Search USGSSearch

USGS · 70170953

Geochemistry and ground-water movement in northwestern Minnesota

Abstract

The relation between water quality and water movement within the ground-water reservoir may be better understood if studies of flow systems are used in conjunction with hydrochemical methods. Within small watersheds, local, intermediate, and regional flow systems may develop, depending upon the shape, the relief, and the thickness of the ground-water reservoir. Lateral and vertical variations of water quality in the ground-water reservoir reflect the difference in length of flow paths within a system. The relative ion concentration of the major ions in solution in ground waters change as water moves from recharge areas to discharge areas. These changes are used to interpret the direction and rate of ground-water movement. Ground-water types mapped in the Two Rivers watershed of northwestern Minnesota indicate that calcium bicarbonate type water occurs near the source of recharge and progressively changes to the sulfate type as water moves downgradient toward the discharge area. Local recharge areas are indicated by the greater penetration of calcium bicarbonate waters into the ground-water reservoir. The calcrum bicarbonate type water of surface streams during low flow indicates that water moves into the stream from the upper part of the ground-water reservoir. Chloride type water moves from the Paleozoic rocks and mixes with water in the glacial drift probably at places where permeable zones in the Paleozoic rocks are in contact with the overlying drift.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R.W. Maclay, T. C. Winter. 2006-07-06. Geochemistry and ground-water movement in northwestern Minnesota. https://doi.org/10.1111/j.1745-6584.1967.tb01233.x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Computing flow-field distortion coefficients from well-construction and formation properties

Direct measurements of groundwater velocity made with borehole flowmeters in screened wells must be compensated for the effects of flow-field distortion (also known as borehole acceleration). A theoretical equation developed by Drost et al. (1968) and simple inputs describing hydraulic properties of well construction and geologic formation were programmed into an Excel workbook to facilitate computation by groundwater-flowmeter users. Tables describing the physical and hydraulic properties for well constructions and gravel pack media are provided with an example to facilitate use of the workbook. Groundwater flowlines converge or diverge as they pass from a geologic formation, through a gravel pack and well screen. The extent of flowline convergence or divergence and the value of the flow-field distortion coefficient is related to the relative changes in hydraulic conductivity of the well screen, gravel pack, and geologic formation. Convergence or divergence is accompanied by acceleration or deceleration of groundwater. Direct measurements of groundwater velocity at the center of the monitoring well can be adjusted to provide a more accurate estimate of velocity in the formation by applying a correction for flow-field distortion. Variables required to compute the flow-field distortion coefficient include the hydraulic conductivity of the gravel pack, well screen, and the geologic formation surrounding the well screen; the borehole radius, and the inside radius and outside radius of the well screen.

Groundwater

Deep groundwater total dissolved solids mapping in the Dakota Group, Williston Basin, USA

Growing concern about the quantity of available freshwater around the world has led to interest in surveying groundwater total dissolved solids (TDS) below water well depths. Deep TDS has not been systematically mapped, and there is much to learn about the distribution and controls on deeper groundwater. In sedimentary basins across the United States, groundwater resources often overlie hydrocarbon resources, providing an opportunity to use borehole geophysical data collected for hydrocarbons to characterize groundwater and pore space resources. This study adapts a recently developed subsurface geostatistical and geophysical modeling approach to continuously map groundwater TDS, porosity, and temperature in the Dakota Group of the Williston Basin—an undercharacterized regional aquifer system overlying deeper hydrocarbon reservoirs. Groundwater TDS in the Dakota Group ranges from approximately 4800 to 26,900 mg/L. TDS patterns are stratified with higher TDS in the lower and upper Dakota Group, and relatively lower TDS in the middle Dakota Group. The lower TDS in the middle zone may represent a preferential regional flow path for lower-TDS meteoric recharge from the west. The alternating pattern of TDS may also be evidence of higher-TDS inflows into the Dakota Group from underlying and potentially from overlying aquifers. Porosity is lower near the center of the Williston Basin and tends to be higher to the east, which may be related to grain size distributions. The new regional TDS and porosity modeling serves as a quantitative reference for water users and provides supporting evidence for hypotheses on Dakota Group recharge.

Montana, North Dakota, South Dakota