Search USGS⌕ Search

USGS · 70201568

Conductivity response to intraplate deformation: Evidence for metamorphic devolatilization and crustal‐scale fluid focusing

Abstract

We present two‐dimensional electrical resistivity models of two 40 km magnetotelluric (MT) profiles across the Frome Embayment to the east of the northern Flinders Ranges, South Australia. The lower crust shows low resistivity of 10 Ω m at around 30 km depth. The middle crust is dominated by resistive (>1000 Ω m) basement rocks underlying the Flinders Ranges. Adjacent to the ranges, conductive lower crust is connected to vertical zones of higher conductivity extending to just below the brittle‐ductile transition at ∼10 km depth. The conductive zones narrow in the brittle upper crust and dip at roughly 45° beneath the surface. Zones of enhanced conductivity coincide with higher strain due to topographic loading and sparse seismicity. We propose that fluids are generated through neotectonic metamorphic devolatilization. Low‐resistivity zones display areas of fluid pathways along either preexisting faults or an effect of crustal compression leading to metamorphic fluid generation. The lower crustal conductors are responding to long‐wavelength flexure‐induced strain, while the upper crustal conductors are responding to short wavelength faulting in the brittle regime. MT is a useful tool for imaging crustal strain in response to far‐field stresses in an intraplate setting and provides important constraints for geodynamic modeling and crustal rheology.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: -30.75° to -29.75° latitude; 138.75° to 140° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Stephan Thiel, Paul Soeffky, Lars Krieger, Klaus Regenauer-Lieb, Jared R. Peacock, Graham Heinson. 2016-11-15. Conductivity response to intraplate deformation: Evidence for metamorphic devolatilization and crustal‐scale fluid focusing. https://doi.org/10.1002/2016gl071351

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Evolution of summit magma pressure during the 2018 caldera collapse at Kılauea volcano

We utilized geodetic data from the 16 May to 4 August 2018 caldera collapse sequence to refine the geometries and pressure evolution of two summit reservoirs at Kīlauea volcano: the shallower Halema‘uma‘u (HMM) and deeper South Caldera (SC) reservoirs. We modeled magma reservoirs as pressurized spheroidal cavities and constrained reservoir geometries with Global Positioning System (GPS) and Interferometric Synthetic Aperture Radar displacements. Inverting high-rate GPS and borehole tilt time series recovered time-dependent reservoir pressure changes and caldera ring fault shear stress. During the collapse sequence, the HMM reservoir accommodated episodic, co-collapse pressure increases of 1.9 MPa (median) and a net 5.8 MPa (median) decrease. Simultaneously, the SC reservoir underwent monotonic depressurization of 6.7 MPa (median). Negligible co-collapse pressure changes in the SC reservoir imply it was not exclusively supplying magma to the eruption vent. These results provide a coherent view of magma reservoir pressure evolution during the 2018 eruption.

Hawaii↗

EMIT reveals elevated calcite signatures in shorelines of Lake Powell and Lake Mead exposed by drought and Colorado River management

Nearly half of Earth’s seasonal freshwater storage variability occurs in human-managed reservoirs, resulting in large areas of reservoir-bed that are episodically inundated or subaerially exposed. Here we use hyperspectral data from NASA’s Earth Surface Mineral Dust Source Investigation (EMIT) mission to map calcite mineral assemblages across exposed surfaces in two large U.S. reservoirs, Lake Mead and Lake Powell. Results show distinct patterns in the occurrence of carbonate, clay, and mica minerals. Reservoir-deposited sediments exhibited significantly higher calcite proportions than adjacent, lithologically similar, non-inundated terrestrial surfaces. These differences likely reflect hydrologically-driven calcite precipitation, wherein warm, clear, productive reservoir waters drive calcium carbonate out of solution. We also detect reductions in calcite proportions in areas of the shoreline disturbed by human recreation. EMIT's imaging capabilities enable rapid, high-resolution mineralogical inventories across vast areas where field sampling is infeasible. We find EMIT is a scalable tool for monitoring geochemical changes associated with large water level fluctuations.

Arizona, Nevada, Utah↗

First application of a coastal-dune model (AeoLiS) to simulate fluvial-aeolian morphodynamics

Quantifying aeolian processes is important to decision-making in river management and for optimizing strategies for ecosystem conservation, natural resource management, and recreation. We applied the AeoLiS aeolian transport model, originally developed for coastal environments, to a dryland river corridor to evaluate its ability to simulate sediment dynamics in a fluvial-aeolian system. The model reproduced spatial and temporal patterns of geomorphic change at a Grand Canyon sandbar, including aeolian dune formation, observed in field data. The model effectively captured trends in observed sediment movement in the spring and summer months. Thus, despite assuming a single grain-size, static vegetation, and not directly accounting for variable sediment supply from fluvial sources, the model performs well at capturing aeolian processes in a complex fluvial-aeolian system. AeoLiS demonstrates strong potential for dryland river applications and management, due to its flexibility and compatibility with coupled modeling frameworks.

Arizona↗