Search USGS⌕ Search

USGS · 70019027

Calibration of GOES-VISSR, visible-band satellite data and its application to the analysis of a dust storm at Owens Lake, California

Abstract

As part of a joint Russian/American dust-storm experiment, GOES-VISSR (Geostationary Operational Environmental Satellite, Visible-Infrared Spin-Scan Radiometer), data from a visible-band satellite image of a large dust storm emanating from Owens Lake, California were acquired on March 10 and 11, 1993. The satellite data were calibrated to targets of known ground reflectance factors and processed with radiative transfer techniques to yield aerosol (dust) optical depth at those stages of the dust storm when concurrent ground-based measurements of optical depth were made. Calibration of the satellite data is crucial for comparing surficial changes in remotely sensed data acquired over a period of time from the same area and for determining accurate concentrations of atmospheric aerosols using radiative transfer techniques. The calibration procedure forces the distribution of visible-band, DN (digital number) values, acquired on July 1, 1992, at 1731 GMT from the GOES-VISSR sensor over a large test area, to match the distribution of visible-band, DN values concurrently acquired from a Landsat MSS (Multispectral Scanner) sensor over the same test area; the Landsat MSS DN values were directly associated with reflectance factors measured from ground targets. The calibrated GOES-VISSR data for July 1, 1992, were then used to calibrate other GOES-VISSR data acquired on March 10 and 11, 1993, during the dust storm. Uncertainties in location of ground targets, bi-directional reflectance and atmospheric attenuation contribute an error of approximately ±0.02 in the satellite-inferred ground reflectance factors. On March 11 at 1031 PST the satellite-received radiances during the peak of the storm were 3 times larger than predicted by our radiative transfer model for a pure clay dust plume of infinite optical depth. This result supported ground-based measurements that the plume at that time was composed primarily of large salt grains, probably sodium sulfate, which could not be properly characterized in our radiative transfer model. Further, the satellite data showed that the salt fell out of the plume within 35 km from the source. Finer-grained, clay dust was observed to extend beyond the salt-laden plume and was the major component of the dust plume after 1131 PST, when erosion of the salt crust on Owens Lake ceased. By 1331 and 1401 PST satellite-inferred, optical depths compared favorably with measurements concurrently acquired at the ground. Uncertainties in bi-directional reflectance, atmospheric attenuation, and locating ground points in the satellite data manifest errors between the inferred and measured optical depths in the range of 20 to 50%; these errors would be much greater without the calibration of the GOES-VISSR data. Changes in satellite-inferred reflectance factors over the lake bed during the course of the storm showed that 76 km 2 of the surface was disrupted during the March 11 storm, suggesting as much as 76 × 10 3 m 3 of crustal material were displaced for each millimeter of several estimated to have been moved during the storm; an unknown fraction of the displaced material was suspended. The satellite data also showed dust fallout on mountain snowfields. Whereas fallout may have removed most of the salt, satellite data acquired at 1631 PST, when the plume had a large brightness contrast with the ground, showed that it covered over 2500 km 2 and contained at least 1.6 × 10 9 g of sediment. For such a small source area, the dust represents a substantial contribution to the regional and global load of aerosols.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

D. J. MacKinnon, P.S. Chavez, R. S. Fraser, T.C. Niemeyer, Dale A. Gillette. 1996. Calibration of GOES-VISSR, visible-band satellite data and its application to the analysis of a dust storm at Owens Lake, California. https://doi.org/10.1016/0169-555x(95)00105-e

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

The influence of riparian zone grazing on channel stability in an arroyo

The introduction of large herds of domesticated grazing animals by European immigrants in the late 19th century is one primary hypothesis used to explain the initiation of arroyo cutting in the American West. But studies designed to quantify the effects of grazing on watershed hydrology and sedimentation have had conflicting results that are often scale dependent. We used a before-and-after study design to examine effects of changes in cattle grazing practices on channel stability in Muddy Creek, an arroyo in the Colorado River headwaters. We digitized 620 meander loop cutoff geometries in the alluvial bottom of Muddy Creek and used meander loop cutoff rate as a broad measure of channel stability. Poisson regression modeling indicated that the change in grazing practices caused an order-of-magnitude decrease in meander loop cutoff rate that was independent of other forcings. Repeat measurements of channel geometry showed a decline in bankfull channel width of about 40% after the changes were implemented. Increases in riparian vegetation density are deduced to be the primary mechanism for the increase in channel stability. Prior to the changes in grazing practices, at least one meander loop cutoff occurred each year, some of which were large enough to create headcuts that scale with the depth of downcutting in this arroyo system. Our analysis demonstrates the profound effects that different grazing practices have on channel stability in headwater arroyo systems, and the potential for grazing animals to initiate a cascade of sediment yields to receiving stream networks.

Colorado, Utah, Wyoming↗

Revisiting the geochronology of late Quaternary marine terraces and uplift rates in coastal Santa Barbara County, California, USA

In several early studies, central California marine terraces between Santa Barbara and Point Conception were interpreted to record sea-level high stands of the last interglacial complex, ∼80 ka to ∼120 ka (marine isotope stage [MIS] 5). These ages and their elevations (∼20 m to ∼45 m) indicate modest rates of tectonic uplift, similar to those from other localities in southern and central California. A recent study, using a combination of luminescence and radiocarbon dating, has challenged the older age interpretations, implying much younger terrace ages, between ∼40 ka and ∼55 ka (MIS 3). From these new ages and a considerably lower sea level during MIS 3, much higher rates of tectonic uplift are inferred. In the present study, new uranium-series ages of terrace corals and amino acid age estimates of terrace mollusks were determined to test these competing interpretations. With the exception of a low-elevation terrace in Isla Vista (near Santa Barbara) that dates to MIS 3, terraces farther west are interpreted to date to MIS 5 and imply tectonic uplift rates of 0.20–0.34 m/kyr. A compilation of data for the region yields a decreasing rate of late Quaternary uplift from east, near Ventura, to west, near Point Conception. This trend is interpreted to reflect a decreasing influence of the processes of compression and crustal shortening south of the Big Bend in the San Andreas fault.

California↗

Toward an efficient framework for remote sensing of river bathymetry: Comparing sensors and algorithms on an inaccessible proglacial river in Alaska

Remote sensing can provide reliable information on river depths and this approach might be particularly valuable in areas that are difficult to survey via conventional field methods. In this study, we assessed the potential to map the bathymetry of an inaccessible proglacial river in Alaska from both aerial orthophotos and a multispectral satellite image. In addition, we evaluated a variety of depth retrieval algorithms with different input data requirements, including some methods that require field measurements of water depth for calibration and other techniques that can be applied even when such field data are not available. These approaches might enable more efficient use of remote sensing methods by resource management agencies. Our results suggest that bathymetric mapping along the turquoise-colored river we examined was not only feasible but highly accurate ( R 2 up to 0.94) for both types of image data. Algorithms that use paired observations of depth and reflectance to train depth retrieval models were the most accurate, with errors on the order of 15%–20% and little or no bias. Alternative techniques based on hydraulic and statistical concepts also led to strong agreement between predicted and observed depths but were more susceptible to systematic biases toward under- or over-estimation of depth. In contrast to clear-flowing streams, bathymetric mapping in this environment was enabled by a direct relationship between the depth and brightness of the water due to scattering by suspended sediment. In selecting an appropriate depth retrieval method, a compromise might need to be reached between the level of field effort invested and the accuracy of the resulting image-derived bathymetry. Standalone software for implementing these techniques is freely available.

Alaska↗