Search USGS⌕ Search

USGS · 70021434

Stress drop for three M∼4.3-4.7 (1992-1994) Parkfield, CA, earthquakes

Abstract

In a previous paper (Fletcher and Spudich, 1998) we determined the slip distribution for the three M∼4.3 to 4.7 Parkfield events that occurred between Oct. 20, 1992 and Dec. 20, 1994. The rupture characteristics of these events are of particular interest because they are the largest events to occur at Parkfield since the 1966 mainshock. To further investigate the rupture process of these events, we compute the static stress change or stress drop caused by the slip using a boundary integral method from Quin and Das (1989) adapted for the forward modeling case of computing stresses from a static slip distribution. We find that the initial phase at or very near the hypocenter has the largest stress change in all cases. This peak has a value of about 3.8 MPa for the Oct. 20, 1992 event (which also has the smallest magnitude of the three at 4.3) and about 45 MPa for the other Nov. 14, 1993 and 60 MPa for the Dec. 20, 1994 event. The rest of the stress release is comparatively small and smooth for the Nov. 14, 1993 event, which is the deepest event and the most impulsive. The pattern of stress release of the other two events (Oct. 20, 1992 and Dec. 20, 1994) is more complex with a greater spatial extent. The spatial distribution of stress is approximately similar to the spatial distribution of slip, but with the larger initial peak in stress drop at the hypocenter.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Joe B. Fletcher, Mariagiovanna Guatteri. 1999. Stress drop for three M∼4.3-4.7 (1992-1994) Parkfield, CA, earthquakes. https://doi.org/10.1029/1999gl900392

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Evolution of summit magma pressure during the 2018 caldera collapse at Kılauea volcano

We utilized geodetic data from the 16 May to 4 August 2018 caldera collapse sequence to refine the geometries and pressure evolution of two summit reservoirs at Kīlauea volcano: the shallower Halema‘uma‘u (HMM) and deeper South Caldera (SC) reservoirs. We modeled magma reservoirs as pressurized spheroidal cavities and constrained reservoir geometries with Global Positioning System (GPS) and Interferometric Synthetic Aperture Radar displacements. Inverting high-rate GPS and borehole tilt time series recovered time-dependent reservoir pressure changes and caldera ring fault shear stress. During the collapse sequence, the HMM reservoir accommodated episodic, co-collapse pressure increases of 1.9 MPa (median) and a net 5.8 MPa (median) decrease. Simultaneously, the SC reservoir underwent monotonic depressurization of 6.7 MPa (median). Negligible co-collapse pressure changes in the SC reservoir imply it was not exclusively supplying magma to the eruption vent. These results provide a coherent view of magma reservoir pressure evolution during the 2018 eruption.

Hawaii↗

EMIT reveals elevated calcite signatures in shorelines of Lake Powell and Lake Mead exposed by drought and Colorado River management

Nearly half of Earth’s seasonal freshwater storage variability occurs in human-managed reservoirs, resulting in large areas of reservoir-bed that are episodically inundated or subaerially exposed. Here we use hyperspectral data from NASA’s Earth Surface Mineral Dust Source Investigation (EMIT) mission to map calcite mineral assemblages across exposed surfaces in two large U.S. reservoirs, Lake Mead and Lake Powell. Results show distinct patterns in the occurrence of carbonate, clay, and mica minerals. Reservoir-deposited sediments exhibited significantly higher calcite proportions than adjacent, lithologically similar, non-inundated terrestrial surfaces. These differences likely reflect hydrologically-driven calcite precipitation, wherein warm, clear, productive reservoir waters drive calcium carbonate out of solution. We also detect reductions in calcite proportions in areas of the shoreline disturbed by human recreation. EMIT's imaging capabilities enable rapid, high-resolution mineralogical inventories across vast areas where field sampling is infeasible. We find EMIT is a scalable tool for monitoring geochemical changes associated with large water level fluctuations.

Arizona, Nevada, Utah↗

First application of a coastal-dune model (AeoLiS) to simulate fluvial-aeolian morphodynamics

Quantifying aeolian processes is important to decision-making in river management and for optimizing strategies for ecosystem conservation, natural resource management, and recreation. We applied the AeoLiS aeolian transport model, originally developed for coastal environments, to a dryland river corridor to evaluate its ability to simulate sediment dynamics in a fluvial-aeolian system. The model reproduced spatial and temporal patterns of geomorphic change at a Grand Canyon sandbar, including aeolian dune formation, observed in field data. The model effectively captured trends in observed sediment movement in the spring and summer months. Thus, despite assuming a single grain-size, static vegetation, and not directly accounting for variable sediment supply from fluvial sources, the model performs well at capturing aeolian processes in a complex fluvial-aeolian system. AeoLiS demonstrates strong potential for dryland river applications and management, due to its flexibility and compatibility with coupled modeling frameworks.

Arizona↗