Search USGSSearch

USGS · ofr90294

Geology and mineralization at the Ishmas Kabir gold prospect, Ishmas gold district, Kingdom of Saudi Arabia

Abstract

Ishmas Kabir ancient gold mine is located approximately 60 km southeast of the city of Ranyah and 9 km northwest of Jabal Ishmas in the southwestern part of the Ishmas gold district. The mine workings are located near the eastern edge of a flat plain covered by eolian sand and drained by Wadi Bishah. Two elongate dumps, 75 m wide and 530 m long (combined length), comprise the workings. Rising 4 m above the plain, they are prominent features in this area of low relief. Core drilling (1,023 m total depth drilled) was conducted to define the extent of potential gold occurrences at the prospect. The two northeasternmost of the four holes drilled unequivocally intersected the gold-bearing main vein zone. Drill hole 1, the northeasternmost hole drilled, passed through significant lengths of altered wall rocks + quartz veins containing > 100 ppb Au (threshold value). The average gold concentration of all intercepts in drill holes 1 through 4 is 278 ppb; the total length of drill core that assayed above the gold threshold value is 13.46 m. The highest gold concentration (1,620 ppb) reported in geochemical assay results was obtained from a 0.33 m length of core in drill hole 1. Gold-intercept occurrences are not economic in the rocks drilled; no further deep drilling is recommended at this time. Gold concentrations in samples obtained from mine dumps are much higher than in drill-core samples. Samples collected by earlier workers assayed 3-7 g/t, and tonnage estimates of mine spoil have been estimated to be as high as 120,000 tons. A possible sampling bias in earlier studies may favor larger gold-enriched, samples relative to samples from quartz tailings. Further work at Ishmas Kabir should be limited to defining gold resource potential in the dumps and in the oxidized, near-surface quartz-vein system. Primary gold at the Ishmas Kabir gold prospect occurs with quartz veins and associated sericite + pyrite alteration hosted by quartz diorite and mafic dikes. The highest gold concentrations both in dumps (earlier studies) and drill core (this investigation) are found with limonite + hematite in breccia zones, in stringer veins, and in sericitic alteration envelopes surrounding quartz veins. Secondary gold is significant in this system and attests to the importance of oxidizing, acidic solutions. Quartz veins intersected by drill holes are surrounded by mylonite schist. Quartz and carbonate veins less than 5 mm thick are boudined, whereas thick quartz veins (£ 1.2 m) have disrupted and brecciated margins; mylonitized country rock envelops quartz-vein fragments. Sulfide mineralization associated with vein formation predates this rock-deformation event. Contemporaneous brittle and ductile deformation of quartz veins and country rocks occurred during the Nabitah orogeny. Supergene gold enrichment took place much later.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 20° to 30° latitude; 43° to 44° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

B.M. Walker, Majed Ben Talib, Mohamed El Komi, M.A. Hussain, R.P. Christian. 1990. Geology and mineralization at the Ishmas Kabir gold prospect, Ishmas gold district, Kingdom of Saudi Arabia. https://doi.org/10.3133/ofr90294

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Special Contributing Area Loading Program user’s manual

Information on the Special Contributing Area Loading Program execution and functions are presented in this user’s manual. An appendix presents a potential improvement for the user to consider. The hydrologic routing simulation method to model flow through multiple reservoirs, or sewer system components, is described. The use of Special Contributing Areas is described to run a successful simulation, which includes user input of hydrologic time series of flow components and the necessary formats. Upon completion of a successful Special Contributing Area Loading Program simulation, the program outputs hydrologic time series and a descriptive text file containing the model results for each defined sub-unit, or Special Contributing Area. The output time series contain flows through, and overflows from, the three reservoirs in the series, and the text file contains input and output path locations.

Open-File Report

Estimating aftershock risk for entry into earthquake-damaged buildings

We present a simple method to estimate the risk of experiencing strong shaking from aftershocks during entry into earthquake-damaged buildings. We compute wait times until the probability of strong ground shaking from aftershocks reaches a predefined risk threshold; for example, a 0.4 percent probability of experiencing Modified Mercalli Intensity 7 or greater shaking during the planned building entry. We also develop a relation between aftershock probability and the probability of strong shaking, so that users can reference the U.S. Geological Survey aftershock forecast during an ongoing aftershock sequence to determine if the risk threshold has been met. We apply our method to active continental regions (for example, the Western United States), stable continental regions (for example, the Central and Eastern United States), and subduction zones (for example, Cascadia or Alaska).

Open-File Report

End-user needs for remote sensing wetlands of the Prairie Pothole Region of North America

The Prairie Pothole Region (PPR) of North America comprises globally important grassland and wetland ecosystems critical for numerous populations of migratory birds. Due to the importance of this region for migratory birds, and particularly waterfowl, and the threats of habitat loss due to intensifying agriculture, there is a mature and diverse system of conservation organizations, agencies, and partnerships that spends hundreds of millions of dollars annually on habitat conservation to support migratory bird populations. Remote sensing can be a powerful tool for observing and evaluating global change at large scales as well as expanding inferences from field studies to the broader landscape with statistical models. However, development and utilization of these tools has lagged behind their demand for several reasons, including concerns over spatial and temporal resolution and accuracy of products; perception of a misalignment with decision-maker needs; technological barriers such as skill sets of conservation professionals, computing resources, data access, and usability. In this report, we summarize the needs of conservation professionals and scientists who use or want to use remote sensing data products to inform science about wetland change and conservation of wetlands in the PPR. We assembled this information through several methods leading up to, during, and following a January 2026 PPR Wetland Remote Sensing Workshop. The workshop included United States and Canadian scientists, conservation professionals, and policy experts. Our goal was to bring together end-users and remote sensing product developers jointly to explore reducing the lag between product development and utilization of products to inform science and conservation. Specifically, we aimed to identify gaps in wetland remote sensing that limit effective monitoring, management, and conservation in the PPR, and to develop a framework that outlines pathways to address these gaps by fostering collaboration, improving communication networks, encouraging discussion, and building on existing and ongoing efforts. This report summarizes our participants’ descriptions of end-user needs and the outcomes of the workshop.

Prairie Pothole region