Conceptual models of the formation of acid-rock drainage at road cuts in Tennessee

Mike Bradley; Scott Worland; Tom Byl

Home/Archive/USGS

USGS · 70145260

Conceptual models of the formation of acid-rock drainage at road cuts in Tennessee

Mike Bradley·Scott Worland·Tom Byl

View original source ↗Export metadata ↓

Abstract

Pyrite and other minerals containing sulfur and trace metals occur in several rock formations throughout Middle and East Tennessee. Pyrite (FeS2) weathers in the presence of oxygen and water to form iron hydroxides and sulfuric acid. The weathering and interaction of the acid on the rocks and other minerals at road cuts can result in drainage with low pH (< 4) and high concentrations of trace metals. Acid-rock drainage can cause environmental problems and damage transportation infrastructure. The formation and remediation of acid-drainage from roads cuts has not been researched as thoroughly as acid-mine drainage. The U.S Geological Survey, in cooperation with the Tennessee Department of Transportation, is conducting an investigation to better understand the geologic, hydrologic, and biogeochemical factors that control acid formation at road cuts. Road cuts with the potential for acid-rock drainage were identifed and evaluated in Middle and East Tennessee. The pyrite-bearing formations evaluated were the Chattanooga Shale (Devonian black shale), the Fentress Formation (coal-bearing), and the Precambrian Anakeesta Formation and similar Precambrian rocks. Conceptual models of the formation and transport of acid-rock drainage (ARD) from road cuts were developed based on the results of a literature review, site reconnaissance, and the initial rock and water sampling. The formation of ARD requires a combination of hydrologic, geochemical, and microbial interactions which affect drainage from the site, acidity of the water, and trace metal concentrations. The basic modes of ARD formation from road cuts are; 1 - seeps and springs from pyrite-bearing formations and 2 - runoff over the face of a road cut in a pyrite-bearing formation. Depending on site conditions at road cuts, the basic modes of ARD formation can be altered and the additional modes of ARD formation are; 3 - runoff over and through piles of pyrite-bearing material, either from construction or breakdown material weathered from shale, and 4 - the deposition of secondary-sulfate minerals can store trace metals and, during rainfall, result in increased acidity and higher concentrations of trace metals in storm runoff. Understanding the factors that control ARD formation and transport are key to addressing the problems associated with the movement of ARD from the road cuts to the environment. The investigation will provide the Tennessee Department of Transportation with a regional characterization of ARD and provide insights into the geochemical and biochemical attributes for the control and remediation of ARD from road cuts.

Explore related subjects

Conference Paper

Source-reported bounding extent: 34.94899072578227° to 36.677230602346214° latitude; -87.593994140625° to -81.63940429687499° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Mike Bradley, Scott Worland, Tom Byl. 2015. Conceptual models of the formation of acid-rock drainage at road cuts in Tennessee. https://pubs.usgs.gov/publication/70145260

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Authoritative knowledge infrastructure for GeoAI: Implications for scientific spatial data providers

Geospatial Artificial Intelligence (GeoAI) increasingly relies on automated analysis of authoritative geospatial data, exposing limitations in data infrastructures originally designed for simple dissemination rather than for knowledge-driven use. From the perspective of scientific spatial data providers, the challenge is enabling GeoAI responsibly while retaining semantic clarity, provenance, reproducibility, and governance. This short paper (i) examines how GeoAI exposed limitations within existing geospatial data infrastructures, and (ii) identifies provider-side requirements for an authoritative knowledge infrastructure. Drawing on GIScience, scientific workflow, and operational AI literature, the paper outlines implications for national mapping organizations that seek to support advanced analytics without jeopardizing scientific rigor or stewardship responsibilities.

Conference Paper↗

USGS2026

Springs of the Catskill Mountains: A conduit flow system in predominantly siliciclastic strata

The Catskill Mountains of New York state are composed of thick sequences of interbedded mudstone, sandstone, and siltstone that are intercalated with thin beds of paludal limestone and calcareous mudstone. Sandstones often contain rip-up clasts of calcareous material at their bases and contain minor amounts of carbonate cement throughout their mass. This minor amount of calcareous material weathers out to produce thin zones of solutional porosity and permeability integrated within perched aquifers that feed perennial hillslope springs. Solutional features are evident within thin carbonate lenses and along fractures in sandstones, occasionally resulting in explorable cave-sized conduits. This study focuses on the behavior of bedrock springs and seeps in the headwaters of the Neversink River basin above the Neversink Reservoir. Bedrock springs are numerous throughout the Catskill Mountains and serve to provide baseflow to the headwater streams that tends to be more persistent during dry times than other baseflow sources. We observed dissolution-influenced conduits within the bedrock, and suffosional conduits within unconsolidated materials. Continuous water temperature at six springs was monitored at hourly intervals from May to October 2022 to investigate the thermal response of groundwater to daily and seasonal changes in air temperature along with event-based meteorological events. Temperature monitoring was augmented at some springs with time-lapse photography to evaluate persistence of flow. The thermal responses of springs to precipitation events were highly variable across sites, with some springs exhibiting flashy responses indicating a strong connection to the surface, while other springs showed muted or no thermal response to events. The seasonal thermal response also varied across sites having lag times of 23-48 days between peak air temperature and peak spring water temperature. The water temperatures and geochemical compositions of these bedrock springs support a conceptual model of multiple residence times, showing both event and seasonal groundwater storage within the conduit flow system that feeds the springs of the Catskill Mountains.

New York↗

USGS2026

Rapid deglaciation of the Tuolumne Meadows region linked to glacier hypsometry

During the LGM deglaciation (19–11 ka), episodes of glacier retreat and stabilization in the western United States are often attributed to abrupt climate change events via changes in Atlantic Meridional Overturning Circulation (e.g., Becker et al. 2025; McGee et al. 2018; Phillips 2016). However, there is considerable variability in the magnitude and timing of glacier retreat across the western US that is difficult to reconcile with a uniform climate forcing (Marcott et al. 2019), indicating either heterogeneous climate change or the influence of local non-climatic variables, such as glacier hypsometry (Young et al. 2011). Prior work from basal lake radiocarbon ages (Gillespie and Clark 2011) and cosmogenic nuclide dating (Phillips 2016; Phillips et al. 2009; Rood et al. 2011) established that Sierra Nevada glaciers receded from LGM moraines to north-facing cirques between 18 and 15 ka, with most deglaciation occurring at 15.8 ± 0.5 ka. As discussed above, geomorphic evidence supports abrupt glacier stagnation and in situ melting in the Tuolumne Meadows region.

Calfiornia↗