Search USGS⌕ Search

USGS · wsp1663F

Ground-water resources of the Lambayeque Valley, Department of Lambayeque, northern Peru

Abstract

Ground water in the Lambayeque Valley has been developed mainly for irrigation of sugarcane and rice. The locality is on the coastal plain of northern Peru, about 650 km (kilometers) northwest of Lima, the national capital. The area considered in this study is about 1,670 sq km (square kilometers) and is mainly on the alluvial fan of Rio Chancay and entirely in the Department of Lambayeque. Chiclayo, the departmental capital and largest city, has a population, of about 46,000. The climate is hot and virtually rainless. Agriculture is dependent on irrigation. The available water, whether in stream s or underground, is introduced from the Andean highlands by Rio Chancay. Rocks in the area range in age from Cretaceous, or possibly Jurassic, to Quaternary and in lithology from dense and hard igneous, sedimentary, and metamorphic rocks to unconsolidated sediments. The bedrock contains and yields water only in small quantities, if at all. The principal water-bearing strata are in the alluvium comprising the fan of Rio Chancay. Where ground water in the alluvium has been most intensively developed, the productive zone is within 20 m (meters) of the land surface and is composed approximately as follows: (1) relatively impermeable soil, clay, and clayey sand, 5 to 10 m thick, (2) permeable sand and gravel, 6 to 10 m thick, at places including one or more layers of clay, so that several water-bearing beds are distinguishable, and (3) relatively impermeable mixtures of clay, sand, and gravel extending below the bottom of wells. Unit 3 in the deepest test continued to 102 m. Unit 2 is the principal source of water tapped by irrigation wells. In the northern part of the area wells locally yield water rather freely from strata as deep as 73 m, but elsewhere in the area the strata deeper than 20 m are not very productive. Wells at and near Chiclayo yield only small amounts, and the deepest well disclosed, in 100 m of material, only 5.5 m of material that can be considered as possibly water bearing. Water in the alluvium of the eastern part of the area occurs under water-table conditions at depths from 1 to 8 m below the land surface. The water table declines during pumping for irrigation and rises when pumping is stopped. Recharge comes mainly from infiltration on irrigated fields and from irrigation ditches and probably varies greatly from year to year at any given place. The ground-water reservoir is replenished when pumps are idle; therefore, it is concluded that the recharge is sufficient to offset withdrawal at a rate comparable to that of 1957, which was about 81 million cum (cubic meters). A study of the effect of protracted pumping on yields of wells suggests that the rate of recharge locally, and for a short period, was more than 76,000 cu m per day. This recharge presumably declined rapidly to zero when irrigation was suspended in the locality. A pumping test showed the transmissivity to be about 950 cu m per day per m and the storage coefficient to be about 0.07. Based on these coefficients, the drawdown caused by one well discharging 10 lps (liters per second) for 6 months would be only 0.066 m at points 4,000 m distant, but 50 wells at the same rate and distance would create 3.3 m of drawdown. As actual distances between wells range from 100 to 300 m where the wells are most numerous and as the average discharge rate is nearer to 20 than to 10 lps, the cumulative effect of the actual pumping is certain to be considerable. If it were not for the recharge resulting from infiltration of irrigation water, the pumping of so many wells probably could not be long sustained. The waters from wells of the Lambayeque Valley compare favorably, in most respects, with the standards established by the U.S. Public Health Service for water for human consumption. Chemical analyses of 10 samples of ground water show that the dissolved solids, silica, bicarbonate, sulfate, and sodium increase in the downstream direction, where

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Stuart L. Schoff, M. Juan Luis Sayan. 1969. Ground-water resources of the Lambayeque Valley, Department of Lambayeque, northern Peru. https://doi.org/10.3133/wsp1663f

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper↗

Use of stable isotopes of carbon, nitrogen, and sulfur to identify sources of nitrogen in surface waters in the Lower Susquehanna River Basin, Pennsylvania

Samples of nitrogen-source material, soil, and water were collected from several small, primarily single-source subbasins in the Lower Susquehanna River Basin during 1988–90 to determine the feasibility of using measurements of stable isotope ratios of carbon ( 13 C), nitrogen ( 15 N), and sulfur ( 34 S) to identify sources of nitrogen (N) in stream water. Chemical and isotopic compositions were measured for six N-source types consisting of rain water, forest leaf litter, synthetic fertilizer, farm-animal manure, municipal-sewage effluent and sludge, and septictank effluent and sludge. Compositions of associated, nearby samples of topsoil, subsoil, runoff water, and stream water were measured to evaluate changes in compositions of transported N-containing materials near the N source. Animal manure, human waste (sewage plus septic), and forest-leaf litter can be distinguished on the basis of 13 C; however, most N-sources cannot be distinguished on the basis of 15 N and 34 S, owing to wide ranges and overlap of compositions among different N-source types. Although values of 15 N for soil and runoff-water samples are qualitatively similar to those of the applied N source, values of 13 C and 34 S for runoff-water and stream-water samples appear to reflect the compositions of relatively large reservoirs of the elements in soil organic matter and minerals, respectively, and not the composition of the applied N source. The ratio of organic carbon to total nitrogen (C-org:N), combined with 13 C, is useful for distinguishing agricultural soils, which have characteristically high 13 C and low C-org:N, from forested soils. The C-org:N values of suspended particulates in runoff or stream waters generally are lower than those of nearby soils, however, and indicate that chemical transformations and resultant isotopic fractionation can be important controls on the compositions of N-containing compounds in the soil and water. In aqueous samples including surface water and liquid N-sources, isotopic ratios commonly differ between coexisting dissolved fractions of NO 3- N and NH 3- N and between dissolved and particulate fractions of N or S, probably because of isotopic fractionation during transport or N-source processing. Isotopic measurements provide qualitative information about important reactions that can affect N concentrations in surface waters. However, mass-balance computations generally are not sufficiently accurate to estimate the proportions of multiple sources contributing to the N load in the streams studied because of (1) variations in source chemical and isotopic compositions and (2) nonconservative behavior and fractionation during transport over short distances (hundreds of meters). Uncertainties in mass-balance computations are complicated by the propagation of errors associated with measurements of discharge, chemical concentrations,and isotopic compositions of relatively dilute, small streams.

Pennsylvania↗

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper↗