acre-feet in 2016 to 158,490 acre-feet in 2023. Basinwide residuals, the change in storage plus uncertainty, were −2,410 acre-feet in 2016, −18,410 acre-feet in 2021, and −3,610 acre-feet in 2023, and each subbasin had a mixture of negative and positive residuals. These basinwide results, interpreted as change in storage plus water-budget uncertainty, indicate minor net losses that increase with dry conditions, consistent with well depth-to-water measurements indicating gradual multi-decadal declines. Patterns in subbasin residuals are driven by irrigation practices and surface-water management; for example, the above Topaz subbasin relies more on groundwater for irrigation, resulting in more negative residuals during dry years. In contrast, the below Topaz subbasin depends more on surface water, producing positive residuals during dry years because of irrigation losses and canal seepage. The analyses for both subbasins indicate decades-long groundwater declines, which agree with the overall negative residuals calculated. The largest sources of uncertainty include climate inputs (precipitation and evapotranspiration) and poorly constrained components such as groundwater inflow and tributary stream infiltration. These findings provide insight into how climatic variables and irrigation practices affect groundwater inflows and outflows within the Portneuf River Basin.

Idaho↗

World minerals outlook—Antimony, copper, graphite, niobium, potash, silicon, silver, and tungsten through 2030

Demand for mineral commodities continues to increase owing to rapid technological advancements and global economic growth. To support this increase in demand, information about current and near-term supplies of these mineral commodities is essential. Such data help evaluate the health and stability of global supply chains and protect against potential supply risks. Current production and production capacity data coupled with information regarding near-term expected changes (such as facility closures, planned expansions, or the completion of new mineral production projects) can provide insight into expected future market developments and expected available supply of mineral commodities. This report within the “World Minerals Outlook” series analyzes data for antimony, copper, natural graphite, niobium, potash, silicon metal, silver, and tungsten—eight mineral commodities listed in the 2025 List of Critical Minerals. World production data from 2019 through 2025, as well as estimated world capacity data from 2023 through 2025 were analyzed. Using these data, near-term (2026–2030) expected world capacities were estimated. For antimony, copper, niobium, silicon metal, silver, and tungsten, modest increases in production capacity of 4 to 10 percent were expected between 2025 and 2030, whereas capacities for natural graphite and potash were expected to increase by about 18 to 20 percent.

Scientific Investigations Report↗