Search USGS⌕ Search

USGS · sir20245062E

Volcanic gas monitoring

Abstract

Introduction As magma rises through the crust, decreasing pressure conditions allow volatiles to exsolve from the magma. These volatiles then migrate upward through the crust, where they can be stored at shallower levels or escape to the atmosphere. Rising magma also heats rock masses beneath volcanic centers, causing water in shallow aquifers and hydrothermal systems to boil and release additional gases and steam (see chapter F , this volume; Ingebritsen and Hurwitz, 2024). The chemistry and quantity of gases that reach the surface during periods of quiescence or volcanic unrest can reveal that gas-rich magma is ascending, crystallizing, or alternatively stalling, with important implications for volcanic hazard (for example, Sutton and others, 1992; Aiuppa and others, 2007, 2021; Werner and others, 2009, 2011, 2012; Moretti and others, 2013; de Moor and others, 2016; Lewicki and others, 2019; Edmonds and others, 2022; Kern and others, 2022; Kunrat and others, 2022). Most volcanoes in Alaska and the western United States are characterized by weak degassing, with one or more low-temperature fumaroles (typically near the local boiling temperature of water) and connect to a deeper and sometimes extensive hydrothermal system (for example, McGee and others, 2001; Symonds and others, 2003a, b). Hydrothermal systems will affect the chemistry of rising gases exsolved from deeper magma (Symonds and others, 2001), including sulfur dioxide (SO 2 ), hydrogen chloride (HCl), and water vapor (for example, Doukas and Gerlach, 1995; Gerlach and others, 1998, 2008; Symonds and others, 2001; Werner and others, 2013). As an example, depending on factors such as temperature, pressure, and oxidation state, rising SO 2 will react with groundwater to form hydrogen sulfide (H 2 S) gas, dissolved sulfate (SO 4 2− ), or elemental sulfur (Christenson, 2000; Symonds and others, 2001; Werner and others, 2008). The reaction and dissolution of SO 2 into shallow groundwater is commonly referred to as scrubbing, and can reduce the likelihood that ascending, degassing magma can be detected. Carbon dioxide, however, in addition to exsolving from magma early in the ascent process, is not easily removed by hydrothermal fluids (Lowenstern, 2001). As scrubbing and other processes take place, the SO 2 /H 2 S, CO 2 /SO 2 , and CO 2 /H 2 S ratios may change. High rates of SO 2 emission indicate that magma has moved to relatively shallow levels in the volcano and that the system has heated up enough to establish dry pathways from depth to the surface. Monitoring multiple gas species and the total output of those species is thereby useful for volcano monitoring during both periods of quiescence, to establish background degassing conditions, and during unrest, when gas geochemistry and emission rates can provide information on changing conditions, such as magma ascent. To provide context for multidisciplinary volcano forecasts, we focus on the following two key required capabilities: (1) characterizing baseline geochemistry and gas discharge from volcanoes and volcanic regions and (2) monitoring changes in gas geochemistry and discharge to inform forecasts of volcanic eruptions and their effects. Sufficient baseline data must be collected to identify and interpret anomalous degassing associated with volcanic unrest (for example, Sorey and others, 1998; Rouwet and others, 2014). Differences in volcano type, baseline degassing rates, local hydrology, and geography (for example, high versus low latitude) will result in a different baseline for each volcano. Volcanoes of any threat level that exhibit one or more degassing phenomena would ideally be monitored by techniques needed to establish baseline degassing data, with the sampling frequency of baseline data dictated by the threat level (table E1). Additional monitoring techniques become necessary during periods of unrest. In general, three of the most important techniques for gas monitoring are (1) direct sampling of fumarole, spring, and soil gases for laboratory geochemical measurements, (2) measurements of the chemical composition of the volcanic plume and emission rates of major gas species (for example, H 2 O, CO 2 , SO 2 , and H 2 S) by satellite, airborne, or ground-based techniques, and (3) measurements of diffuse emissions of CO 2 and other gases through soils. Various methods and instruments may be useful both for baseline studies and during unrest.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Jennifer L. Lewicki, Christoph Kern, Peter J. Kelly, Patricia A. Nadeau, Tamar Elias, Laura E. Clor. 2024-10-04. Volcanic gas monitoring. https://doi.org/10.3133/sir20245062e

Cite the original work for its findings. Save a collection to share your selection of sources.

Discover connections

Connections use source metadata and explicit phrase matches, not verified experimental comparisons.

KEEP EXPLORING

Related USGS reports

Slip tendency and dilation tendency of Quaternary faults in the Great Basin region, Arizona, California, Idaho, Nevada, Oregon, Utah, and Wyoming

This report presents the results of slip tendency and dilation tendency analysis of Quaternary faults in the Great Basin region, in the states of Arizona, California, Idaho, Nevada, Oregon, Utah, and Wyoming. This effort was undertaken as part of two studies: the U.S. Department of Energy Geothermal Technologies Office-funded Innovative Geothermal Exploration through Novel Investigations of Undiscovered Systems (INGENIOUS) project, which is a multidisciplinary, multi-institution effort to develop new methodologies and best practices to accelerate the discovery of new, commercially viable hydrothermal resources; and the U.S. Geological Survey Geothermal Resources Investigations Project. The goal of this work is to identify faults and fault segments that are appropriately oriented to be stress-loaded for slip or to dilate under the ambient stress conditions. Both conditions may make such faults more likely to host permeability and fluid flow relative to other faults in the region. Slip tendency and dilation tendency were calculated for all fault segments in the study area from the U.S. Geological Survey Quaternary Fault and Fold Database. Results demonstrate that faults with high slip tendency and dilation tendency are common in the Great Basin region. The areas containing many high slip tendency and dilation tendency fault segments are associated with high strain rates. These areas also host a relatively high proportion of the known hydrothermal systems. This indicates that faults with high slip tendency and dilation tendency in areas with high strain-rate are potentially most prospective for hosting hydrothermal systems. The database published in coordination with this report contains the slip tendency and dilation tendency results data, including the fault geometry and stress data used to calculate these quantities, for both the Great Basin study area and the smaller INGENIOUS study area.

Scientific Investigations Report↗

A spatial analysis of the groundwater emergence flood hazard in Long Island, New York, and coastal areas surrounding Long Island Sound in New York, Connecticut, and Rhode Island

Long Island, New York, and nearby coastal areas surrounding Long Island Sound are densely populated and, like other coastal areas, are susceptible to flooding from several potential sources, including stormwater from precipitation events, tidal flooding and storm surge, and groundwater emergence flooding. Groundwater emergence fooding refers to the intersection of a rising water table with land surface or critical infrastructure. Many studies of flood drivers either neglect or only briefly discuss how shallow groundwater conditions may contribute to or exacerbate flood conditions. As a part of a comprehensive study of compound flood hazards in the coastal areas of Long Island and Long Island Sound, a spatial analysis was completed by the U.S. Geological Survey, in cooperation with the Environmental Protection Agency’s Long Island Sound Partnership, formerly called the Long Island Sound Study, using available regional datasets to characterize the potential hazard for groundwater emergence flooding. The approximately 3,100 square mile study area was subdivided into 11,407 grid cells that were 900 meters by 900 meters (approximately 3,000 feet by 3,000 feet), for the purpose of integrating the spatial datasets to calculate and map the groundwater emergence flood hazard. The depth to the water table, hydrologic soil groups, and National Land Cover Database were harmonized to the common grid. A groundwater emergence flood hazard score was calculated for each grid cell for current average conditions following a set of rules accounting for the depth to the water table and the percentage of area within each cell with slow infiltrating soils. A scenario with a higher sea-level position was also calculated for the Long Island part of the study area. The calculated groundwater emergence flood hazard score was reviewed in conjunction with the National Land Cover Database to identify developed areas and associated infrastructure that may be at risk of potential groundwater emergence flooding. Study results indicate that the groundwater emergence flood hazard is highest in coastal areas and near surface water where the water table is close to ground surface. Inland areas away from surface waterbodies are not likely to be exposed to groundwater emergence flooding. For Long Island, in the scenario with higher sea-level position, a greater groundwater emergence flood hazard is calculated for some locations closer to the coast and where land is submerged. Away from the coast and surface-water drainage, the groundwater emergence flood hazard is similar between the current average sea-level condition and the higher sea-level position scenario.

Connecticut, New York, Rhode Island↗

Streamflow assessment of Birch Creek, southern boundary of the Blackfeet Indian Reservation, Pondera County, northwestern Montana—Synoptic and continuous streamflow measurements through 2022

The U.S. Geological Survey, in cooperation with the Blackfeet Water Department, performed this study to assist water-resource managers in understanding and quantifying irrigation diversions, instream flows, and the spatial and temporal streamflow dynamics of Birch Creek in northwestern Montana. Birch Creek forms the southernmost boundary of the Blackfeet Indian Reservation and is highly valued culturally as an aquatic life and wildlife resource and as a principal source of water for irrigation. The study area included Birch Creek from Swift Dam to 53.3 miles downstream just above its confluence with the Two Medicine River. The study period was calendar year 2022, but selected historical information was also included in the study. Birch Creek streamflow originates through releases from Swift Reservoir, with the largest releases typically occurring during the irrigation season (May–October) to primarily meet the needs of downstream irrigators. This study included the compilation and collection of (1) continuous streamflow measured at streamgages installed for this study, (2) instantaneous streamflow measurements made during four synoptic events, and (3) reported daily values of Swift Reservoir outflow and irrigation diversions. Continuous streamflow data were available from two U.S. Geological Survey streamgages: Birch Creek below Heart Butte Road, near Heart Butte, Montana (upper streamgage; station 06094900), at river mile 12.9 and Birch Creek at Bullhead Bridge near Valier, Mont. (lower streamgage; station 06098120), at river mile 53.3. The upper streamgage (station 06094900) was primarily affected by the regulated releases from Swift Dam with daily mean streamflow typically slightly higher than the reported Swift Reservoir outflows. Daily mean streamflow ranged from 9.87 cubic feet per second (ft 3 /s) (November 18, 2022) to 640 ft 3 /s (June 22, 2022) during September 16, 2021–December 31, 2022. The mean annual streamflow was 122 ft 3 /s in water year 2022 (a water year is the 12-month period from October 1 to September 30 and is designated by the year in which it ends), about 13 percent greater than the mean annual reported Swift Reservoir outflows. The lower streamgage (station 06098120) was downstream from all major tributaries and diversions within the Birch Creek drainage basin. Daily mean streamflow ranged from 6.02 ft 3 /s (September 8, 2022) to 95.0 ft 3 /s (June 5, 2021) during August 26, 2020–December 31, 2022. Mean annual streamflow was 27.8 ft 3 /s for water year 2022. Flows at the lower streamgage (station 06098120) were typically lower than at the upper streamgage (station 06094900) from late April to early October, whereas flows from early October to late spring were similar to or greater than those at the upper streamgage. The upper streamgage had a total streamflow volume of 87,960 acre-feet (acre-ft) for water year 2022, whereas the lower streamgage had a total streamflow of 20,357 acre-ft. A net volume of about 67,603 acre-ft was removed from Birch Creek through diversions, losses to groundwater, and evapotranspiration along that reach during water year 2022. Most of the changes in main-stem streamflow could be accounted for by the tributary inflows or diversion outflows. The most dynamic streamflow gains and losses occurred along the upper few miles of Birch Creek. Streamflow was consistently lost to the groundwater system immediately below Swift Dam and then returned to levels that slightly exceeded the outflow at the dam near river mile 11.0. The overall net gains for the entire 53.3-mile study reach ranged from 15.5 to 42.6 ft 3 /s among the synoptic events. On several occasions, streamflow fell below minimum instream flow conditions specified in the Blackfeet Compact (water rights compact among the Blackfeet Tribe, State of Montana, and United States), which are subject to a 15-year deferral period (until June 12, 2033). Notably, a section of Birch Creek immediately downstream from Swift Dam was completely dry during the October 18, 2022, synoptic event.

Montana↗