Search USGS⌕ Search

USGS · 70031600

The persistence of directivity in small earthquakes

Abstract

We derive a simple inversion of peak ground acceleration (PGA) or peak ground velocity (PGV) for rupture direction and rupture velocity and then test this inversion on the peak motions obtained from seven 3.5≤ M ≤4.1 earthquakes that occurred in two clusters in November 2002 and February 2003 near San Ramon, California. These clusters were located on two orthogonal strike-slip faults so that the events share the same approximate focal mechanism but not the same fault plane. Three earthquakes exhibit strong directivity, but the other four earthquakes exhibit relatively weak directivity. We use the residual PGAs and PGVs from the other six events to determine station corrections for each earthquake. The inferred rupture directions unambiguously identify the fault plane for the three earthquakes with strong directivity and for three of the four earthquakes with weak directivity. The events with strong directivity have fast rupture velocities (0.63 β ≤ v ≤0.87 β ); the events with weak directivity either rupture more slowly (0.17 β ≤ v ≤0.35 β ) or bilaterally. The simple unilateral inversion cannot distinguish between slow and bilateral ruptures: adding a bilateral rupture component degrades the fit of the rupture directions to the fault planes. By comparing PGAs from the events with strong and weak directivity, we show how an up-dip rupture in small events can distort the attenuation of peak ground motion with distance. When we compare the rupture directions of the earthquakes to the location of aftershocks in the two clusters, we find than almost all the aftershocks of the three earthquakes with strong directivity occur within 70° of the direction of rupture.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

J. Boatwright. 2007. The persistence of directivity in small earthquakes. https://doi.org/10.1785/0120050228

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Re-evaluation of shaking, dynamic strain, and the source of the 1886 Charleston, South Carolina, earthquake

As the largest historical event in the eastern United States, the 1886 Charleston, South Carolina, earthquake, plays a prominent role in our nation’s seismological and human history and an outsized role in our probabilistic ground‐motion hazard estimates, affecting building codes, insurance rates, and geophysical monitoring. Thus, constraining the characteristics of the 1886 earthquake source, as well as the nature of its shaking distribution and impacts to the extent possible, is essential. Given its vintage, however, societal, geological, and geophysical datasets are limited compared with those used in modern seismological analyses. Because of these limitations, some characteristics of the rupture model are fundamentally nonunique. Still, by re‐evaluating all available data, I can constrain several key aspects of this earthquake. I show that several interpretations in recent analyses are inconsistent regarding the inferred source; shaking; ground failure; and, particularly, railway impacts. Importantly, I have shown that although dynamic strain caused the ground failure that led to track deformation, without the intermediate liquefaction step, dynamic strain alone was unlikely to be the source of rail deformation, contrary to earlier studies. Had earlier pronouncements that dynamic strain is a real concern for bending railways held true, there would be serious ramifications for railway engineering as well as for other above‐ and below‐ground linear infrastructure.

South Carolina↗

ETAS-positive: Extracting unbiased epidemic-type aftershock models from incomplete earthquake catalogs

Earthquake catalogs are inherently incomplete, and short-term fluctuations in catalog completeness can strongly bias estimates of seismicity parameters. Here, we extend the positive statistics framework recently introduced for estimating Gutenberg–Richter a and b values to the Epidemic-Type Aftershock Sequence (ETAS) model. The approach focuses on complete magnitude–time intervals defined by pairs of earthquakes in which the second event is larger than the first. Comprehensive synthetic tests demonstrate that the proposed ETAS + method retrieves nearly unbiased parameter estimates even from highly incomplete catalogs, whereas parameters obtained using classical estimation approaches are strongly biased. Application to Southern California reveals a similar trend, with the productivity scaling parameter α approaching the b value, consistent with self-similar earthquake triggering within estimation uncertainties. Owing to its robustness against catalog incompleteness and computational efficiency, the ETAS + method provides a powerful new tool for seismicity analysis and earthquake forecasting.

California↗