Search USGSSearch

USGS · 70241526

Forecasting explosions at Sinabung Volcano, Indonesia, based on SO2 emission rates

Abstract

Dome-building volcanic eruptions are often associated with frequent Vulcanian explosions, which constitute a substantial threat to proximal communities. One proposed mechanism driving such explosions is the sealing of the shallow volcanic system followed by pressurization due to gas accumulation beneath the seal. We investigate this hypothesis at Sinabung Volcano (Sumatra, Indonesia), which has been in a state of eruption since August 2010. In 2013, the volcano began erupting a lava dome and lava flow, and frequent explosions produced eruptive columns that rose many kilometers into the atmosphere and at times sent pyroclastic density currents down the southeast flanks. A network of scanning Differential Optical Absorption Spectrometers (DOAS) was installed on the volcano’s eastern flank in 2016 to continuously monitor SO 2 emission rates during daytime hours. Analysis of the DOAS data from October 2016 to September 2017 revealed that passive SO 2 emissions were generally lower in the 5 days leading up to explosive events (∼100 t/d) than was common in 5-day periods leading up to days on which no explosions occurred (∼200 t/d). The variability of passive SO 2 emissions, expressed as the standard deviation, also took on a slightly wider range of values before days with explosions (0–103 t/d at 1-sigma) than before days without explosions (43–117 t/d). These observations are consistent with the aforementioned seal-failure model, where the sealing of the volcanic conduit blocks gas emissions and leads to pressurization and potential Vulcanian explosions. We develop a forecasting methodology that allows calculation of a relative daily explosion probability based solely on measurements of the SO 2 emission rate in the preceding days. We then calculate forecast explosion probabilities for the remaining SO 2 emissions dataset (October 2017—September 2021). While the absolute accuracy of forecast explosion probabilities is variable, the method can inform the probability of an explosion occurring relative to that on other days in each test period. This information can be used operationally by volcano observatories to assess relative risk. The SO 2 emissions-based forecasting method is likely applicable to other open vent volcanoes experiencing dome-forming eruptions.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Syegi Kunrat, Christoph Kern, Hilma Alfianti, Allan Lerner. 2022-09-12. Forecasting explosions at Sinabung Volcano, Indonesia, based on SO2 emission rates. https://doi.org/10.3389/feart.2022.976928

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Pliocene (Piacenzian) planktic foraminiferal biogeography: Insights into how planktic biogeography is linked to climate and socioeconomic impacts on marine ecosystems

The Piacenzian Age (3.60–2.58 Ma) of the Pliocene Epoch was characterized by globally warmer climates, higher sea levels, and atmospheric CO 2 similar to present. Utilizing a robust dataset of 2,101 samples and over 637,000 foraminifer specimens from 77 deep-sea core sites worldwide, we document planktic foraminifer biogeography and biodiversity during the mid-Piacenzian Warm Period (mPWP). Cluster analysis and multidimensional scaling reveal five major bioregions: tropical, warm subtropical, transitional, polar, and a distinct North Atlantic polar bioregion. Each bioregion was dominated by characteristic species with well-established temperature preferences. Analyses demonstrate higher species richness and evenness in low and mid-latitudes, with increased diversity associated with periods of climatic warming and poleward expansion of warm water assemblages. The long-term stability of biogeographic patterns underscores ecological conservatism but also highlights potential vulnerability to rapid anthropogenic climate change. Our findings emphasize the critical role of planktic foraminifers in reconstructing past ocean conditions and offer valuable insights into links between planktic biogeography, climate, and socioeconomic impacts on marine ecosystems. This work advances our understanding of marine ecosystem responses to climate extremes and provides a foundation for future regional and temporal analyses of planktic foraminifer biogeography under global change scenarios.

Frontiers in Earth Science

Estimation of dynamic geologic CO2 storage resources in the Illinois Basin, including effects of brine extraction, anisotropy, and hydrogeologic heterogeneity

Since the vast majority of carbon dioxide (CO 2 ) storage resources in the United States are in deep saline aquifers, optimizing the use of these saline storage resources could be crucial for efficient development of geologic CO 2 storage (GCS) resources and basin- or larger-scale deployment of GCS in the country. Maximum CO 2 injection rates can be enhanced by extracting brine from the CO 2 storage unit. However, disposal of the extracted brine is both a technological and economic challenge. The lowest-cost option would likely be reinjection of the extracted brine into another formation above or below the CO 2 storage unit. Therefore, it is important to estimate brine injectivity as it will constrain the potential to increase CO 2 injectivity at an injection site that has access to multiple geologic storage units where either CO 2 or brine can be injected. Using a simulation-optimization framework, coupled with a non-isothermal, multiphase CO 2 -water-salt equation-of-state module, we developed a computationally efficient method for evaluating optimization of simultaneous CO 2 injection, brine extraction, and brine (re)injection at hypothetical injection sites deployed across a geologic basin. The Illinois basin is ideal for testing our methodology because it contains multiple geologic storage units with seals in between them to isolate injection of CO 2 in one unit from interfering with the injection of either brine or CO 2 in another unit above or below it. In addition, we investigated the relative effects of variation in key geologic parameters as well as two reservoir structures (hydrogeologic heterogeneity/anisotropy and homogeneity/isotropy) on CO 2 injectivities and enhancement of CO 2 injectivity through extracting brine. Results suggest that permeability, depth, and especially thickness of the storage unit could be the most influential parameters determining CO 2 injectivity. They also suggest that only injecting CO 2 into the storage unit with the greatest injectivity, enhancing that unit’s injectivity by extracting brine, and disposing of the produced brine in other suitable units could maximize total CO 2 injectivity in limited regions of the basin. At the majority of simulated injection sites, however, we found that injecting CO 2 into all of the accessible and suitable storage units was more likely to maximize the CO 2 storage resource.

Illinois, Kentucky, Indiana

An exploration of the relative influence of physical models for Omori’s law

Omori’s law states that the rate of aftershocks decays as a function of inverse time. There are multiple physical explanations that we reduce into a nonlinear mixed effects relation of three terms: (1) a Rate/State expression that can account for static/dynamic and viscoelastic triggering caused directly by the mainshock, (2) a fluid diffusion triggering term, and (3) a randomized secondary triggering (cascade) term. We fit free physical-model parameters to an observed aftershock sequence through two nonlinear regression methods to find the relative contributions of physics-based models in an observed aftershock sequence. Results from both methods show that Rate/State models overpredict aftershock rates by ∼0–30%. Secondary aftershocks cause a net negative contribution (seismicity rate reduction that corrects overprediction by other terms) ranging between ∼0 and 30%. All regression solutions yield negative secondary triggering contributions without being guided to do so. A physical explanation for this is that aftershock occurrence relieves stress from the crust, ultimately causing the sequence to extinguish itself. Fluid diffusion triggering contributions range from ∼0 to 20%. Diffusion processes are observed to be shorter in time than the full duration of an aftershock sequence and they are also spatially limited, diminishing their influence. Our results apply to an aftershock decay curve from the 2016 Central Apennines earthquake sequence, meaning that our specific results may not be general. Our primary conclusion is that any one physical model cannot alone fit the observed sequence as well as the combination of three we investigated.

Frontiers in Earth Science