Upper Mississippi embayment shallow seismic velocities measured in situ

Huaibao P. Liu; Y. Hu; J. Dorman; T.-S. Chang; J.-M. Chiu

doi:10.1016/s0013-7952(97)00009-4

Home/Archive/USGS

USGS · 70019683

Upper Mississippi embayment shallow seismic velocities measured in situ

Huaibao P. Liu·Y. Hu·J. Dorman·T.-S. Chang·J.-M. Chiu

View original source ↗Export metadata ↓

Abstract

Vertical seismic compressional- and shear-wave (P- and S-wave) profiles were collected from three shallow boreholes in sediment of the upper Mississippi embayment. The site of the 60-m hole at Shelby Forest, Tennessee, is on bluffs forming the eastern edge of the Mississippi alluvial plain. The bluffs are composed of Pleistocene loess, Pliocene-Pleistocene alluvial clay and sand deposits, and Tertiary deltaic-marine sediment. The 36-m hole at Marked Tree, Arkansas, and the 27-m hole at Risco, Missouri, are in Holocene Mississippi river floodplain sand, silt, and gravel deposits. At each site, impulsive P- and S-waves were generated by man-made sources at the surface while a three-component geophone was locked downhole at 0.91-m intervals. Consistent with their very similar geology, the two floodplain locations have nearly identical S-wave velocity (VS) profiles. The lowest VS values are about 130 m s-1, and the highest values are about 300 m s-1 at these sites. The shear-wave velocity profile at Shelby Forest is very similar within the Pleistocene loess (12m thick); in deeper, older material, VS exceeds 400 m s-1. At Marked Tree, and at Risco, the compressional-wave velocity (VP) values above the water table are as low as about 230 m s-1, and rise to about 1.9 km s-1 below the water table. At Shelby Forest, VP values in the unsaturated loess are as low as 302 m s-1. VP values below the water table are about 1.8 km s-1. For the two floodplain sites, the VP/VS ratio increases rapidly across the water table depth. For the Shelby Forest site, the largest increase in the VP/VS ratio occurs at ???20-m depth, the boundary between the Pliocene-Pleistocene clay and sand deposits and the Eocene shallow-marine clay and silt deposits. Until recently, seismic velocity data for the embayment basin came from earthquake studies, crustal-scale seismic refraction and reflection profiles, sonic logs, and from analysis of dispersed earthquake surface waves. Since 1991, seismic data for shallow sediment obtained from reflection, refraction, crosshole and downhole techniques have been obtained for sites at the northern end of the embayment basin. The present borehole data, however, are measured from sites representative of large areas in the Mississippi embayment. Therefore, they fill a gap in information needed for modeling the response of the embayment to destructive seismic shaking.

Explore related subjects

Engineering Geology Article

Source-reported bounding extent: 33.06203275778296° to 37.82101966464191° latitude; -92.22604064609834° to -87.56783752109824° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

Huaibao P. Liu, Y. Hu, J. Dorman, T.-S. Chang, J.-M. Chiu. 1997. Upper Mississippi embayment shallow seismic velocities measured in situ. https://doi.org/10.1016/s0013-7952(97)00009-4

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2026

Sackung at Bald Eagle ridge, central Colorado: An updated interpretation of ridge-spreading movement, structures, and mechanisms from 50 years (1975–2025) of U.S. Geological Survey research

Slow gravitational failures of mountain peaks and ridges are poorly understood. Herein, we report on 50 years of studies at a slowly spreading castellate ridge in the Sawatch Range in central Colorado. The orientations of geomorphic-structural features indicate that the fractured Precambrian granitic rock underlying the ridge has extended and spread northwestward toward the formerly glacier-covered Busk Creek valley. Results from surveying, field-based geomorphic-structural mapping using lidar, rock mass quality measurements, a passive seismic survey, and satellite radar provide a major update to research started by U.S. Geological Survey researchers in the 1970s and 1980s. New insights include a recognition that the entire ridge has slowly moved by concurrent sliding along an inferred northwest dipping, compound basal-slip surface (or zone), and through the formation of multiple grabens by normal faulting and flexural toppling along sets of pre-existing fractures that dip moderately (∼45°) to the southeast. We were unable to distinguish the presence of a sudden and strong contrast in seismic velocity across the inferred slip surface. Movement during the 50-year study period has been episodic and gradually decreasing, in correspondence with decreasing cumulative annual precipitation and increasing mean annual air temperatures. The fastest moving area, just upslope from the glacier trimline, had an average horizontal velocity of 3 – 4 mm/yr. Evidence suggests that movement started as a paraglacial response mechanism, but because of the site’s proximity to the Rio Grande Rift, we cannot exclude earthquake shaking as a mechanism for initiation or enhancement of slope movement. An estimate of longer-term horizontal movement from the exposed basal-slip surface at the uphill side of the ridgetop graben is ∼1.1 mm/yr for the 13 – 14 ky post-glacial period. Broad implications of our work are that: (1) long-term measurements (decades or longer) of slope movement can add insights into how sackungen form and evolve through time; (2) the identification of thrust faults and toes in zones of compression near valley bottoms can be crucial for interpreting sackung failure mechanisms, and (3) the use of passive-seismic techniques to identify the depth to a slip surface may not be successful in granitic terrain dominated by planar fractures and subtle changes in rock-mass characteristics.

Colorado↗

USGS2026

From landslide susceptibility to risk assessment in the conterminous U.S.

Understanding the spatial distribution of landslide prone-areas and what consequences they may have is important for risk management and land-use planning. In the United States, although landslides occur in every state, a comprehensive landslide risk assessment is still missing. Existing efforts, such as the Federal Emergency Management Agency (FEMA)’s National Risk Index, rely on aggregated products and coarse cartographic units, limiting their geomorphological and practical accuracy. In this study, we present a methodological advance for landslide risk assessment across large areas with incomplete and sparse data. We apply our procedures to the conterminous United States by integrating geomorphologically meaningful partitions and spatial and temporal probability data-driven models. Landslide susceptibility is estimated using a Generalized Additive Mixed Model incorporating a bias capture/correction scheme to account for inventory inaccuracies (reference Area Under the Curve = 0.75). The exceedance probabilities of landslide occurrence are defined for three temporal scenarios (2, 5, and 10 year). Then, we explore the associated potential economic consequences for human settlements and agricultural areas. The findings indicate that the spatial variability of risk is primarily controlled by exposure rather than by susceptibility/hazard alone. The mean risk increases by ∼170% from the 2-year to the 10-year scenario. Beyond its quantitative outcomes, this study offers a blueprint for continental or sub-continental scale landslide risk assessments, demonstrating both the opportunities and current limitations.

Engineering Geology↗

USGS2025

Global patterns of coseismic landslide runout mobility differ from aseismic landslide trends

Coseismic landslides significantly contribute to human and economic losses during and immediately following earthquakes, yet very little data on the runout of such landslides exist. While well-established behavior of aseismic (e.g., hydrologically triggered) landslide runout mobility suggests strong correlation between landslide size and mobility, limited studies of coseismic landslide runout find conflicting mobility trends. We present a global dataset of runout lengths produced from a new automated method for estimating landslide runout, developed and validated using 1726 manually mapped landslides from five unique earthquakes. We then apply the automated runout tool to 23 global earthquake-induced landslide inventories, producing a compiled database of 73,665 measured and estimated runout lengths of coseismic landslides to assess mobility trends. We find a significant divergence between well-established aseismic mobility trends and that of coseismic landslides, with far greater scatter and more complex mobility patterns in earthquake-triggered landslides. As a function of landslide size, we observe global coseismic landslide mobility patterns are bilinear, becoming increasingly less mobile with increasing size above some threshold. This discordance between aseismic and coseismic landslide mobility may be a function of landslide type, kinematics, hydrology, and or setting that systematically differ between triggering mechanisms and should be explored in more depth to develop predictive models of these unique runout patterns. These results suggest hazard and risk models for coseismic landslides may significantly under-predict or over-predict impacts, depending on the size of triggered landslides.

Engineering Geology↗