An appraisal of ground water for irrigation in the Wadena area, central Minnesota

F.G. Lindholm

doi:10.3133/wsp1983

Home/Archive/USGS

USGS · wsp1983

An appraisal of ground water for irrigation in the Wadena area, central Minnesota

F.G. Lindholm

View original source ↗Read source document ↗Export metadata ↓

Abstract

The Wadena area is part of a large sandy plain in central Minnesota whose soils have low water-holding capacity. Drought conditions which adversely affect plant growth frequently occur in the summer when moisture is most needed. To reduce the risk of crop failure in the area supplemental irrigation is on the increase. This study was made to evaluate the ground-water resources of the area and to determine possible effects of development on them. About half the area's approximately 102,000 acres is considered irrigable at the present time. In 1967, about 1,100 acres were under irrigation. Outwash sand and gravel, which forms the water-table aquifer, is the main source of water presently known. Saturated thickness ranges from 0 to 70 feet and averages about 36 feet. Sandy till underlies the outwash. Within the till are sand and gravel lenses whose distribution and water-yielding characteristics were not determined. Average annual precipitation at the U.S. Weather Bureau station in Wadena from 1934 to 1967 was 26.4 inches, of which about 22.5 inches was lost by evapotranspiration, and the balance of 3.9 inches was surface runoff. Even in wet years, evapotranspiration during the .summer months exceeds precipitation, and a moisture deficiency for optimum plant growth occurs. In 1967, about 8 inches of the total precipitation of 19.3 inches reached the water table. Recharge to the water table in 1967 was about 70,000 acre-feet. Result of field aquifer (pumping) tests were used to estimate transmissivity values at test-hole sites. Information gained by auger test drilling was the basis for estimating transmissivity values elsewhere. Transmissivity of the watertable aquifer in most of the Wadena area ranges from 15,000 to 120,000 gallons per day per foot. A map was prepared to show the maximum yield, in gallons per minute, which might be obtained from individual wells completed in the water-table aquifer. The map indicates that in about 60 percent of the area, individual wells can be pumped at rates greater than 300 gallons per minute for a 30-day period if drawdown in the pumped well is two-thirds the saturated thickness after correction for dewatering. Quality of both ground and surface waters is such that they are well suited for irrigation. Locally, nitrate concentrations in ground water, in excess of the U.S. Public Health Service's drinking water standards, might be related to a local source of organic pollution or to the increased use of fertilizers which accompanies irrigation. An electric analog model of the water-table aquifer in the Wadena area was built and used to analyze possible effects of ground-water development of the hydrologic system. The model was designed to .simulate existing hydrologic conditions and used to predict changes in the system which might result from development. The withdrawal of large quantities of ground water would lower the water table, thereby reducing evapotranspiration losses and making more water available for beneficial use. Additional water would be salvaged when normal ground-water discharge to streams is intercepted by pumping from wells. Analyses were made to determine effects of development on ground-water levels under different development schemes both after a single irrigation season and after 5 and 20 successive years of irrigation. Where development is concentrated, some interference between wells can be expected. Although water levels recover rapidly when pumps are shut off, recovery will not be complete prior to the next irrigation season in heavily developed areas. After several years of watertable lowering, yields from wells will decrease because of deceased saturated thickness, unless climatic changes result in abnormally high amounts of recharge.

Explore related subjects

Water Supply Paper Report

Source-reported bounding extent: 46.316667° to 46.541667° latitude; -95.25° to -94.75° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

F.G. Lindholm. 1970. An appraisal of ground water for irrigation in the Wadena area, central Minnesota. https://doi.org/10.3133/wsp1983

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2004

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper↗

USGS2002

Use of stable isotopes of carbon, nitrogen, and sulfur to identify sources of nitrogen in surface waters in the Lower Susquehanna River Basin, Pennsylvania

Samples of nitrogen-source material, soil, and water were collected from several small, primarily single-source subbasins in the Lower Susquehanna River Basin during 1988–90 to determine the feasibility of using measurements of stable isotope ratios of carbon ( 13 C), nitrogen ( 15 N), and sulfur ( 34 S) to identify sources of nitrogen (N) in stream water. Chemical and isotopic compositions were measured for six N-source types consisting of rain water, forest leaf litter, synthetic fertilizer, farm-animal manure, municipal-sewage effluent and sludge, and septictank effluent and sludge. Compositions of associated, nearby samples of topsoil, subsoil, runoff water, and stream water were measured to evaluate changes in compositions of transported N-containing materials near the N source. Animal manure, human waste (sewage plus septic), and forest-leaf litter can be distinguished on the basis of 13 C; however, most N-sources cannot be distinguished on the basis of 15 N and 34 S, owing to wide ranges and overlap of compositions among different N-source types. Although values of 15 N for soil and runoff-water samples are qualitatively similar to those of the applied N source, values of 13 C and 34 S for runoff-water and stream-water samples appear to reflect the compositions of relatively large reservoirs of the elements in soil organic matter and minerals, respectively, and not the composition of the applied N source. The ratio of organic carbon to total nitrogen (C-org:N), combined with 13 C, is useful for distinguishing agricultural soils, which have characteristically high 13 C and low C-org:N, from forested soils. The C-org:N values of suspended particulates in runoff or stream waters generally are lower than those of nearby soils, however, and indicate that chemical transformations and resultant isotopic fractionation can be important controls on the compositions of N-containing compounds in the soil and water. In aqueous samples including surface water and liquid N-sources, isotopic ratios commonly differ between coexisting dissolved fractions of NO 3- N and NH 3- N and between dissolved and particulate fractions of N or S, probably because of isotopic fractionation during transport or N-source processing. Isotopic measurements provide qualitative information about important reactions that can affect N concentrations in surface waters. However, mass-balance computations generally are not sufficiently accurate to estimate the proportions of multiple sources contributing to the N load in the streams studied because of (1) variations in source chemical and isotopic compositions and (2) nonconservative behavior and fractionation during transport over short distances (hundreds of meters). Uncertainties in mass-balance computations are complicated by the propagation of errors associated with measurements of discharge, chemical concentrations,and isotopic compositions of relatively dilute, small streams.

Pennsylvania↗

USGS2001

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper↗