Small-volume tephra deposits of the May 1924 explosions from Halemaʻumaʻu, Kīlauea volcano, and their origin

Abstract

More than 50 explosive eruptions occurred from Halemaʻumaʻu at Kīlauea volcano over 17 days from May 11 to 27, 1924. Ballistics weighing as much as 14,000 kg were ejected and most landed within 2 km of the vent. Fine ash made up a major component of the tephra and was dispersed tens of kilometers downwind. Draining of the Halemaʻumaʻu lava lake occurred in late February 1924, with the crater floor eventually subsiding by a further ∼70 m (to ∼180 m below the crater rim) by the time the first explosions took place during the night of May 10–11. The largest explosions occurred on May 17–18 and smaller explosions continued until May 27, at which point Halemaʻumaʻu had more than doubled in width and depth. The explosions generated plumes reaching up to ∼10 km high with ballistics ejected up to 2 km from the crater. Almost 100 years later, we investigate and characterize the preserved tephra deposits within ∼3 km of the 1924 crater rim. Grain size and shape analyses were performed on 202 samples collected from 34 tephra profiles using dynamic image analysis, with a subset of layers from nine tephra profiles used for componentry (200 grains per layer in the 0.5–1 mm size fraction). Additionally, we characterize the average diameters (using the five largest clasts) at 216 locations and measure the average diameters of 2291 ballistics (largest per ∼100 m 2 area). Physical descriptions from fieldwork and grain size distributions were used to subdivide the tephra layers into five lithofacies: coarse homogeneous, fine homogenous, red ash, accretionary lapilli-bearing, and finely laminated. Grain size versus shape data show a range of values that demonstrate most grains are dense, smooth, and equant, in alignment with lithic clasts dominating the tephra componentry. The fine grained and accretionary lapilli-bearing nature of some of these lithofacies confirms that water influenced the style of the explosions. However, we also note juvenile clasts within many of the tephra layers, indicating that many of the layers were formed during phreatomagmatic explosions (sensu stricto), despite the eruptive mechanism being dominantly phreatic. Juvenile clasts are more abundant higher in the tephra profiles, suggesting that juvenile magma was more involved later in the explosive sequence. Thermal and hydrologic modeling indicate that groundwater inflow into a short-lived, small-diameter volcanic conduit (10-m to 120-m-diameter used for modeling) during the 78–85 days preceding the first explosion provides a physically plausible mechanism for this eruptive sequence.