Search USGS⌕ Search

USGS · 70200830

Using science to inform management and improve biological conservation in the Desert Renewable Energy Conservation Plan

Abstract

The Mojave and Colorado deserts of southern California have been viewed as vast wilderness since early exploration and, until recently, were considered the most untrammeled among western landscapes in the contiguous lower 48 states (United States Department of Agriculture 1893; Leu et al. 2008). However, the factors that define desert wilderness—small human population, temperature differentials that create unrelenting winds, low rainfall, and cloudless skies—are attractive for renewable energy development. The demand for clean, renewable energy is a national and regional priority and has increased demand for large-scale solar and wind farms in the deserts, particularly in California. The need to balance these national and state energy priorities with existing natural resource and land conservation policies has emerged as a landscape-scale land-use planning initiative known as the Desert Renewable Energy Conservation Plan (DRECP). One of the primary goals for the DRECP was to establish Development Focus Areas (DFAs) where high-quality renewable energy potential of up to 20 gigawatts (GW) could be implemented by the year 2040. DFAs were designed to provide expedited project approvals in locations where environmental impacts could be managed and mitigated, and proximity to transmission corridors provides for the efficient dissemination of energy to users. The DRECP also aims to identify protections for natural resources, recreation, and cultural resources. This plan identifies 37 covered species that receive special consideration in the DRECP. Among the special considerations are climate adaptation requirements, such as the ability to maintain population connectivity through wildlife corridors, while protecting several special recreation areas and 32,000 known cultural sites that are dispersed throughout the region. We evaluated several particular aspects of the DRECP design and process. In particular, we examined land designations in relation to published studies on Mohave ground squirrel (Xerospermophilus mohavensis) habitat and genetic diversity patterns of a suite of broadly distributed desert animal species. The squirrel and its habitat are of particular interest because the entire range of the squirrel is encompassed by the DRECP. We describe the framework of the DRECP, provide a case study of how the DRECP accommodates the needs of the Mohave ground squirrel and its habitat, illustrate DFAs in relation to the genetic diversity of a broad range of terrestrial biota, and conclude with some observations on how land-use issues were resolved across the landscape under various scenarios.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Todd Esque, Amy Fesnock-Parker, Brian Croft, Felicia Chen, Amy G. Vandergast. 2017. Using science to inform management and improve biological conservation in the Desert Renewable Energy Conservation Plan. https://pubs.usgs.gov/publication/70200830

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Authoritative knowledge infrastructure for GeoAI: Implications for scientific spatial data providers

Geospatial Artificial Intelligence (GeoAI) increasingly relies on automated analysis of authoritative geospatial data, exposing limitations in data infrastructures originally designed for simple dissemination rather than for knowledge-driven use. From the perspective of scientific spatial data providers, the challenge is enabling GeoAI responsibly while retaining semantic clarity, provenance, reproducibility, and governance. This short paper (i) examines how GeoAI exposed limitations within existing geospatial data infrastructures, and (ii) identifies provider-side requirements for an authoritative knowledge infrastructure. Drawing on GIScience, scientific workflow, and operational AI literature, the paper outlines implications for national mapping organizations that seek to support advanced analytics without jeopardizing scientific rigor or stewardship responsibilities.

Conference Paper↗

Springs of the Catskill Mountains: A conduit flow system in predominantly siliciclastic strata

The Catskill Mountains of New York state are composed of thick sequences of interbedded mudstone, sandstone, and siltstone that are intercalated with thin beds of paludal limestone and calcareous mudstone. Sandstones often contain rip-up clasts of calcareous material at their bases and contain minor amounts of carbonate cement throughout their mass. This minor amount of calcareous material weathers out to produce thin zones of solutional porosity and permeability integrated within perched aquifers that feed perennial hillslope springs. Solutional features are evident within thin carbonate lenses and along fractures in sandstones, occasionally resulting in explorable cave-sized conduits. This study focuses on the behavior of bedrock springs and seeps in the headwaters of the Neversink River basin above the Neversink Reservoir. Bedrock springs are numerous throughout the Catskill Mountains and serve to provide baseflow to the headwater streams that tends to be more persistent during dry times than other baseflow sources. We observed dissolution-influenced conduits within the bedrock, and suffosional conduits within unconsolidated materials. Continuous water temperature at six springs was monitored at hourly intervals from May to October 2022 to investigate the thermal response of groundwater to daily and seasonal changes in air temperature along with event-based meteorological events. Temperature monitoring was augmented at some springs with time-lapse photography to evaluate persistence of flow. The thermal responses of springs to precipitation events were highly variable across sites, with some springs exhibiting flashy responses indicating a strong connection to the surface, while other springs showed muted or no thermal response to events. The seasonal thermal response also varied across sites having lag times of 23-48 days between peak air temperature and peak spring water temperature. The water temperatures and geochemical compositions of these bedrock springs support a conceptual model of multiple residence times, showing both event and seasonal groundwater storage within the conduit flow system that feeds the springs of the Catskill Mountains.

New York↗

Stability changes after weak layer collapse: Insights from an unexpected dataset

While conducting avalanche mitigation or traveling through the backcountry, avalanche professionals sometimes experience a "whumpf": a collapse-mode crack accompanied by surface cracking that does not produce an avalanche. These whumpfs are a clear warning sign of instability in the surrounding terrain. But assessing the collapsed slope itself, if it is steep enough to avalanche, carries much more uncertainty. Can slopes that whumpf and are steep enough to slide still avalanche? The answer to this question supports avalanche mitigators and ski guides in assessing whether to open such slopes. Previous research on collapsed slopes is limited to one study conducted before tests that estimate crack propagation propensity, such as the Propagation Saw Test (PST), were developed. This work showed that weak layer shear strength decreased immediately after collapsing and then increased over time. However, no research has examined crack propagation propensity after a whumpf. Studying propagation propensity is key for assessing how whumpfs immediately affect slope stability. To improve our understanding of changes in propagation propensity following weak layer collapse, we conducted PSTs on a test slope in the hours and days after an unexpected collapse occurred on a layer of surface hoar. Two PSTs at our study site three days prior to this collapse provided an estimate of weak layer propagation propensity. PST cut lengths decreased immediately following the collapse, suggesting that the collapse increased the propagation propensity. However, over the next 4-5 hours, PST cut lengths steadily increased at our site, likely due to ongoing sintering and strengthening in the collapsed weak layer. By the end of day two, we were no longer able to initiate propagation, suggesting substantial stabilization of the weak layer. Our results support prior findings and observations suggesting that slopes may remain capable of producing avalanches immediately after a collapse but likely stabilize over the next day or two. Although this research does not provide answers about precisely when a slope becomes stable after a collapse, it does highlight uncertainties in our understanding and interpretation of the stability of slopes that have whumped.

Montana↗