Search USGSSearch

USGS · 70279243

Evolution of arsenic speciation during thermal treatment simulating wildfire heating in arsenic-rich sediments

Abstract

Understanding arsenic transformations during wildfires can help better constrain the environmental impacts of increased wildfire intensity, frequency, and burned area. Previous studies have monitored the evolution of metal(loid) speciation at specific time/temperature endpoints, hampering the comprehension of the dynamic transformations of metal(loid)s during wildfires. Here, a novel approach, namely in situ time-resolved X-ray absorption near edge structure (TR-XANES) spectroscopy, was used for the first time to monitor the heat-induced redox transformations of arsenic (As) in two As-rich sediments with different characteristics. No arsenic transformations were observed in either sediment at room temperature or when the sediments were heated to a maximum temperature of 400 ºC. When heated to a maximum temperature of 600 or 700 ºC, As underwent complex, dynamic, and partially reversible redox transformations, the extent of which varied with sediment properties, initial As speciation, and heating temperature and duration. In the case of sediments initially containing As(V) and a low sulfide/sulfate ratio, the As(V) was reduced to As(III) over a short period of time, followed by immediate reoxidation of As(III) to As(V). The extent of the transient As reduction increased with increasing maximum temperature. The final As speciation at the end of the heating experiment was not substantially different from that at the beginning of the experiment. In contrast, in sediments that were best described by a more complex combination of reference compounds (As(V) coprecipitated with or adsorbed on iron oxide, arseniosiderite, arsenopyrite) with a high sulfide/sulfate ratio, As(V) phases were reduced to As(III) and As(III) was further reduced to As(-I) (at 700 ºC, only), followed by delayed reoxidation of As(-I) to As(III) (at 700 ºC, only) and reoxidation of As(III) to As(V). Approximately 9% and 26% of all As remained as As(III) ( i.e., was not reoxidized to As(V)) at the end of the experiment when heated to a maximum temperature of 600 and 700 ºC, respectively, which is higher than the relative abundance of As(III) in the native sediment. These fire-induced As transformations can potentially enhance As mobilization to surface water and groundwater, posing risks to environmental and human health.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 39.1977753° to 39.2085582274284° latitude; -121.0471968° to -121.03897428455141° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

BibTeXRIS

Mohammed Baalousha, Morgane Desmau, Andrea L. Foster. 2026-08-18. Evolution of arsenic speciation during thermal treatment simulating wildfire heating in arsenic-rich sediments. https://doi.org/10.1016/j.jhazmat.2026.143271

Cite the original work for its findings. Save a collection to share your selection of sources.

Discover connections

Connections use source metadata and explicit phrase matches, not verified experimental comparisons.

KEEP EXPLORING

Related USGS reports

Uncertainty reduction for subaerial landslide-tsunami hazards

Subaerial rock slopes may generate a tsunami by rapidly moving into the water. Large uncertainty in landslide characteristics propagates into large uncertainty in tsunami hazard, making hazard assessment more difficult for land and emergency managers. Once a potentially tsunamigenic landslide is identified, it may not be clear which landslide characteristics contribute most significantly to uncertainty in the tsunami hazard. Our aim is to document the relative worth of different landslide characteristics (e.g., size, material properties) for reducing uncertainty in landslide-tsunami hazard assessments. Isolating the relative importance of specific landslide characteristics may inform prioritization of data collection and improve efficiency in understanding hazard. To accomplish this, we generated a set of 288 landslide-tsunami simulations in which we systematically varied the size and material properties of possible failure extents at the Barry Arm landslide complex in northwestern Prince William Sound, Alaska, USA. We find that for landslides smaller than the receiving waterbody, the landslide volume has the strongest effect on resulting wave characteristics and thus the highest leverage on reducing uncertainty in tsunami hazard. In contrast, for landslides substantially larger than the waterbody, the duration of rapid movement of the landslide has the highest leverage. Based on our results, we propose a classification scheme for subaerial landslides based on the relative size of the landslide and waterbody. Additionally, our results support the generation of a tsunami height transfer function between existing tide gages and a nearby coastal city. These results have direct implications for the practice of operational early warning.

Alaska

Timescales of surface faulting preservation in low-strain intraplate regions from landscape evolution modeling and the geomorphic and historical record

Large surface-rupturing intraplate earthquakes in stable continental regions (SCRs) are uncommon globally and have recurrence intervals of thousands to hundreds of thousands of years based on the paleoseismic and geomorphic record, challenging accurate active fault identification in these regions. To constrain the timescales of preservation for scarps created by surface ruptures from dip-slip earthquakes, we use a two-dimensional scarp diffusion model for typical intraplate settings and explore which parameters influence fault scarp preservation. These parameters include the coseismic vertical surface offset, the recurrence interval of similar magnitude earthquakes, diffusivity (as a proxy for mean annual precipitation rate), and the erodibility of the surficial material. We constrain parameter ranges from a compilation of historical surface ruptures in intraplate settings in a variety of climates, including the Central and Eastern United States, Australia, Europe, Central Asia (Mongolia, China), India, and West Africa. The timescales of scarp preservation from landscape evolution modeling agree well with observations of scarp preservation in low-strain SCR and intraplate tectonic settings, with some notable exceptions for Australian scarps. We find that the erodibility of the surficial material and earthquake recurrence interval have a stronger effect on the timescales of scarp preservation than diffusivity or coseismic vertical surface offset. Our model results may aid in identifying and characterizing subtle, slow-moving active faults in low-strain SCR and intraplate tectonic settings for different tectonic, geomorphic, and climatic characteristics. Accurate fault locations and characterization from the landscape record has implications for both probabilistic seismic and fault displacement hazard analyses.

Journal of Geophysical Research Solid Earth

3D viscoelastic models of slip-deficit rate along the Cascadia subduction zone

Interseismic deformation in the Pacific Northwest is constrained by the horizontal crustal velocity field derived from the Global Positioning System (GPS) in addition to vertical rates derived from GPS, leveling, and tide gauge measurements. Such measurements were folded in to deformation models of fault slip rates as part of the 2023 National Seismic Hazard Model (NSHM) update. Here I build upon one of the contributing models, the viscoelastic earthquake-cycle model of Pollitz [2022]. This model permits inclusion of effects of time-dependent viscoelastic relaxation within earthquake cycles (i.e., ‘ghost transients’) and laterally variable elastic and/or ductile material properties. I lever-age these capabilities to incorporate the Cascadia megathrust into Western U.S.-wide deformation models in which crustal fault slip rates are estimated simultaneously with slip deficit rates along the interplate boundary between the descending Juan de Fuca plate and North American plate. This effort includes construction of a margin-wide model of viscoelastic structure founded on the Slab 2.0 model and probes different models of the ductile properties of the surrounding oceanic asthenosphere, continental lower crust, and mantle asthenosphere. This results in new estimates of the distribution of slip deficit rate along the ∼ 1000 km long margin, highlights the importance of correcting for glacial-isostatic adjustment effects, and permits assessment of sensitivity of results to assumed ductile properties.

California, Oregon, Washington