Search USGS⌕ Search
Home/Archive/USGS

USGS · 70029106

Engineering geologic and geotechnical analysis of paleoseismic shaking using liquefaction effects: Field examples

R.A. Green·S. F. Obermeier·S.M. Olson
View original source ↗Export metadata ↓

Abstract

The greatest impediments to the widespread acceptance of back-calculated ground motion characteristics from paleoliquefaction studies typically stem from three uncertainties: (1) the significance of changes in the geotechnical properties of post-liquefied sediments (e.g., "aging" and density changes), (2) the selection of appropriate geotechnical soil indices from individual paleoliquefaction sites, and (3) the methodology for integration of back-calculated results of strength of shaking from individual paleoliquefaction sites into a regional assessment of paleoseismic strength of shaking. Presented herein are two case studies that illustrate the methods outlined by Olson et al. [Engineering Geology, this issue] for addressing these uncertainties. The first case study is for a site near Memphis, Tennessee, wherein cone penetration test data from side-by-side locations, one of liquefaction and the other of no liquefaction, are used to readily discern that the influence of post-liquefaction "aging" and density changes on the measured in situ soil indices is minimal. In the second case study, 12 sites that are at scattered locations in the Wabash Valley and that exhibit paleoliquefaction features are analyzed. The features are first provisionally attributed to the Vincennes Earthquake, which occurred around 6100 years BP, and are used to illustrate our proposed approach for selecting representative soil indices of the liquefied sediments. These indices are used in back-calculating the strength of shaking at the individual sites, the results from which are then incorporated into a regional assessment of the moment magnitude, M, of the Vincennes Earthquake. The regional assessment validated the provisional assumption that the paleoliquefaction features at the scattered sites were induced by the Vincennes Earthquake, in the main, which was determined to have M ??? 7.5. The uncertainties and assumptions used in the assessment are discussed in detail. ?? 2004 Elsevier B.V. All rights reserved.

Explore related subjects

Engineering GeologyArticle

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R.A. Green, S. F. Obermeier, S.M. Olson. 2005. Engineering geologic and geotechnical analysis of paleoseismic shaking using liquefaction effects: Field examples. https://doi.org/10.1016/j.enggeo.2004.07.026

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Sackung at Bald Eagle ridge, central Colorado: An updated interpretation of ridge-spreading movement, structures, and mechanisms from 50 years (1975–2025) of U.S. Geological Survey research

Slow gravitational failures of mountain peaks and ridges are poorly understood. Herein, we report on 50 years of studies at a slowly spreading castellate ridge in the Sawatch Range in central Colorado. The orientations of geomorphic-structural features indicate that the fractured Precambrian granitic rock underlying the ridge has extended and spread northwestward toward the formerly glacier-covered Busk Creek valley. Results from surveying, field-based geomorphic-structural mapping using lidar, rock mass quality measurements, a passive seismic survey, and satellite radar provide a major update to research started by U.S. Geological Survey researchers in the 1970s and 1980s. New insights include a recognition that the entire ridge has slowly moved by concurrent sliding along an inferred northwest dipping, compound basal-slip surface (or zone), and through the formation of multiple grabens by normal faulting and flexural toppling along sets of pre-existing fractures that dip moderately (∼45°) to the southeast. We were unable to distinguish the presence of a sudden and strong contrast in seismic velocity across the inferred slip surface. Movement during the 50-year study period has been episodic and gradually decreasing, in correspondence with decreasing cumulative annual precipitation and increasing mean annual air temperatures. The fastest moving area, just upslope from the glacier trimline, had an average horizontal velocity of 3 – 4 mm/yr. Evidence suggests that movement started as a paraglacial response mechanism, but because of the site’s proximity to the Rio Grande Rift, we cannot exclude earthquake shaking as a mechanism for initiation or enhancement of slope movement. An estimate of longer-term horizontal movement from the exposed basal-slip surface at the uphill side of the ridgetop graben is ∼1.1 mm/yr for the 13 – 14 ky post-glacial period. Broad implications of our work are that: (1) long-term measurements (decades or longer) of slope movement can add insights into how sackungen form and evolve through time; (2) the identification of thrust faults and toes in zones of compression near valley bottoms can be crucial for interpreting sackung failure mechanisms, and (3) the use of passive-seismic techniques to identify the depth to a slip surface may not be successful in granitic terrain dominated by planar fractures and subtle changes in rock-mass characteristics.

Colorado↗
USGS2026

From landslide susceptibility to risk assessment in the conterminous U.S.

Understanding the spatial distribution of landslide prone-areas and what consequences they may have is important for risk management and land-use planning. In the United States, although landslides occur in every state, a comprehensive landslide risk assessment is still missing. Existing efforts, such as the Federal Emergency Management Agency (FEMA)’s National Risk Index, rely on aggregated products and coarse cartographic units, limiting their geomorphological and practical accuracy. In this study, we present a methodological advance for landslide risk assessment across large areas with incomplete and sparse data. We apply our procedures to the conterminous United States by integrating geomorphologically meaningful partitions and spatial and temporal probability data-driven models. Landslide susceptibility is estimated using a Generalized Additive Mixed Model incorporating a bias capture/correction scheme to account for inventory inaccuracies (reference Area Under the Curve = 0.75). The exceedance probabilities of landslide occurrence are defined for three temporal scenarios (2, 5, and 10 year). Then, we explore the associated potential economic consequences for human settlements and agricultural areas. The findings indicate that the spatial variability of risk is primarily controlled by exposure rather than by susceptibility/hazard alone. The mean risk increases by ∼170% from the 2-year to the 10-year scenario. Beyond its quantitative outcomes, this study offers a blueprint for continental or sub-continental scale landslide risk assessments, demonstrating both the opportunities and current limitations.

Engineering Geology↗
USGS2025

Global patterns of coseismic landslide runout mobility differ from aseismic landslide trends

Coseismic landslides significantly contribute to human and economic losses during and immediately following earthquakes, yet very little data on the runout of such landslides exist. While well-established behavior of aseismic (e.g., hydrologically triggered) landslide runout mobility suggests strong correlation between landslide size and mobility, limited studies of coseismic landslide runout find conflicting mobility trends. We present a global dataset of runout lengths produced from a new automated method for estimating landslide runout, developed and validated using 1726 manually mapped landslides from five unique earthquakes. We then apply the automated runout tool to 23 global earthquake-induced landslide inventories, producing a compiled database of 73,665 measured and estimated runout lengths of coseismic landslides to assess mobility trends. We find a significant divergence between well-established aseismic mobility trends and that of coseismic landslides, with far greater scatter and more complex mobility patterns in earthquake-triggered landslides. As a function of landslide size, we observe global coseismic landslide mobility patterns are bilinear, becoming increasingly less mobile with increasing size above some threshold. This discordance between aseismic and coseismic landslide mobility may be a function of landslide type, kinematics, hydrology, and or setting that systematically differ between triggering mechanisms and should be explored in more depth to develop predictive models of these unique runout patterns. These results suggest hazard and risk models for coseismic landslides may significantly under-predict or over-predict impacts, depending on the size of triggered landslides.

Engineering Geology↗