Search USGS⌕ Search

USGS · ofr20171116

Morphologic evolution of the wilderness area breach at Fire Island, New York—2012–15

Abstract

Introduction Hurricane Sandy, which made landfall on October 29, 2012, near Atlantic City, New Jersey, had a significant impact on the coastal system along the south shore of Long Island, New York. A record significant wave height of 9.6 meters (m) was measured at wave buoy 44025 , approximately 48 kilometers offshore of Fire Island, New York. Surge and runup during the storm resulted in extensive beach and dune erosion and breaching of the Fire Island barrier island system at two locations, including a breach that formed within the Otis Pike Fire Island High Dune Wilderness area on the eastern side of Fire Island. The U.S. Geological Survey (USGS) has a long history of conducting morphologic change and processes research at Fire Island. One of the primary objectives of the current research effort is to understand the morphologic evolution of the barrier system on a variety of time scales (from storm scale to decade(s) to century). A number of studies that support the project objectives have been published. Prior to Hurricane Sandy, however, little information was available on specific storm-driven change in this region. The USGS received Hurricane Sandy supplemental funding (project GS2–2B: Linking Coastal Processes and Vulnerability, Fire Island, New York, Regional Study) to enhance existing research efforts at Fire Island. The existing research was greatly expanded to include inner continental shelf mapping and investigations of processes of inner shelf sediment transport; beach and dune response and recovery; and observation, analysis, and modeling of the newly formed breach in the Otis Pike High Dune Wilderness area, herein referred to as the wilderness breach. The breach formed at the site of Old Inlet, which was open from 1763 to 1825. The location of the initial island breaching does not directly correspond with topographic lows of the dunes, but instead the breach formed in the location of a cross-island boardwalk that was destroyed during Hurricane Sandy. From 2013 to November 2015, bathymetric data were collected by the USGS St. Petersburg Coastal and Marine Science Center during three surveys of the breach channel and tidal shoals, and shoreline positions on each side of the breach (also collected by the National Park Service). Additionally, pre-storm topography/bathymetry EAARL–B light detection and ranging (lidar) data were collected by the USGS the day prior to Hurricane Sandy’s landfall. These data serve as a baseline for change analyses during four subsequent periods: June 2013, June 2014, October 2014, and May 2015. The June 2013 single-beam bathymetry data were collected in collaboration with the U.S. Army Corps of Engineers (USACE), using the Lighter Amphibious Resupply Cargo (LARC) vessel, and included the ebb shoal and breach channel. The USGS collected and processed the three additional bathymetric datasets using personal watercraft equipped with single-beam echo sounders and backpack Global Positioning System (GPS) over shallow flood shoals. Eastern and western breach shorelines were surveyed weekly to monthly beginning on November 6, 2012 (by the National Park Service [NPS], and USGS St. Petersburg Coastal and Marine Science Center), with measurements made every few weeks for the first year and every few months after October 2013. The NPS and researchers from Stony Brook University monitored the breach by collecting field data of the breach channel bathymetry, conducting aerial photographic overflights, and performing water-quality analyses (see http://po.msrc.sunysb.edu/GSB/ ). The aerial photography collected and rectified by Stony Brook University is used extensively in our morphologic change description to examine changes to breach shorelines (supplementing shoreline data collected in the field), channel width, and orientation. Due to the uncertainties and the variation in survey methods, a rigorous quantitative analysis was not performed. However, average calculations of various breach metrics allow a qualitative analysis of breach development and evolution. This report presents an overview of the data collected and a summary discussion of the observed changes to the breach system and the seasonal wave climatology associated with the breach morphodynamic response.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 40.6113461833302° to 40.73581157695217° latitude; -73.32000732421875° to -72.87574768066406° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Cheryl J. Hapke, Timothy R. Nelson, Rachel E. Henderson, Owen T. Brenner, Jennifer L. Miselis. 2017-09-18. Morphologic evolution of the wilderness area breach at Fire Island, New York—2012–15. https://doi.org/10.3133/ofr20171116

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

ECCOE Landsat quarterly calibration and validation report—Quarter 2, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 2 (April–June), 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov.

Open-File Report↗

ECCOE Landsat quarterly calibration and validation report—Quarter 1, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 1 (January–March) of 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov . One specific activity that the ECCOE Landsat Cal/Val Team closely monitored was a Landsat 8 Thermal Infrared Sensor encoder alerts anomaly. On March 18, 2026, the Thermal Infrared Sensor instrument’s mechanism control electronics board reset, driving several parameters to default power-on values. Subsequent telemetry and analysis determined that no persistent hardware misconfiguration was present and no radiometric or geometric degradation was observed.

Open-File Report↗

Floods of June 20–July 6, 2024, in the Big Sioux River, Rock River, Little Sioux River, Ocheyedan River, and Floyd River Basins, northwestern Iowa

Major flooding occurred on June 20–July 6, 2024, in northwestern Iowa affecting the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd River Basins. Heavy rain fell in northwestern Iowa, southwestern Minnesota, and southeastern South Dakota on June 20–22, 2024. Parts of northwestern Iowa recorded 2–6 inches of rainfall and localized amounts exceeding 12 inches. A maximum peak-of-record streamflow of 175,000 cubic feet per second at the U.S. Geological Survey streamgage Big Sioux River at Akron, Iowa (06485500), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at four locations along the Big Sioux River between U.S. Interstate 29 at Sioux City, Iowa, upstream to Iowa Highway 10 north of Hawarden, Iowa, a distance of 75.7 river miles. A maximum peak-of-record streamflow of 157,000 cubic feet per second at the U.S. Geological Survey streamgage Rock River near Rock Valley, Iowa (06483500), was recorded on June 22, 2024, and had an annual exceedance probability of less than 0.2 percent. High-water marks were measured at eight locations along the Rock River between County Road B30 east of Hudson, South Dakota, upstream to Iowa Highway 9 at Rock Rapids, Iowa, a distance of 39.3 river miles. A maximum peak-of-record streamflow of 63,000 cubic feet per second at the U.S. Geological Survey streamgage Little Sioux River at Correctionville, Iowa (06606600), was recorded on June 24, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at 11 locations along the Little Sioux River between Iowa Highway 31 west of Correctionville, Iowa, upstream to U.S. Highway 18 north of Spencer, Iowa, a distance of 134.8 river miles. A maximum streamflow of 24,500 cubic feet per second at the U.S. Geological Survey streamgage Ocheyedan River near Spencer, Iowa (06605000), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at three locations along the Ocheyedan River between County Road M38 west of Spencer, Iowa, upstream to U.S. Highway 18 west of Everly, Iowa, a distance of 12.8 river miles. A maximum streamflow of 41,000 cubic feet per second at the U.S. Geological Survey streamgage Floyd River at Alton, Iowa (06600100), was recorded on June 22, 2024, and had an annual exceedance probability range of 1–1.99 percent. High-water marks were measured at six locations along the Floyd River between Iowa Highway 3 at Le Mars, Iowa, upstream to Iowa Highway 10 at Alton, Iowa, a distance of 27.5 river miles. The high-water marks were used to develop flood profiles for the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd Rivers.

Iowa, Minnesota, South Dakota↗