Relations among pH, sulfate, and metals concentrations in anthracite and bituminous coal-mine discharges, Pennsylvania

III Cravotta

Home/Archive/USGS

USGS · 70189257

Relations among pH, sulfate, and metals concentrations in anthracite and bituminous coal-mine discharges, Pennsylvania

III Cravotta

View original source ↗Export metadata ↓

Abstract

Water-quality data for discharges from 140 abandoned mines in the Bituminous and Anthracite Coalfields of Pennsylvania illustrate relations among pH, sulfate, and dissolved metal concentrations. The pH for the 140 samples ranged from 2.7 to 7.3, with two modes at pH 2.5 to 4 (acidic) and 6 to 7 (near neutral). Generally, flow rates were smaller and solute concentrations were greater for low-pH samples; flow rates increased with pH. Although the pH distribution was similar for the bituminous and anthracite subsets, the bituminous discharges had smaller median flow rates, greater concentrations of sulfate, iron, and aluminum, and smaller concentrations of barium and lead than anthracite discharges with the same pH values. The observed relations between the pH and constituent concentrations can be attributed to (1) dilution of acidic water by alkaline ground water; (2) solubility control of aluminum, iron, manganese, barium, and lead by hydroxide, sulfate, and/or carbonate minerals; and (3) aqueous sulfate-complex formation. The formation of AlSO 4 + and AlHSO 4 +2 complexes adds to the total dissolved aluminum concentration at pH of equilibrium with aluminum hydroxide or hydroxysulfate minerals and can account for 10 to 20 times greater concentrations of dissolved aluminum in bituminous discharges compared to anthracite discharges at similar pH. Sulfate complexation also can account for 10 to 30 times greater concentrations of dissolved ferric iron concentrations at equilibrium with ferrihydrite (Fe(OH) 3 ) and/or schwertmannite (Fe 8 O 8 (OH) 4.5 (SO 4 ) 1.75 ) at pH of 3 to 5. In contrast, lower barium and lead concentrations in bituminous than anthracite discharges indicates elevated sulfate concentration could decrease mobility of these metals by the formation of insoluble minerals such as barite (BaSO 4 ) or anglesite (PbSO 4 ). Most samples were saturated with barite, but none were saturated with anglesite. Hence, lead concentrations could be controlled by coprecipitation with barite and/or by adsorption to schwertmannite or another sulfate-bearing oxide.

Explore related subjects

Conference Paper

Source-reported bounding extent: 39.7198° to 42.26986° latitude; -80.519891° to -74.689516° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

III Cravotta. 2006. Relations among pH, sulfate, and metals concentrations in anthracite and bituminous coal-mine discharges, Pennsylvania. https://pubs.usgs.gov/publication/70189257

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Authoritative knowledge infrastructure for GeoAI: Implications for scientific spatial data providers

Geospatial Artificial Intelligence (GeoAI) increasingly relies on automated analysis of authoritative geospatial data, exposing limitations in data infrastructures originally designed for simple dissemination rather than for knowledge-driven use. From the perspective of scientific spatial data providers, the challenge is enabling GeoAI responsibly while retaining semantic clarity, provenance, reproducibility, and governance. This short paper (i) examines how GeoAI exposed limitations within existing geospatial data infrastructures, and (ii) identifies provider-side requirements for an authoritative knowledge infrastructure. Drawing on GIScience, scientific workflow, and operational AI literature, the paper outlines implications for national mapping organizations that seek to support advanced analytics without jeopardizing scientific rigor or stewardship responsibilities.

Conference Paper↗

USGS2026

Springs of the Catskill Mountains: A conduit flow system in predominantly siliciclastic strata

The Catskill Mountains of New York state are composed of thick sequences of interbedded mudstone, sandstone, and siltstone that are intercalated with thin beds of paludal limestone and calcareous mudstone. Sandstones often contain rip-up clasts of calcareous material at their bases and contain minor amounts of carbonate cement throughout their mass. This minor amount of calcareous material weathers out to produce thin zones of solutional porosity and permeability integrated within perched aquifers that feed perennial hillslope springs. Solutional features are evident within thin carbonate lenses and along fractures in sandstones, occasionally resulting in explorable cave-sized conduits. This study focuses on the behavior of bedrock springs and seeps in the headwaters of the Neversink River basin above the Neversink Reservoir. Bedrock springs are numerous throughout the Catskill Mountains and serve to provide baseflow to the headwater streams that tends to be more persistent during dry times than other baseflow sources. We observed dissolution-influenced conduits within the bedrock, and suffosional conduits within unconsolidated materials. Continuous water temperature at six springs was monitored at hourly intervals from May to October 2022 to investigate the thermal response of groundwater to daily and seasonal changes in air temperature along with event-based meteorological events. Temperature monitoring was augmented at some springs with time-lapse photography to evaluate persistence of flow. The thermal responses of springs to precipitation events were highly variable across sites, with some springs exhibiting flashy responses indicating a strong connection to the surface, while other springs showed muted or no thermal response to events. The seasonal thermal response also varied across sites having lag times of 23-48 days between peak air temperature and peak spring water temperature. The water temperatures and geochemical compositions of these bedrock springs support a conceptual model of multiple residence times, showing both event and seasonal groundwater storage within the conduit flow system that feeds the springs of the Catskill Mountains.

New York↗

USGS2026

Rapid deglaciation of the Tuolumne Meadows region linked to glacier hypsometry

During the LGM deglaciation (19–11 ka), episodes of glacier retreat and stabilization in the western United States are often attributed to abrupt climate change events via changes in Atlantic Meridional Overturning Circulation (e.g., Becker et al. 2025; McGee et al. 2018; Phillips 2016). However, there is considerable variability in the magnitude and timing of glacier retreat across the western US that is difficult to reconcile with a uniform climate forcing (Marcott et al. 2019), indicating either heterogeneous climate change or the influence of local non-climatic variables, such as glacier hypsometry (Young et al. 2011). Prior work from basal lake radiocarbon ages (Gillespie and Clark 2011) and cosmogenic nuclide dating (Phillips 2016; Phillips et al. 2009; Rood et al. 2011) established that Sierra Nevada glaciers receded from LGM moraines to north-facing cirques between 18 and 15 ka, with most deglaciation occurring at 15.8 ± 0.5 ka. As discussed above, geomorphic evidence supports abrupt glacier stagnation and in situ melting in the Tuolumne Meadows region.

Calfiornia↗