Search USGSSearch

USGS · pp1708D.1

Coal and coalbed-methane resources in the Appalachian and Black Warrior basins: maps showing the distribution of coal fields, coal beds, and coalbed-methane fields

Abstract

The maps contained in this chapter show the locations of coal fields, coal beds assessed by the U.S. Geological Survey (USGS) in 2000, and coalbed-methane fields in the central and southern Appalachian basin study areas, which include the coal-producing parts of the Black Warrior basin. The maps were compiled and modified from a variety of sources such as Tully (1996), Northern and Central Appalachian Basin Coal Regions Assessment Team (2001), Hatch and others (2003), Milici (2004), and unpublished data from the State geological surveys of Pennsylvania, West Virginia, Virginia, and Alabama. The terms “coalbed methane” and “coal-bed gas” are used interchangeably in this report. All of the figures are located at the end of this report. The Appalachian basin historically has been subdivided into three coal regions on the basis of regional geologic structure and stratigraphy: the northern region in western Pennsylvania, eastern Ohio, western Maryland, and northern West Virginia; the central region in west-central and southwestern West Virginia, eastern Kentucky, northern Tennessee, and southwestern Virginia; and the southern region in southern Tennessee, northern Alabama, and northwestern Georgia. The Appalachian basin is one of the most important coal-producing regions in the Nation and the world, and coal has been mined there throughout the last three centuries. The coal is primarily used within the Eastern United States for electrical power generation, but some of it is suitable for metallurgical uses. In 2008, the Appalachian basin produced about 320 million short tons of coal from 1,278 underground and surface coal mines (Energy Information Agency, 2009a). Coalbed-methane production in the Appalachian basin coal regions is an increasingly important resource. In 2008, 247 billion cubic feet (bcf) of coalbed methane was produced in the basin from Alabama (107 bcf), Virginia (101 bcf), West Virginia (28 bcf), and Pennsylvania (11 bcf) (Energy Information Agency, 2009b). Coalbed-methane exploration is ongoing in all of the States in the Appalachian basin coal regions, and production is expected to increase. The study area for most reports in this volume is the Appalachian basin. The term “Appalachian basin study area” (shortened from “Appalachian basin geologic framework study area”) includes all of the Appalachian Basin Province (Province 67) and part of the neighboring Black Warrior Basin Province (Province 65) of Dolton and others (1995). The boundaries for these two provinces and the study area are shown on figure 1.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 32.43561304116276° to 44.695992981720714° latitude; -88.43994140625° to -73.619384765625° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Michael H. Trippi, Leslie F. Ruppert, Robert C. Milici, Scott A. Kinney. 2014. Coal and coalbed-methane resources in the Appalachian and Black Warrior basins: maps showing the distribution of coal fields, coal beds, and coalbed-methane fields. https://doi.org/10.3133/pp1708d.1

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Resurvey of the Marble Canyon and Bridge Canyon dam sites in Grand Canyon National Park—Changes in sediment storage and evidence supporting the occurrence of bedrock incision through the mid-20th century

The Bureau of Reclamation developed an extensive plan for a network of dams, water tunnels, and hydropower plants in and around Grand Canyon, Arizona, in the 1940s through 1960s. The two largest of these planned dams were the Marble Canyon and Bridge Canyon Dams on the Colorado River. Though these dams were ultimately never built, Reclamation conducted extensive topographic, bathymetric, and subsurface exploration work at the sites proposed for these dams in the 1940s and 1950s. Resurveys of these dam sites were conducted between 1998 and 2021 to determine the changes in sediment storage at these dam sites caused by the upstream construction and operation of Glen Canyon Dam and by the recession of Lake Mead, the reservoir impounded by Hoover Dam. The resurveys of the Marble Canyon dam sites indicate that the post-1950s changes in sediment storage at these dam sites are broadly consistent with flux-based estimates of voluminous sand erosion from Marble Canyon since the 1963 closure of Glen Canyon Dam. These resurveys also suggest that the pre-dam longitudinal variation in sediment thickness over bedrock played a key role in determining the locations of the sand erosion induced by Glen Canyon Dam; more sand eroded from locations where more sand was present in the 1950s. The resurvey of the Bridge Canyon dam sites indicates that the Colorado River’s incision of the Lake Mead delta is regulated both by bed-sediment grain size and downstream hydraulic controls. Finally, analyses of bed-sediment thickness and sedimentological data at the dam sites, and observations of bed scour and gravel transport, suggest that sufficient bedrock was exposed to allow bedrock incision during commonly recurring pre-dam snowmelt floods that entrained small boulders into transport.

Arizona

The eruptive behavior of distributed volcanism forming low shield edifices—A case study of Sentinel-Arlington volcanic field, U.S.A.

Distributed volcanic fields are present in various tectonic settings worldwide, and their characteristics reflect differing influences from magmatic and tectonic processes. In the southwestern United States alone, there are 37 Quaternary distributed volcanic fields. After the primary period of extensional tectonics in the southern Basin and Range 15–5 million years ago, the Sentinel-Arlington volcanic field developed in southwestern Arizona between 4 and 1 million years ago. The Sentinel-Arlington volcanic field consists primarily of low relief shield volcanoes, a type of distributed volcanism with poorly understood temporal evolution. The Sentinel-Arlington volcanic field is less than 200 kilometers (km) from the Colorado Plateau, Gulf of California, and southern San Andreas Fault system. This work identifies and examines controls on the emplacement of the Sentinel-Arlington volcanic field by documenting shallow and surficial structures as well as eruption characteristics and style through time. The Sentinel-Arlington volcanic field consists of 21 volcanoes with a total of 33 vents over an area of about 770 square kilometers (km 2 ). The prominence of low relief shield volcanoes may be explained by ascent of basaltic magmas through thin Basin and Range crust, without much crustal contamination, and low viscosities common to mafic compositions. Typical eruption characteristics involve the construction of low relief shield volcanoes followed by Strombolian fissure eruptions at the summits or near-summit medial areas that produce scoria lapilli, which may weld to form agglomerate. The total lifetime erupted volume of about 4.3 cubic kilometers (km 3 ) represents an average eruptive flux of approximately 2x10 -3 km 3 per thousand years (k.y.). This erupted volume is low relative to Neogene basaltic intraplate distributed volcanic fields worldwide, which typically range from 10 -3 to 1 km 3 k.y. -1 . Sentinel-Arlington volcanic field eruptions were likely triggered by intermittent rejuvenation of transient magmatic zones that exist in thinned crust. Instantaneous flux from point sources feeding the lava flows is estimated to be on the order of 10 -1 to 10 cubic meters per second.

Arizona

Capitalization of positional (Lower/Middle/Upper) and temporal (Early/Middle/Late) adjectives in the names of formal chronostratigraphic and geochronologic units of the Phanerozoic

Many authors are understandably confused about the capitalization of the words “lower,” “middle,” “upper,” “early,” and “late.” Where these words are used simply as descriptive adjectives, they should be in lowercase; where they form the first word of a formal chronostratigraphic or geochronologic unit name, they should be in uppercase.

Professional Paper