Search USGS⌕ Search

USGS · ofr20201078

Assessment of dissolved-selenium concentrations and loads in the Lower Gunnison River Basin, Colorado, as part of the Selenium Management Program, 2011–17

Abstract

The Gunnison Basin Selenium Management Program implemented a water-quality monitoring network in 2011 to measure concentrations of selenium in the lower Gunnison River Basin in Colorado. Selenium is a trace element that bioaccumulates in aquatic food chains. Selenium is essential for life, but elevated amounts can cause reproductive failure, deformities, and other harmful effects. The primary goal of the Selenium Management Program is to meet the State of Colorado water-quality standard of 4.6 micrograms per liter (µg/L) for dissolved selenium at the U.S. Geological Survey (USGS) streamflow-gaging station number 09152500—Gunnison River near Grand Junction, Colorado—herein referred to as “Whitewater.” The U.S. Geological Survey, in cooperation with the Bureau of Reclamation, has completed a review of dissolved-selenium data collected from the Selenium Management Program network during Water Year (WY) 2017 (October 1, 2016 through September 30, 2017) to further the understanding of the status and trends of selenium in the basin. This report presents the percentile values for selenium because regulatory agencies in Colorado make decisions based on the U.S. Environmental Protection Agency’s Clean Water Act section 303(d), which uses percentile values for concentrations. Also presented are dissolved-selenium loads at 14 sites in the lower Gunnison River Basin for WYs 2011–17. Annual dissolved-selenium loads were calculated for six sites with continuous U.S. Geological Survey streamflow-gaging stations. These six sites are referred to as “core” sites in this report. The remaining sites, which do not have streamflow-gaging stations, are referred to as “ancillary” sites in this report. During WY 2017, the loads calculated at the six core sites ranged from 306 pounds (lb) at Uncompahgre River at Colona to 12,600 lb at Whitewater, respectively. By using discrete water-quality samples and the associated discharge measurements, instantaneous loads were calculated for 14 sites in WYs 2011–17 where discrete water-quality sampling took place. Median instantaneous loads ranged from 0.52 pounds per day (lb/d) at Uncompahgre River at Colona to 35.7 lb/d at Whitewater. Mean instantaneous loads ranged from 0.63 lb/d at Cummings Gulch at mouth to 35.5 lb/d at Whitewater. Most tributary sites in the basin had a median instantaneous dissolved-selenium load of less than 20.0 lb/d. In general, dissolved-selenium loads at Gunnison River main-stem sites showed an increase from upstream to downstream. The State of Colorado’s water-quality standard for dissolved selenium of 4.6 µg/L was compared to the 85th percentiles for dissolved selenium at selected sites. Annual 85th percentiles for dissolved selenium were calculated by using estimated dissolved-selenium concentrations from linear regression models for the six core sites with U.S. Geological Survey streamflow-gaging stations. The 85th-percentile concentrations for WY 2017 based on this method ranged from 0.68 µg/L at Uncompahgre River at Colona to 140 µg/L at Loutzenhizer Arroyo at North River Road. The 85th percentiles for concentrations of dissolved selenium also were calculated from water-quality samples collected during WY 2017 from sites with sufficient data. The annual 85th-percentile concentrations based on the discrete samples ranged from 0.75 µg/L at Uncompahgre River at Colona to 106 µg/L at Loutzenhizer Arroyo at North River Road. An analysis was completed for Whitewater to determine if an upward or downward trend exists for dissolved-selenium loads during two time periods. The first time period included all data at Whitewater, whereas the second time period focused on more recent data. The trend analysis indicates a decrease from 22,200 to 12,600 lb, which is a 43.1 percent (9,600 lb) reduction during the time period WY 1986 through WY 2017. The trend analysis for the annual dissolved-selenium load for WY 1995 through WY 2017 indicates a decrease of 6,600 lb per year, or 35.5 percent. An evaluation of laboratory bias was completed for selenium data which was used in the trend analysis. Findings indicated a potential positive bias of approximately 12 percent may exist in the data from October 2005 through August 2015.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 37.309014074275915° to 39.115144700901475° latitude; -109.11895751953125° to -107.1441650390625° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Mark F. Henneberg. 2020-08-26. Assessment of dissolved-selenium concentrations and loads in the Lower Gunnison River Basin, Colorado, as part of the Selenium Management Program, 2011–17. https://doi.org/10.3133/ofr20201078

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

ECCOE Landsat quarterly calibration and validation report—Quarter 2, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 2 (April–June), 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov.

Open-File Report↗

ECCOE Landsat quarterly calibration and validation report—Quarter 1, 2026

Executive Summary The U.S. Geological Survey Earth Resources Observation and Science Calibration and Validation (Cal/Val) Center of Excellence (ECCOE) focuses on improving the accuracy, precision, calibration, and product quality of remote-sensing data, leveraging years of multiscale optical system geometric and radiometric calibration and characterization experience. The ECCOE Landsat Cal/Val Team continually monitors the geometric and radiometric performance of active Landsat missions and makes calibration adjustments, as needed, to maintain data quality at the highest level. This report provides observed geometric and radiometric analysis results for Landsats 8 and 9 for quarter 1 (January–March) of 2026. All data used to compile the Cal/Val analysis results presented in this report are freely available from the U.S. Geological Survey EarthExplorer website: https://earthexplorer.usgs.gov . One specific activity that the ECCOE Landsat Cal/Val Team closely monitored was a Landsat 8 Thermal Infrared Sensor encoder alerts anomaly. On March 18, 2026, the Thermal Infrared Sensor instrument’s mechanism control electronics board reset, driving several parameters to default power-on values. Subsequent telemetry and analysis determined that no persistent hardware misconfiguration was present and no radiometric or geometric degradation was observed.

Open-File Report↗

Floods of June 20–July 6, 2024, in the Big Sioux River, Rock River, Little Sioux River, Ocheyedan River, and Floyd River Basins, northwestern Iowa

Major flooding occurred on June 20–July 6, 2024, in northwestern Iowa affecting the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd River Basins. Heavy rain fell in northwestern Iowa, southwestern Minnesota, and southeastern South Dakota on June 20–22, 2024. Parts of northwestern Iowa recorded 2–6 inches of rainfall and localized amounts exceeding 12 inches. A maximum peak-of-record streamflow of 175,000 cubic feet per second at the U.S. Geological Survey streamgage Big Sioux River at Akron, Iowa (06485500), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at four locations along the Big Sioux River between U.S. Interstate 29 at Sioux City, Iowa, upstream to Iowa Highway 10 north of Hawarden, Iowa, a distance of 75.7 river miles. A maximum peak-of-record streamflow of 157,000 cubic feet per second at the U.S. Geological Survey streamgage Rock River near Rock Valley, Iowa (06483500), was recorded on June 22, 2024, and had an annual exceedance probability of less than 0.2 percent. High-water marks were measured at eight locations along the Rock River between County Road B30 east of Hudson, South Dakota, upstream to Iowa Highway 9 at Rock Rapids, Iowa, a distance of 39.3 river miles. A maximum peak-of-record streamflow of 63,000 cubic feet per second at the U.S. Geological Survey streamgage Little Sioux River at Correctionville, Iowa (06606600), was recorded on June 24, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at 11 locations along the Little Sioux River between Iowa Highway 31 west of Correctionville, Iowa, upstream to U.S. Highway 18 north of Spencer, Iowa, a distance of 134.8 river miles. A maximum streamflow of 24,500 cubic feet per second at the U.S. Geological Survey streamgage Ocheyedan River near Spencer, Iowa (06605000), was recorded on June 22, 2024, and had an annual exceedance probability range of 0.2–0.49 percent. High-water marks were measured at three locations along the Ocheyedan River between County Road M38 west of Spencer, Iowa, upstream to U.S. Highway 18 west of Everly, Iowa, a distance of 12.8 river miles. A maximum streamflow of 41,000 cubic feet per second at the U.S. Geological Survey streamgage Floyd River at Alton, Iowa (06600100), was recorded on June 22, 2024, and had an annual exceedance probability range of 1–1.99 percent. High-water marks were measured at six locations along the Floyd River between Iowa Highway 3 at Le Mars, Iowa, upstream to Iowa Highway 10 at Alton, Iowa, a distance of 27.5 river miles. The high-water marks were used to develop flood profiles for the Big Sioux, Rock, Little Sioux, Ocheyedan, and Floyd Rivers.

Iowa, Minnesota, South Dakota↗