Search USGS⌕ Search

USGS · ofr76240

Helium detection as a guide for uranium exploration

Abstract

Helium, a byproduct of radioactive decay, may prove to be a valuable indicator of the presence and distribution of uranium deposits. Recent technological advances permit the development of instrumentation not previously adapted for this purpose. Commercially available equipment can provide high sensitivity at low cost and allow reasonable mobility for field use. A truck-mounted mass-spectrometer, tuned for helium-4, permits immediate adjustment or modification of sampling patterns in response to accumulating data. The inlet system of the spectrometer has been designed to allow flexibility in gas analyses from various sample types--soil gas, atmosphere, or gases in water. Sensitivity of the instrument is better than 50 parts of helium per 10 9 parts of gas. Replicate samples and standards can be analyzed in only 3 minutes. Helium in soil gas is being used for the initial evaluation of the technique. A hollow probe, as much as 2 m long, is driven into the ground; and a 10-cc syringe is used to purge the probe and extract the gas. This sample is then injected into the inlet system and introduced into the spectrometer at constant pressure. The output signal is displayed on a chart recorder. Investigations can be performed on a qualitative, relative basis, or on a quantitative basis by comparison to calibrated helium standards. Preliminary field testing includes studies of the responses to variations in wind speed, temperature, barometric pressure, moisture, and sampling depth over extended time periods, as well as studies of geologic controls on the helium content in soil gas. Surveys over known uranium occurrences reveal some anomalous helium distributions. This report describes an updated technological approach to an old idea: that of using helium, a byproduct of uranium radioactive decay, as an exploration tool for uranium. Helium is the sixth most abundant gas found in the earth's atmosphere (Table 1). It is an inert gas and very mobile, mixing rapidly. When the alpha particles from the radioactive decay of uranium and thorium pick up two electrons, atoms of the isotope helium-4 are formed. Several helium-4 atoms are produced from each decay series of U-238, U-235, and Th-232 (fig. 1). The half-lives of the parent isotopes are5also shown in figure 1. One gram of uranium will produce ~10 5 atoms of helium-4 per second, and one gram of thorium produces ~2.5 x 10 4 atoms of helium-4 per second (fig. 2). Calculations of the helium produced from the crust and mantle reveal that 1,125 x 10 30 atoms per year are produced, but only 7 x 10 30 atoms per year escape from the earth (Damon and Kulp, 1958). More is being produced than is being lost; in fact, the total atmospheric content of helium could be produced in only 2 million years (MacDonald, 1963)! However, all the crustal and mantle helium-4 does not degas into the atmosphere as it is formed. It is trapped in crystal lattices and in pore spaces within the earth. What this means is that there is excess helium-4 in the earth--excess, that is, compared to the atmospheric concentration in equilibrium with the helium-4 escape rate into space and the helium-4 flux from the crust and mantle (Nicolet, 1957). Near-surface pockets of high helium-4 concentrations are known, and some natural gas fields are so enriched that they are the source for commercial production of helium. Work by Roberts and others (1975) has shown high helium concentration in the soil gas associated with geothermal areas; and work by Clark and Kugler (1973), Dyck (1975), and Goldak (1974), for example, has noted high helium concentrations in soils and waters in the vicinity of uranium deposits. These latter studies certainly indicate the potential of helium detection for use as an exploration tool for uranium.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

G. Michael Reimer. 1976. Helium detection as a guide for uranium exploration. https://doi.org/10.3133/ofr76240

Cite the original work for its findings. Save a collection to share your selection of sources.

Discover connections

Connections use source metadata and explicit phrase matches, not verified experimental comparisons.

KEEP EXPLORING

Related USGS reports

ECCOE Landsat quarterly calibration and validation report—Quarter 2, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 2 (April–June), 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov.

Open-File Report↗

ECCOE Landsat quarterly calibration and validation report—Quarter 1, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 1 (January–March) of 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov . One specific activity that the ECCOE Landsat Cal/Val Team closely monitored was a Landsat 8 Thermal Infrared Sensor encoder alerts anomaly. On March 18, 2026, the Thermal Infrared Sensor instrument’s mechanism control electronics board reset, driving several parameters to default power-on values. Subsequent telemetry and analysis determined that no persistent hardware misconfiguration was present and no radiometric or geometric degradation was observed.

Open-File Report↗

Floods of June 20–July 6, 2024, in the Big Sioux River, Rock River, Little Sioux River, Ocheyedan River, and Floyd River Basins, northwestern Iowa

Major flooding occurred on June 20–July 6, 2024, in northwestern Iowa affecting the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd River Basins. Heavy rain fell in northwestern Iowa, southwestern Minnesota, and southeastern South Dakota on June 20–22, 2024. Parts of northwestern Iowa recorded 2–6 inches of rainfall and localized amounts exceeding 12 inches. A maximum peak-of-record streamflow of 175,000 cubic feet per second at the U.S. Geological Survey streamgage Big Sioux River at Akron, Iowa (06485500), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at four locations along the Big Sioux River between U.S. Interstate 29 at Sioux City, Iowa, upstream to Iowa Highway 10 north of Hawarden, Iowa, a distance of 75.7 river miles. A maximum peak-of-record streamflow of 157,000 cubic feet per second at the U.S. Geological Survey streamgage Rock River near Rock Valley, Iowa (06483500), was recorded on June 22, 2024, and had an annual exceedance probability of less than 0.2 percent. High-water marks were measured at eight locations along the Rock River between County Road B30 east of Hudson, South Dakota, upstream to Iowa Highway 9 at Rock Rapids, Iowa, a distance of 39.3 river miles. A maximum peak-of-record streamflow of 63,000 cubic feet per second at the U.S. Geological Survey streamgage Little Sioux River at Correctionville, Iowa (06606600), was recorded on June 24, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at 11 locations along the Little Sioux River between Iowa Highway 31 west of Correctionville, Iowa, upstream to U.S. Highway 18 north of Spencer, Iowa, a distance of 134.8 river miles. A maximum streamflow of 24,500 cubic feet per second at the U.S. Geological Survey streamgage Ocheyedan River near Spencer, Iowa (06605000), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at three locations along the Ocheyedan River between County Road M38 west of Spencer, Iowa, upstream to U.S. Highway 18 west of Everly, Iowa, a distance of 12.8 river miles. A maximum streamflow of 41,000 cubic feet per second at the U.S. Geological Survey streamgage Floyd River at Alton, Iowa (06600100), was recorded on June 22, 2024, and had an annual exceedance probability range of 1–1.99 percent. High-water marks were measured at six locations along the Floyd River between Iowa Highway 3 at Le Mars, Iowa, upstream to Iowa Highway 10 at Alton, Iowa, a distance of 27.5 river miles. The high-water marks were used to develop flood profiles for the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd Rivers.

Iowa, Minnesota, South Dakota↗