Search USGS⌕ Search

USGS · 70024045

Plant community composition and biomass in Gulf Coast Chenier Plain marshes: Responses to winter burning and structural marsh management

Abstract

Many marshes in the Gulf Coast Chenier Plain, USA, are managed through a combination of fall or winter burning and structural marsh management (i.e., levees and water control structures; hereafter SMM). The goals of winter burning and SMM include improvement of waterfowl and furbearer habitat, maintenance of historic isohaline lines, and creation and maintenance of emergent wetlands. Although management practices are intended to influence the plant community, effects of these practices on primary productivity have not been investigated. Marsh processes, such as vertical accretion and nutrient cycles, which depend on primary productivity may be affected directly or indirectly by winter burning or SMM. We compared Chenier Plain plant community characteristics (species composition and above- and belowground biomass) in experimentally burned and unburned control plots within impounded and unimpounded marshes at 7 months (1996), 19 months (1997), and 31 months (1998) after burning. Burning and SMM did not affect number of plant species or species composition in our experiment. For all three years combined, burned plots had higher live above-ground biomass than did unburned plots. Total above-ground and dead above-ground biomasses were reduced in burned plots for two and three years, respectively, compared to those in unburned control plots. During all three years, belowground biomass was lower in impounded than in unimpounded marshes but did not differ between burn treatments. Our results clearly indicate that current marsh management practices influence marsh primary productivity and may impact other marsh processes, such as vertical accretion, that are dependent on organic matter accumulation and decay.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

S.W. Gabrey, A. D. Afton. 2001. Plant community composition and biomass in Gulf Coast Chenier Plain marshes: Responses to winter burning and structural marsh management. https://doi.org/10.1007/s002670010149

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Assessing low-dose copper treatment for dreissenid mussels: Effects on nontarget organisms

Zebra mussels ( Dreissena polymorpha ), an invasive dreissenid mussel, have been established and caused considerable effects in many North American aquatic ecosystems. In response, copper-based pesticides have been used to manage zebra mussel populations. We evaluated the effects of a low-dose (60 µg Cu/L for 10 d) copper-based molluscicide for zebra mussel suppression on nontarget species in Lake Minnetonka (Minnesota, USA). Specifically, we assessed changes in four fish species, a native mussel species, adult zebra mussels, chlorophyll-a concentrations (as a proxy for phytoplankton productivity), the zooplankton community, and the benthic invertebrate community before and after treatment. Chlorophyll- a concentration increased in both the treated and reference bays 1 and 4 d posttreatment. Non-target zooplankton community composition changed in both bays over the course of this study; zooplankton abundance and diversity initially decreased in the treated bay but gradually recovered and was back to pretreatment and reference bay levels after one year. We observed no significant differences in non-target benthic invertebrate abundance or diversity between the treated and reference bays, although abundance and diversity estimates were dynamic and uncertain. Among caged non-target organisms, copper bioaccumulation was higher in both mussel species than in fish, and among fish, was highest in fathead minnow ( Pimephales promelas ). These findings contribute to our understanding of the potential effects of copper-based pesticides on aquatic ecosystems and provide insights for zebra mussel management.

Minnesota↗

Assessing a low-dose copper treatment for dreissenid mussels: Effects on zebra mussel (Dreissena polymorpha) population

We conducted and evaluated a low-dose copper treatment (applied as EarthTec QZ) to suppress zebra mussel ( Dreissena polymorpha Pallas 1771) veliger abundance and settlement in a 66.3 ha bay in Lake Minnetonka (Hennepin County, MN) over a 3-y period. We maintained a mean (standard deviation [SD]) concentration of 83.0 (10.3) µg/L as copper over the 10-d treatment period, much lower than the maximum allowable 1 mg/L as copper. Veliger density was reduced from 6.0 veligers/L before treatment to 0.3 veligers/L following the treatment period. Posttreatment zebra mussel settlement was 1900 times lower in the treated bay compared to an untreated bay days after the treatment despite similar pretreatment veliger densities. Veliger density and settlement remained suppressed nearly 2 y following the treatment. Sampling for adult zebra mussels within the treated bay returned variable results but survival of caged adult zebra mussels indicated ~30% treatment-related mortality. Copper in surface waters returned to near pretreatment concentrations 90 d after treatment. Our study demonstrates that low-dose applications of a copper molluscicide can effectively reduce zebra mussel veliger densities and settlement.

Minnesota↗

Lessons learned from a hybrid approach to collecting user feedback on coastal science products

Science products play a critical role in assisting environmental decision-makers to manage coastal systems; yet there are challenges to developing products that align with needs of end-users. By combining aspects of usability testing and contextual inquiry methods, we describe a hybrid approach for collecting user feedback, especially applicable within the federal government context. This paper presents results of this hybrid testing approach on two of U.S. Geological Survey’s science products, the Coastal Change Likelihood (CCL) and Hazard Exposure Reporting and Analytics (HERA). Both science products synthesize coastal hazard exposure at different geographies and scales. By comparing two science products in different stages of development, we identify common usability issues across both products; the importance of defining a target audience; requested functionalities beyond the products’ scope; and the effect of previous stakeholder engagement on how testers describe technical issues and barriers. Results from user feedback contribute to understanding needs and barriers of coastal decision-makers for science product development. This paper broadens the understanding of environmental decision-makers in the science product development cycle, and how social dimensions can be integrated in project design through iteratively working with end-users and product developers. Further, we present general lessons in usability for development cycles and how these lessons can inform development of actionable science products in coastal management.

Environmental Management↗