Search USGS⌕ Search

Geology topics

A. H. Sallenger

Publications and source records attributed to A. H. Sallenger.

67 records · Page 4Linked to original sources
USGS1989

Nearshore bars and the break-point hypothesis

The set of hypotheses calling for bar formation at the break point was tested with field data. During two different experiments, waves were measured across the surf zone coincident with the development of a nearshore bar. We use a criterion, based on the wave height to depth ratio, to determine the offshore limit of the inner surf zone. During the first experiment, the bar became better developed and migrated offshore while remaining well within the inner surf zone. During the second experiment, the surf zone was narrower and we cannot rule out the possibility of break point processes contributing to bar development. We conclude that bars are not necessarily coupled with the break point and can become better developed and migrate offshore while being in the inner surf zone landward from initial wave breaking in the outer surf zone.

Coastal Engineering↗
USGS1987

Map showing locations and statistical parameters of beach and offshore sand samples, Tutuila Island, American Samoa

In April 1985, sand samples were collected from many of the beaches on Tutuila Island, American Samoa, and in July 1985, three bays were surveyed using side-scan sonar and shallow seismic profiling. During that second trip, scuba divers collected sand samples from the surveyed areas. Dingler and others (1986) describes the study; this report presents the grain-size and composition data for the onshore and offshore sand samples. Locations of the onshore samples are plotted on the map of the island, which is reproduced from Normark and others (1985); locations of most of the offshore samples and side-scan sonar interpretations made during the study are plotted on enlargements (A and B, respectively) of Fagaitua and Nua-seetaga Bays. Lam Yuen (1981), U.S. Army Corps of Engineers (1980), and Sea Engineering Services Inc. (1980) provide additional information pertaining to the island's beaches.

Tutuila Island↗
USGS1979

Beach-cusp formation

Field experiments on beach-cusp formation were undertaken to document how the cuspate form develops and to test the edge-wave hypothesis on the uniform spacing of cusps. These involved observations of cusps forming from an initially plane foreshore. The cuspate form was observed to be a product of swash modification of an intertidal beach ridge as follows. A ridge, cut by a series of channels quasi-equally spaced along its length, was deposited onto the lower foreshore. The ridge migrated shoreward with flood tide, while the longshore positions of the channels remained fixed. On ebb tide, changes in swash circulation over the ridge allowed the upwash to flow shoreward through the channels and the channel mouths were eroded progressively wider until adjacent mouths met, effecting a cuspate shape. Measured spacings of cusps, ranging in size from less than 1 m to more than 12 m, agree well with computed spacings due to either zero-mode subharmonic or zero-mode synchronous edge waves. Edge-wave-induced longshore variations in run up will cause water ponded behind a ridge to converge at points of low swash and flow seaward as relatively narrow currents eroding channels spaced at one edge-wave wavelength for synchronous edge waves or one half wavelength for subharmonic edge waves. The channels are subsequently modified into cusp troughs as described above.

Marine Geology↗
USGS1979

Inverse grading and hydraulic equivalence in grain-flow deposits

Inversely graded grain-flow deposits are characterized by a hydraulic equivalence that differs from that based on settling velocities or entrainment. Dispersive equivalence, derived from the dispersive pressure hypothesis on how inverse grading develops, was found to agree reasonably well with observed relationships between grain sizes and densities in grain-flow deposits. Furthermore, observed relationships in deposits formed in subaerial and subaqueous environments were found to be independent of fluid density as is required by dispersive equivalence. The results suggest that dispersive pressure controls the development of the inverse grading common to beach foreshore laminations, slip-face foreset strata, the basal parts of some coarse-grained turbidites, and other diverse deposits.

Journal of Sedimentary Petrology↗
USGS1977

Beach cusps

Explore the source record for details and available documents.

North Carolina;Virginia↗