Steam injection pilot study in a contaminated fractured limestone (Maine, USA): Modeling and analysis of borehole radar reflection data

C. Gregoire; J.W. Lane; P. K. Joesten

doi:10.1109/agpr.2005.1487846

Home/Archive/USGS

USGS · 70027714

Steam injection pilot study in a contaminated fractured limestone (Maine, USA): Modeling and analysis of borehole radar reflection data

C. Gregoire·J.W. Lane·P. K. Joesten

View original source ↗Export metadata ↓

Abstract

Steam-enhanced remediation (SER) has been successfully used to remove DNAPL and LNAPL contaminants in porous media. Between August and November 2002, SER was tested in fractured limestone at the former Loring Air Force Base, in Maine, USA. During the SER investigation, the U.S. Geological Survey conducted a series of borehole radar surveys to evaluate the effectiveness of radar methods for monitoring the movement of steam and heat through the fractured limestone. The data were collected before steam injection, 10 days after the beginning of injection, and at the end of injection. In this paper, reflection-mode borehole radar data from wells JBW-7816 and JBW-7817A are presented and discussed. Theoretical modeling was performed to predict the variation of fracture reflectivity owed to heating, to show displacement of water and to assess the effect of SER at the site. Analysis of the radar profile data indicates some variations resulting from heating (increase of continuity of reflectors, attenuation of deeper reflections) but no substantial variation of traveltimes. Spectral content analysis of several individual reflections surrounding the boreholes was used to investigate the replacement of water by steam in the fractures. Observed decrease in radar reflectivity was too small to be explained by a replacement of water by steam, except for two high-amplitude reflectors, which disappeared near the end of the injection; moreover, no change of polarity, consistent with steam replacing water, was observed. The decrease of amplitude was greater for reflectors near well JBW-7817A and is explained by a greater heating around this well.

Explore related subjects

Conference Paper

Source-reported bounding extent: 43.059825° to 47.459686° latitude; -71.084334° to -66.950569° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

C. Gregoire, J.W. Lane, P. K. Joesten. 2005. Steam injection pilot study in a contaminated fractured limestone (Maine, USA): Modeling and analysis of borehole radar reflection data. https://doi.org/10.1109/agpr.2005.1487846

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Time-to-depth conversion of seismic-reflection data from eastern Lake Superior and implications for the eastern arm of the Midcontinent Rift

Seismic-reflection data were acquired in the mid 1980s along several lines across eastern Lake Superior by industry and the Great Lakes International Multidisciplinary Program on Crustal Evolution (GLIMPCE) (Fig. 1). The lines form part of a larger network of crossing lines over the entire lake, which can be used to develop three-dimensional geologic models of the Mesoproterozoic Midcontinent Rift that lies below. To better interpret these lines, we developed velocity models to convert seismic reflections versus two-way travel time (TWTT) to reflections versus depth. In addition, the velocity models themselves provide insights into the structure of the Midcontinent Rift by recognizing common velocity ranges for certain rock types (Grauch, 2023).

eastern Lake Superior↗

USGS2026

Revisiting the utility of regional-scale, high-quality geophysical data in mineral exploration - A case study featuring the Mammoth Magnetic Anomaly, Pinal County, Arizona

Regional aeromagnetic surveys passively measure the total magnetic intensity (TMI) and are a foundational tool used in mineral exploration (Airo, 2015). With the increased global demand and the number of critical mineral resources required for manufacturing high-tech devices, developing high-quality, regional-scale geophysical surveys could aid critical mineral exploration efforts and geologic mapping. In 2019, the U. S. Geological Survey launched the Earth Mapping Resources Initiative (Earth MRI) to modernize the geologic and geophysical mapping of regions that have the potential to contain critical mineral resources within the United States. In support of planning Earth MRI geophysical surveys, Drenth and Grauch (2019) defined five aeromagnetic data quality rankings (rank 1 through rank 5) applying them to the airborne geophysical survey inventory of the United States (Johnson et al., 2021). Rank 1 aeromagnetic surveys are of the highest quality, meeting modern standards and allowing best practices for qualitative and quantitative interpretation; whereas rank 5 aeromagnetic surveys are of the lowest quality, being useful only for qualitative interpretation of broad features. Through the Earth MRI effort, 48 high-quality, regional-scale rank 1 and 2 airborne magnetic and radiometric geophysical surveys have been planned, collected, or publicly release through May 2025 (U. S. Geological Survey, 2025). Here, a portion of a rank 1 Earth MRI aeromagnetic survey in southeast Arizona is presented and compared to a legacy rank 5 aeromagnetic survey over the Mammoth Magnetic Anomaly (MMA), demonstrating how modern, high-quality aeromagnetic data improves our view of crustal geology, aiding mineral exploration.

Arizona↗

USGS2026

Early Miocene volcanic rocks and associated tectonics, Lava Hills and southern Bristol Mountains, California

Volcanic rocks of latest Oligocene to early Miocene age form an east-west belt across part of the central eastern Mojave Desert from the Whipple Mountains on the east to the Rosamond Hills on the west. We term this the central belt because it is separated from northern and southern belts by swaths with no volcanic rocks. Limited geochronologic data indicate that much of the belt is latest Oligocene and early Miocene in age, about 24 to 19 Ma, a finding that is consistent with these rocks being overlain by the 18.8 Ma Peach Spring Tuff in many places. We describe Miocene geology in a central area of the belt, in the Lava Hills, southern Bristol Mountains, and southern Old Dad Mountains. Sedimentary basins formed coeval with early andesite to rhyolite volcanism, progressing from fluvial and lacustrine tuffaceous sandstone to volcanic lavas, tuffs, and breccias, indicating that early basins formed proximal to volcanic edifices. Higher strata are fluvial and lacustrine with lavas punctuating the sequence. Although basins may partly have been formed within topographic lows bounded by volcanic domes, plateaus, and stratovolcanoes, consistent stratigraphic sections over wide areas indicate that tectonic basin evolution affected broad areas. The volcanic section is capped by local basalt flows and the regional Peach Spring Tuff. Limited data on normal faults support interpretations of early extensional basin development caused by northeast-southwest oriented stretching. Later extension caused stratal rotations, tilting early deposits down to the southwest. This tilted and subsequently beveled basin architecture was overlain by the youngest volcanic deposits, primarily rhyolite and basalt. The Peach Spring Tuff, 18.8 Ma, lies within this upper unit. Similar stratigraphic and structural relations are exposed in the nearby Marble Mountains and Van Winkle Mountain sections, reinforcing that a broad area underwent similar volcanism and tectonism. In our study area the upper unit is only very gently tilted except near dextral strike-slip faults of the eastern California shear zone. These late Miocene to Recent faults are represented as four main fault zones spaced about 5 km apart, representing distributed shear north of the Bristol Lake basin.

California↗