Search USGS⌕ Search

USGS · 70020115

Rupture characteristics of the three M ∼ 4.7 (1992-1994) Parkfield earthquakes

Abstract

Slip on the San Andreas fault was determined for three M ∼ 4.7 earthquakes using a tomographic inverse system [ Beroza and Spudich , 1988] to invert seismic source time functions (STFs) from S waves. STFs were obtained by deconvolving mainshock accelerograms by those from collocated smaller earthquakes. Accelerograms were from the U.S. Geological Survey Parkfield Small Aperture Array (UPSAR) and from a distributed array of digital accelerometer stations at Parkfield. Eight or nine STFs are used in each of the three inversions. STFs are typically symmetrical pulses with a duration of about 0.3–0.5 s. In the inversion, mainshock rise time was set to 0.05 s, and we allowed the rupture time to vary slightly from a constant rupture velocity of approximately 0.85β. Rupture for all three events, which are located in or close to the Middle Mountain preparation zone or box (MMB), quickly reaches a local maximum in slip and then propagates outward to peaks, ridges, or plateaus in the slip distribution. Slip for the October 20, 1992, event (located just inside the southern edge of the MMB) propagates from an initial spike north and updip along a curving ridge for about 2 km. The initial spike continued to grow in the November 14, 1993, event (located north of the October 20, 1992, event just beneath the hypocenter of the 1966 Parkfield earthquake), which shows little directivity, although there is a smaller patch of slip updip and to the south. In contrast, rupture for the December 20, 1994, event (located just south of the October 20, 1992, event) propagated north and slightly updip, creating a rough plateau in slip a few kilometers wide on a side. Directivity for this event also is to the north. Directivity for all three events points in the approximate direction of the 1966 hypocenter. Small pulses, which comprise a coda, are found on the STFs for several seconds after the initial impulsive event. Several tests based on the assumption that the average of all STFs from UPSAR for each event is an estimate of the true slip at the source suggest that the codas in the STFs are S waves from a long-duration source rather than uncorrected site response. An initiation phase is found on the array average for the November 14, 1993, and December 20, 1994, events. These precursory phases are the result of a spike in slip at the hypocenter. A value of 2.4–4 mm is obtained for D c , the slip-weakening distance, by interpreting the initial spike as a critical patch. The few aftershocks for the October 20, 1992, event are distributed to the north and updip of the mainshock, but the November 14, 1993, event had a strong burst of aftershock activity that propagated to the north of its hypocenter at roughly the same depth. Aftershocks of the December 20, 1994, event are mostly updip. The November 14, 1993, event had the simplest slip distribution, appeared to be the most impulsive, and had the most active aftershock sequence and the greatest depth. If the eventual Parkfield earthquake initiates near the 1966 hypocenter, then the directivity of the three events studied here will have pointed to it. However, it is certainly possible that both the initiation of characteristic Parkfield shocks and the directivity of smaller events are controlled by fault properties on a larger scale such as by fault bends or jogs.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Jon Peter B. Fletcher, Paul A. Spudich. 1998-01-10. Rupture characteristics of the three M ∼ 4.7 (1992-1994) Parkfield earthquakes. https://doi.org/10.1029/97jb01797

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

High-resolution InSAR reveals localized pre-eruptive deformation inside the crater of Agung Volcano, Indonesia

During a volcanic crisis, high-rate, localized deformation can indicate magma close to the surface, with important implications for eruption forecasting. However, only a few such examples have been reported, because frequent, dense monitoring is needed. High-resolution Synthetic Aperture Radar (SAR) is capable of achieving <1 m spatial resolution and sub-weekly revisit times, but is under-used. Here we use high-resolution satellite SAR imagery from COSMO-SkyMed, TerraSAR-X, and Sentinel-1 to detect intra-crater uplift preceding the November 2017 onset of eruptive activity at Agung, Indonesia. Processing the SAR imagery with an up-to-date, accurate, high-resolution digital elevation model was crucial for preventing aliasing of the deformation signal and for accurate georeferencing. We show that >15 cm of line-of-sight shortening occurred over a 400-by-400 m area on the crater floor in September-October 2017, accompanying a deep seismic swarm and flank dyke intrusion. We attribute the deformation to the pressurization of a shallow (<200 m deep) hydrothermal system by the injection of magmatic gases and fluids. We also observe a second pulse of intra-crater deformation of 3–5 cm within 4 days to 11 hr prior to the first phreatomagmatic eruption, which is consistent with interaction between the hydrothermal system and the ascending magma. This phreatomagmatic eruption created the central pathway used during the final stages of magma ascent. Our observations have important implications for understanding unrest and eruption forecasting, and demonstrate the potential of monitoring with high-resolution SAR.

Agung Volcano, Bali↗

Identification of seismo-volcanic regimes at Whakaari/White Island (New Zealand) via systematic tuning of an unsupervised classifier

We present an algorithm based on Self-Organizing Maps (SOM) and k-means clustering to recognize patterns in a continuous 12.5-year tremor time series recorded at Whakaari/White Island volcano, New Zealand (hereafter referred to as Whakaari). The approach is extendable to a variety of volcanic settings through systematic tuning of the classifier. Hyperparameters are evaluated by statistical means, yielding a combination of “ideal” SOM parameters for the given data set. Extending from this, we applied a Kernel Density Estimation approach to automatically detect changes within the observed seismicity. We categorize the Whakaari seismic time series into regimes representing distinct volcano-seismic states during recent unrest episodes at Whakaari (2012/2013, 2016, and 2019). There is a clear separation in classification results between background regimes and those representing elevated levels of unrest. Onset of unrest is detected by the classifier 6 weeks before the August 2012 eruption, and ca. 3.5 months before the December 2019 eruption, respectively. Regime changes are corroborated by changes in commonly monitored tremor proxies as well as with reported volcanic activity. The regimes are hypothesized to represent diverse mechanisms including: system pressurization and depressurization, degassing, and elevated surface activity. Labeling these regimes improves visualization of the 2012/2013 and 2019 unrest and eruptive episodes. The pre-eruptive 2016 unrest showed a contrasting shape and nature of seismic regimes, suggesting differing onset and driving processes. The 2016 episode is proposed to result from rapid destabilization of the shallow hydrothermal system, while rising magmatic gases from new injections of magma better explain the 2012/2013 and 2019 episodes.

Whakaari, White Island↗

Microgravity change during the 2008-2018 Kı̄lauea summit eruption: Nearly a decade of subsurface mass accumulation

Results from nine microgravity campaigns from Kı̄lauea, Hawaiʻi, spanning most of the volcano's 2008–2018 summit eruption, indicate persistent mass accumulation at shallow levels. A weighted least squares approach is used to recover microgravity results from a network of benchmarks around Kı̄lauea's summit, eliminate instrumental drift, and restore suspected data tares. A total mass of 1.9 × 10 11 kg was determined from these microgravity campaigns to have accumulated below Kı̄lauea Caldera during 2009–2015 at an estimated depth of 1.3 km below sea level. Only a fraction of this mass is reflected in surface deformation, and this is consistent with previously reported discrepancies between subsurface mass accumulation and observed surface deformation. The discrepancy, amongst other independent evidence from gas emissions, seismicity, and continuous gravimetry, indicate densification of magma in the reservoirs below the volcano summit. This densification may have been driven by degassing through the summit vent. It is hypothesized that during the final years of the summit eruption, magma densification resulted in a buildup of pressure in the reservoirs that may have contributed to the lower East Rift Zone outbreak of 2018. The observed mass accumulation beneath Kı̄lauea could not have been detected through other techniques and illustrates the importance of microgravity measurements in volcano monitoring.

Hawai'i↗