Determination of discharge during pulsating flow

T. H. Thompson

doi:10.3133/wsp1869d

Home/Archive/USGS

USGS · wsp1869D

Determination of discharge during pulsating flow

T. H. Thompson

View original source ↗Read source document ↗Export metadata ↓

Abstract

Pulsating flow in an open channel is a manifestation of unstable-flow conditions in which a series of translatory waves of perceptible magnitude develops and moves rapidly downstream. Pulsating flow is a matter of concern in the design and operation of steep-gradient channels. If it should occur at high stages in a channel designed for stable flow, the capacity of the channel may be inadequate at a discharge that is much smaller than that for which the channel was designed. If the overriding translatory wave carries an appreciable part of the total flow, conventional stream-gaging procedures cannot be used to determine the discharge; neither the conventional instrumentation nor conventional methodology is adequate. A method of determining the discharge during pulsating flow was tested in the Santa Anita Wash flood control channel in Arcadia, Calif., April 16, 1965. Observations of the dimensions and velocities of translatory waves were made during a period of controlled reservoir releases of about 100, 200, and 300 cfs (cubic feet per second). The method of computing discharge was based on (1) computation of the discharge in the overriding waves and (2) computation of the discharge in the shallow-depth, or overrun, part of the flow. Satisfactory results were obtained by this method. However, the procedure used-separating the flow into two components and then treating the shallow-depth component as though it were steady--has no theoretical basis. It is simply an expedient for use until laboratory investigation can provide a satisfactory analytical solution to the problem of computing discharge during pulsating flow. Sixteen months prior to the test in Santa Anita Wash, a robot camera had been designed .and programmed to obtain the data needed to compute discharge by the method described above. The photographic equipment had been installed in Haines Creek flood control channel in Los Angeles, Calif., but it had not been completely tested because of the infrequency of flow in that channel. Because the Santa Anita Wash tests afforded excellent data for analysis, further development of the photographic ,technique at Haines Creek was discontinued. Three methods for obtaining the data needed to compute discharge during pulsating flow are proposed. In two of the methods--the photographic method and the depth-recorder method--the dimensions and velocities of translatory waves are recorded, and discharge is then computed by the procedure developed in this report. The third method?the constant-rate-dye-dilution method--yields the discharge more directly. The discharge is computed from the dye-injection rate and the ratio of the concentration of dye in the injected solution to the concentration of dye in the water sampled at a site downstream. The three methods should be developed and tested in ,the Santa Anita Wash flood control channel under controlled conditions similar to those in the test of April 1965.

Explore related subjects

Water Supply Paper Report

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

T. H. Thompson. 1968. Determination of discharge during pulsating flow. https://doi.org/10.3133/wsp1869d

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2004

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper↗

USGS2002

Use of stable isotopes of carbon, nitrogen, and sulfur to identify sources of nitrogen in surface waters in the Lower Susquehanna River Basin, Pennsylvania

Samples of nitrogen-source material, soil, and water were collected from several small, primarily single-source subbasins in the Lower Susquehanna River Basin during 1988–90 to determine the feasibility of using measurements of stable isotope ratios of carbon ( 13 C), nitrogen ( 15 N), and sulfur ( 34 S) to identify sources of nitrogen (N) in stream water. Chemical and isotopic compositions were measured for six N-source types consisting of rain water, forest leaf litter, synthetic fertilizer, farm-animal manure, municipal-sewage effluent and sludge, and septictank effluent and sludge. Compositions of associated, nearby samples of topsoil, subsoil, runoff water, and stream water were measured to evaluate changes in compositions of transported N-containing materials near the N source. Animal manure, human waste (sewage plus septic), and forest-leaf litter can be distinguished on the basis of 13 C; however, most N-sources cannot be distinguished on the basis of 15 N and 34 S, owing to wide ranges and overlap of compositions among different N-source types. Although values of 15 N for soil and runoff-water samples are qualitatively similar to those of the applied N source, values of 13 C and 34 S for runoff-water and stream-water samples appear to reflect the compositions of relatively large reservoirs of the elements in soil organic matter and minerals, respectively, and not the composition of the applied N source. The ratio of organic carbon to total nitrogen (C-org:N), combined with 13 C, is useful for distinguishing agricultural soils, which have characteristically high 13 C and low C-org:N, from forested soils. The C-org:N values of suspended particulates in runoff or stream waters generally are lower than those of nearby soils, however, and indicate that chemical transformations and resultant isotopic fractionation can be important controls on the compositions of N-containing compounds in the soil and water. In aqueous samples including surface water and liquid N-sources, isotopic ratios commonly differ between coexisting dissolved fractions of NO 3- N and NH 3- N and between dissolved and particulate fractions of N or S, probably because of isotopic fractionation during transport or N-source processing. Isotopic measurements provide qualitative information about important reactions that can affect N concentrations in surface waters. However, mass-balance computations generally are not sufficiently accurate to estimate the proportions of multiple sources contributing to the N load in the streams studied because of (1) variations in source chemical and isotopic compositions and (2) nonconservative behavior and fractionation during transport over short distances (hundreds of meters). Uncertainties in mass-balance computations are complicated by the propagation of errors associated with measurements of discharge, chemical concentrations,and isotopic compositions of relatively dilute, small streams.

Pennsylvania↗

USGS2001

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper↗