Search USGSSearch

USGS · 70156135

Using nuclear magnetic resonance and transient electromagnetics to characterise water distribution beneath an ice covered volcanic crater: The case of Sherman Crater Mt. Baker Washington.

Abstract

Surface and laboratory Nuclear Magnetic Resonance (NMR) measurements combined with transient electromagnetic (TEM) data are powerful tools for subsurface water detection. Surface NMR (sNMR) and TEM soundings, laboratory NMR, complex resistivity, and X-Ray Diffraction (XRD) analysis were all conducted to characterise the distribution of water within Sherman Crater on Mt. Baker, WA. Clay rich rocks, particularly if water saturated, can weaken volcanoes, thereby increasing the potential for catastrophic sector collapses that can lead to far-travelled, destructive debris flows. Detecting the presence and volume of shallow groundwater is critical for evaluating these landslide hazards. The TEM data identified a low resistivity layer (<10 ohm-m), under 60 m of glacial ice related to water saturated clays. The TEM struggles to resolve the presence or absence of a plausible thin layer of bulk liquid water on top of the clay. The sNMR measurements did not produce any observable signal, indicating the lack of substantial accumulated bulk water below the ice. Laboratory analysis on a sample from the crater wall that likely represented the clays beneath the ice confirmed that the controlling factor for the lack of sNMR signal was the fine-grained nature of the media. The laboratory measurements further indicated that small pores in clays detected by the XRD contain as much as 50% water, establishing an upper bound on the water content in the clay layer. Forward modelling of geologic scenarios revealed that bulk water layers as thin as &frac12; m between the ice and clay layer would have been detectable using sNMR. The instrumentation conditions which would allow for sNMR detection of the clay layer are investigated. Using current instrumentation the combined analysis of the TEM and sNMR data allow for valuable characterisation of the groundwater system in the crater. The sNMR is able to reduce the uncertainty of the TEM in regards to the presence of a bulk water layer, a valuable piece of information in hazard assessment.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 48.62110864256238° to 48.89722676235673° latitude; -122.05947875976562° to -121.55548095703125° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Trevor P. Irons, Kathryn Martin, Carol A. Finn, Benjamin R. Bloss, Robert Horton. 2014. Using nuclear magnetic resonance and transient electromagnetics to characterise water distribution beneath an ice covered volcanic crater: The case of Sherman Crater Mt. Baker Washington.. https://doi.org/10.3997/1873-0604.2014009

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Multi-scale geophysical mapping of the brine and bedrock surfaces along the Dolores River, Paradox Valley, Colorado, December 2023

Total dissolved solids derived from salt dome–sourced brine in the underlying alluvial aquifer substantially increase with distance in the reach of the Dolores River that passes through Paradox Valley in southwestern Colorado. The area has been the site of salinity control operations since the 1990s to reduce salt loading to the downstream Colorado River. Previous airborne and ground/water-based electromagnetic (EM) geophysical data have successfully mapped the top of the brine surface, albeit with relatively coarse near-surface resolution and limited spatial coverage. This present December 2023 study used ground-based high-resolution EM and passive seismic (horizontal-to-vertical spectral ratio, HVSR) tools to map in detail the depth and thickness of the brine zone in the alluvial aquifer (top of the brine down to bedrock contact) in areas immediately surrounding the Dolores River where previous airborne EM (AEM) results indicated brine within 10 m of land surface. Results indicate the deepest bedrock is generally associated with the shallowest brine and local depressions in the collapse breccia (caprock to the Paradox Formation salt) may facilitate vertical migration of brine into the alluvial aquifer. Additionally, the ground-based EM mapping corroborated general patterns in depth to brine that were observed in previous AEM results while also revealing additional detail, including suspected focused brine discharge zones to the Dolores River. A river-based survey wherein EM data, channel depth and river water–specific conductance information were collected augmented these findings and indicated specific areas on both the western and eastern sides of the river where focused brine discharge may occur. This study comprises a large-scale, ground- and water-based geophysical mapping effort, including hundreds of HVSR soundings and 100s of kilometres of EM data, which were successfully translated into digital brine and bedrock surfaces that could be incorporated into groundwater modelling efforts, future well siting or other decision-making.

Colorado

Preferential groundwater seepage in karst terrane inferred from geoelectric measurements

The Ellenburger–San Saba aquifer discharges spring flows into the overlying Hamilton Creek bed in Burnet County, central Texas. The aquifer is susceptible to contamination from surface‐water reservoirs because of the presence of dissolution cavities that are hydraulically connected to the reservoirs in some locations. There is concern that preferential groundwater seepage from reservoirs into the aquifer in these locations might ultimately degrade the quality of the springwater that enters Hamilton Creek. To investigate preferential groundwater seepage patterns and hydraulic connectivity between surface‐water reservoirs and the Ellenburger–San Saba aquifer, geophysical reconnaissance surveys were completed between July 2017 and January 2018 to map dissolution cavities and locate preferential groundwater seepage within a specific region of the aquifer. Two‐dimensional electric resistivity tomography and self‐potential profiling were utilized, and a simplified, three‐dimensional finite‐element model of the field site was constructed to provide an interpretive aid. The self‐potential data indicated the occurrence of preferential groundwater seepage through a porous seepage conduit that was imaged by the electric resistivity tomography data but did not indicate the occurrence of groundwater seepage through two fluid‐filled dissolution cavities that were imaged by electric resistivity tomography data. Collectively, the surveying and modelling results demonstrate the efficacy of geoelectric methods for mapping the locations of dissolution cavities and preferential groundwater seepage in the electrically resistive karst terrane of the Ellenburger–San Saba aquifer.

Near Surface Geophysics

Faulting and groundwater in a desert environment: constraining hydrogeology using time-domain electromagnetic data

Within the south-western Mojave Desert, the Joshua Basin Water District is considering applying imported water into infiltration ponds in the Joshua Tree groundwater sub-basin in an attempt to artificially recharge the underlying aquifer. Scarce subsurface hydrogeological data are available near the proposed recharge site; therefore, time-domain electromagnetic (TDEM) data were collected and analysed to characterize the subsurface. TDEM soundings were acquired to estimate the depth to water on either side of the Pinto Mountain Fault, a major east-west trending strike-slip fault that transects the proposed recharge site. While TDEM is a standard technique for groundwater investigations, special care must be taken when acquiring and interpreting TDEM data in a twodimensional (2D) faulted environment. A subset of the TDEM data consistent with a layered-earth interpretation was identified through a combination of three-dimensional (3D) forward modelling and diffusion time-distance estimates. Inverse modelling indicates an offset in water table elevation of nearly 40 m across the fault. These findings imply that the fault acts as a low-permeability barrier to groundwater flow in the vicinity of the proposed recharge site. Existing production wells on the south side of the fault, together with a thick unsaturated zone and permeable near-surface deposits, suggest the southern half of the study area is suitable for artificial recharge. These results illustrate the effectiveness of targeted TDEM in support of hydrological studies in a heavily faulted desert environment where data are scarce and the cost of obtaining these data by conventional drilling techniques is prohibitive.

Near Surface Geophysics