USGS1979
The East Tintic Mountains, Utah consist of folded and faulted Paleozoic sedimentary rocks, which are partly covered by Tertiary volcanic rocks. Clastic rocks dominate the lower one-third of the Paleozoic section, whereas carbonate rocks with subordinate amounts of shale and elastic rocks predominate in the remainder. Some of the rocks, especially the Tintic Quartzite and some shales, are commonly limonitic, an important factor in analysis of Landsat MSS images. The volcanic rocks, mainly tuffs, flows, and agglomerates of quartz latitic and latitic composition, are limonitic in a few places where hematite is present in the groundmass. Emplacement of monzonite and biotite monzonite porphyry bodies resulted in several types of altered rocks. Most widespread are argillized and silicified rocks, which are commonly bleached and limonitic. Locally, the intrusive rocks arc also altered. Hydrothermal dolomite is common in the northern part of the area, and in the East Tintic mining district, calcitic, chloritic, and weakly argillized volcanic rocks and pebble dikes are widespread. Volcanic rocks subjected to an early phase of "intravolcanic weathering" in this district are weakly altered but commonly limonitic. Barren as well as mineralized veins are present throughout the study area. In situ spectral reflectance curves representing the most abundant altered and unaltered rocks show that the argillized and silicified rocks generally have intense ferric-iron and hydroxyl absorption bands owing to the presence of iron-oxide and hydroxyl-bearing phases, respectively. These features are generally absent in the unaltered rocks, except the limonitic rocks, which have prominent iron absorption hands. Both spectral features are weakly expressed in the volcanic rocks subjected to accelerated weathering, On the other hand, hydrothermal dolomite and calcitic volcanic rocks generally lack both features, and thus are spectrally similar to the unaltered rocks. Chloritic rocks are of limited distribution and have not been measured spectrally. Most of the silicified and argillized areas are apparent in Skylab S190B, high altitude-, and low altitude color aerial photographs because of the high albedo of these rocks. However, many unaltered rocks have similar albedos and therefore are not distinguishable from the altered rocks. Moreover, very little color information is available in these photographs. These problems are further complicated by brightness variations related to topographic slope. MSS ratio images were generated to subdue the effects of topographic slope and albedo, and combined into several color composite images for displaying the spectral reflectance differences between the most widespread altered and unaltered rocks. The most effective combination proved to be MSS 4/5, MSS 4/6, and MSS 6/7 using blue, yellow and magenta diazo films, respectively, rather than the MSS 4/5, MSS 5/6, and MSS 6/7 combination used so successfully in south-central Nevada. Consideration of schematic frequency distributions of ratio values for these two areas suggests that the lack of enhancement of limonitic rocks in MSS 5/6 images of the present study area is due to the higher frequency of low ratios representing vegetation. Comparison of a limonitic bedrock map produced by scanning the optimum color-ratio composite image with a map of the silicified rocks shows good agreement, except where they are obscured by vegetation. Measurements of vegetation density indicate that shrub cover and. juniper, pinyon, and sage cover greater than 40-50 and 33-43 percent, respectively, obscure limonitic rocks in these images. Argillized rocks, the most widely distributed altered rock type, were consistently detected in exposed areas. On the other hand, hydrothermal dolomite and calcitic and chloritic volcanic rocks are not portrayed in the limonitic bedrock map because of their general lack of limonite. Some altered rocks, especially veins and pebble dikes, are too small to be detected by the MSS except where they are closely spaced and well exposed. Another important limitation is that exposures of unaltered limonitic sedimentary and volcanic rocks are included in the limonitic bedrock map. Analysis of in situ spectral reflectance measurements indicates that this limitation can be largely overcome by obtaining radiance information in the 2.2 and 1.6 μ m regions.