Search USGSSearch

USGS · 70046831

Geodetic evidence for en echelon dike emplacement and concurrent slow slip during the June 2007 intrusion and eruption at Kilauea volcano, Hawaii

Abstract

A series of complex events at Kīlauea Volcano, Hawaii, 17 June to 19 June 2007, began with an intrusion in the upper east rift zone (ERZ) and culminated with a small eruption (1500 m 3 ). Surface deformation due to the intrusion was recorded in unprecedented detail by Global Positioning System (GPS) and tilt networks as well as interferometric synthetic aperture radar (InSAR) data acquired by the ENVISAT and ALOS satellites. A joint nonlinear inversion of GPS, tilt, and InSAR data yields a deflationary source beneath the summit caldera and an ENE-striking uniform-opening dislocation with ~2 m opening, a dip of ∼80° to the south, and extending from the surface to ~2 km depth. This simple model reasonably fits the overall pattern of deformation but significantly misfits data near the western end of an inferred dike-like source. Three more complex dike models are tested that allow for distributed opening including (1) a dike that follows the surface trace of the active rift zone, (2) a dike that follows the symmetry axis of InSAR deformation, and (3) two en echelon dike segments beneath mapped surface cracks and newly formed steaming areas. The en echelon dike model best fits near-field GPS and tilt data. Maximum opening of 2.4 m occurred on the eastern segment beneath the eruptive vent. Although this model represents the best fit to the ERZ data, it still fails to explain data from a coastal tiltmeter and GPS sites on Kīlauea's southwestern flank. The southwest flank GPS sites and the coastal tiltmeter exhibit deformation consistent with observations of previous slow slip events beneath Kīlauea's south flank, but inconsistent with observations of previous intrusions. Slow slip events at Kīlauea and elsewhere are thought to occur in a transition zone between locked and stably sliding zones of a fault. An inversion including slip on a basal decollement improves fit to these data and suggests a maximum of ~15 cm of seaward fault motion, comparable to previous slow-slip events.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: 19.05835° to 19.54759° latitude; -155.798371° to -155.016307° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

E. K. Montgomery-Brown, D. K. Sinnett, Michael Poland, P. Segall, Tim R. Orr, H. Zebker, Asta Mikijus. 2010-07-13. Geodetic evidence for en echelon dike emplacement and concurrent slow slip during the June 2007 intrusion and eruption at Kilauea volcano, Hawaii. https://doi.org/10.1029/2009jb006658

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Pre-eruptive outgassing and pressurization, and post-fragmentation bubble nucleation, recorded by vesicles in breadcrust bombs from vulcanian activity at Guagua Pichincha Volcano, Ecuador

Breadcrust bombs formed during Vulcanian eruptions are assumed to originate from the shallow plug or dome. Their rim to core texture reflects the competition between cooling and degassing timescales, which results in a dense crust with isolated vesicles contrasting with a highly vesicular vesicle network in the interior. Due to relatively fast quenching, the crust can shed light on pre- and syn-eruptive conditions prior to or during fragmentation, whereas the interior allows us to explore post-fragmentation vesiculation. Investigation of pre- to post-fragmentation processes in breadcrust bombs from the 1999 Vulcanian activity at Guagua Pichincha, Ecuador, via 2D and 3D textural analysis reveals a complex vesiculation history, with multiple, spatially localized nucleation and growth events. Large vesicles (Type 1), present in low number density in the crust, are interpreted as pre-eruptive bubbles formed by outgassing and collapse of a permeable bubble network during ascent or stalling in the plug. Haloes of small, syn-fragmentation vesicles (Type 2), distributed about large vesicles, are formed by pressurization and enrichment of volatiles in these haloes. The nature of the pressurization process in the plug is discussed in light of seismicity and ground deformation signals, and previous textural and chemical studies. A third population (Type 3) of post-fragmentation small vesicles appears in the interior of the bomb, and growth and coalescence of Type 2 and 3 vesicles causes the transition from isolated to interconnected bubble network in the interior. We model the evolution of viscosity, bubble growth rate, diffusion timescales, bubble radius and porosity during fragmentation and cooling. These models reveal that thermal quenching dominates in the crust whereas the interior undergoes a viscosity quench caused by degassing, and that the transition from crust to interior corresponds to the onset of percolation and development of permeability in the bubble network.

Guagua Pichincha Volcano

Strength recovery in quartzite is controlled by changes in friction in experiments at hydrothermal conditions up to 200°C

The rate of fault zone restrengthening between earthquakes can be influenced by both frictional and cohesive healing processes. Friction is dependent on effective normal stress while cohesion is independent of normal stress, potentially explaining—in part—the lack of depth dependence of earthquake stress drops. Although amenable to laboratory testing, few studies have systematically addressed the normal stress dependence of restrengthening rate. This is partially due to difficulty in separating relative contributions of friction and cohesion in recovery of fault strength. We present results from a series of slide-hold-slide tests on thin layers (≤10 𝜇m) of ultrafine quartz gouge that develop during shearing of initially bare-surface quartzite. Tests were conducted at 10 MPa constant pore pressure, 20–200 MPa constant effective normal stress, and temperatures of 22°–200°C. Restrengthening, defined as the difference between peak shear stress measured after resumption of sliding and steady-state sliding shear stress, increases with the log of hold duration. The 200°C healing rate, 0.014 per e-fold increase in time, is comparable to that determined from seismological observations along the Calaveras Fault, California. Construction of Mohr-Coulomb failure envelopes shows that changes in cohesion are small (<1 MPa) and independent of hold durations to 10 5 s, indicating that the increased strength is due to changes in the friction coefficient. These experimental results are inconsistent with the hypothesis that cohesive healing explains the depth independence of earthquake stress drop, but higher temperatures, longer time-scales, and more complex mineralogy could facilitate cohesive healing in natural fault systems.

Journal of Geophysical Research - Solid Earth

Toward next-generation lava flow forecasting: Development of a fast, physics-based lava propagation model

During effusive volcanic crises, the eruption and propagation of lava flows pose a significant hazard to nearby populations, homes, and infrastructure. Consequently, timely lava flow forecasts are a critical need for volcano observatory and emergency management operations. Previous lava flow modeling tools are typically either too slow to produce timely forecasts, or are fast, but lack critical aspects of lava physics or important forecasting outputs. In particular, the strong thermal stratification present in laminar, high-Prandtl number flows has generally been neglected. Bulk rheological changes have previously been computed from cell-averaged temperatures, assuming that the flow is thermally mixed. Here, we detail the development and initial testing of Lava2d, a new two-dimensional depth-averaged finite volume model of lava flow propagation over natural terrain which accounts for bulk rheological changes due to thermorheological stratification. We use a novel approach to energy conservation based on tracking cooling and solidifying at the flow base and at the moving flow surface, allowing for the estimation of more realistic vertical thermorheological profiles, while maintaining computational efficiency, producing very timely model runs. We validate our approach with three examples: comparison with theoretical propagation of crust-dominated lava flows, comparison with a large-scale molten basalt experiment from the Syracuse University Lava Project, and efficiency testing and comparison with the initial phase of the 1984 Mauna Loa lava flows. Our model is shown to produce rapid, realistic forecasts, making it a good candidate for operationalization in active volcanic regions such as in Hawai'i.

Journal of Geophysical Research - Solid Earth