Search USGS⌕ Search

USGS · wsp1499H

Water resources of the Hartford-New Britain area, Connecticut

Abstract

The Hartford-New Britain area includes the metropolitan areas of Hartford and New Britain and parts of several adjoining towns. Water used in the area is withdrawn from the principal streams and aquifers at an average rate of 463.5 mgd (million gallons per day). Sufficient water is available from these sources to meet present requirements and those for many years to come, although local shortages may develop in some areas as the result of problems of distribution and treatment. About 98 percent of all water used in 1957 was from surface sources. More than 425 mgd was required by industry, and about 23 mgd was for domestic water supply. The Farmington River upstream from Collinsville is the chief source of water for public supply in the Hartford-New Britain area, whereas the Connecticut River is the chief source of water for industry. An average of about 40 mgd is withdrawn from the upper Farmington River for public supply, and about 404 mgd is withdrawn by industry from the Connecticut River for nonconsumptive use and returned directly to the stream. The Connecticut River is the source of the largest quantity of water in the area. The flow of the stream at Thompsonville may be expected to equal or exceed about 2,000 mgd 95 percent of the time, and the flow should not be less than this amount for periods longer than 12 days. The flow below Thompsonville is increased by additions from the Scantic, Farmington, Park, and Hockanum Rivers and from numerous smaller tributary streams. The available streamflow data for the aforementioned rivers have been summarized graphically in the report. The chemical quality of water in the Connecticut River is good, except for short periods when the iron concentration is high. In addition to the removal of iron some other treatment may be necessary if water from the Connecticut River is used for special purposes. The chemical quality of the tributary streams is good, except the quality of the Park River, which is poor. Thus the Connecticut River in the vicinity of Hartford offers an almost unlimited source of water of good chemical quality to the Hartford, New Britain area. The Connecticut River and many of its tributaries, however, are polluted to some degree, and the cost of treatment for pollution and of delivery of water to the area presents an economic problem in the further development of these sources. The Hartford-New Britain area in the vicinity of Hartford has been plagued by floods since the time of its settlement. Most of the damage to property and loss of life in the Hartford area has been caused by flooding of the Connecticut and Park Rivers. Floods have occurred on the Connecticut River and its tributaries in every month of the year, but the most severe floods occur in the spring and fall. The most devastating flood on the Connecticut River occurred on March 21, 1986, when the stage at Hartford reached 37.0 feet above mean sea level. The maximum flood on the Park River occurred on August 19, 1955, when the stage reached 43.5 feet above mean sea level. Floods on the other tributaries have been frequent and some have been large, but damage has not been as great because the streams flow mostly through rural areas. Small to moderate supplies of water suitable for domestic use and for small municipalities and industries are available from wells in the Hartford-New Britain area. Moderate supplies are obtainable from five definable sand-and-gravel aquifers and from widespread consolidated sedimentary rocks. Yields to individual wells range from 15 to 400 gpm (gallons per minute) for wells penetrating sand and gravel and from 1 to 578 gpm for wells penetrating consolidated sedimentary rocks. Sand and gravel deposits bordering the Connecticut River downstream from Rocky Hill afford the greatest potential for the development of large supplies of ground water. Small supplies ranging from 1 to 40 gpm are obtainable from glacial till and from consolidated crystalline rocks.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 41.625° to 41.875° latitude; -72.875° to -72.567° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Robert Vittum Cushman, D. Tanski, M. P. Thomas. 1964. Water resources of the Hartford-New Britain area, Connecticut. https://doi.org/10.3133/wsp1499h

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Basic ground-water hydrology

Ground water is one of the Nation's most valuable natural resources. It is the source of about 40 percent of the water used for all purposes exclusive of hydropower generation and electric powerplant cooling. Surprisingly, for a resource that is so widely used and so important to the health and to the economy of the country, the occurrence of ground water is not only poorly understood but is also, in fact, the subject of many widespread misconceptions. Common misconceptions include the belief that ground water occurs in underground rivers resembling surface streams whose presence can be detected by certain individuals. These misconceptions and others have hampered the development and conservation of ground water and have adversely affected the protection of its quality. In order for the Nation to receive maximum benefit from its ground-water resource, it is essential that everyone, from the rural homeowner to managers of industrial and municipal water supplies to heads of Federal and State water-regulatory agencies, become more knowledgeable about the occurrence, development, and protection of ground water. This report has been prepared to help meet the needs of these groups, as well as the needs of hydrologists, well drillers, and others engaged in the study and development of ground-water supplies. It consists of 45 sections on the basic elements of ground-water hydrology, arranged in order from the most basic aspects of the subject through a discussion of the methods used to determine the yield of aquifers to a discussion of common problems encountered in the operation of ground-water supplies. Each section consists of a brief text and one or more drawings or maps that illustrate the main points covered in the text. Because the text is, in effect, an expanded discussion of the illustrations, most of the illustrations are not captioned. However, where more than one drawing is included in a section, each drawing is assigned a number, given in parentheses, and these numbers are inserted at places in the text where the reader should refer to the drawing. In accordance with U.S. Geological Survey policy to encourage the use of metric units, these units are used in most sections. In the sections dealing with the analysis of aquifer (pumping) test data, equations are given in both consistent units and in the inconsistent inch-pound units still in relatively common use among ground-water hydrologists and well drillers. As an aid to those who are not familiar with metric units and with the conversion of ground-water hydraulic units from inch-pound units to metric units, conversion tables are given on the inside back cover. Definitions of ground-water terms are given where the terms are first introduced. Because some of these terms will be new to many readers, abbreviated definitions are also given on the inside front cover for convenient reference by those who wish to review the definitions from time to time as they read the text. Finally, for those who need to review some of the simple mathematical operations that are used in ground-water hydrology, a section on numbers, equations, and conversions is included at the end of the text.

Water Supply Paper↗

Use of stable isotopes of carbon, nitrogen, and sulfur to identify sources of nitrogen in surface waters in the lower Susquehanna River basin, Pennsylvania

With the exception of sewage and septic effluents, most nitrogen sources and soils contain larger proportions of organic and reduced forms of carbon, nitrogen, and sulfur than inorganic, oxidized forms. In contrast, most surface water and ground water contains larger proportions of dissolved inorganic carbon, nitrogen, and sulfur forms than organic forms. Data indicate that carbon, nitrogen, and sulfur are extensively processed in soils and streams.

Water Supply Paper↗

Validation of a numerical modeling method for simulating rainfall-runoff relations for headwater basins in western King and Snohomish Counties, Washington

The validity of a previously determined numerical modeling method was assessed. Numerical models for 11 drainage basins were constructed with the Hydrologic Simulation Program-FORTRAN (HSPF) with parameter values that were generalized for the physiographic region. Large and recurrent simulation errors were initially identified, but three systematic modifications of the models corrected those errors for 10 out of the 11 basins. The validity of the numerical modeling method for simulating rainfall-runoff relations in the study area, as modified during this investigation, was not rejected, but observed streamflow data were needed to apply the method.

Water Supply Paper↗