Search USGSSearch

USGS · 70019004

Environmental Isotope Characteristics of Landfill Leachates and Gases

Abstract

The isotopic characteristics of municipal landfill leachate and gases (carbon dioxide and methane) are unique relative to the aqueous and gaseous media in most other natural geologic environments. The δ 13 C of the CO 2 in landfills is significantly enriched in 13 C, with values as high as +20 ‰ reported. The δ 13 C and δD values of the methane fall within a range of values representative of microbial methane produced primarily by the acetate-fermentation process. The δD of landfill leachate is strongly enriched in deuterium, by approximately 30 ‰ to nearly 60 ‰ relative to local average precipitation values. This deuterium enrichment is undoubtedly due to the extensive production of microbial methane within the limited reservoir of a landfill. The concentration of the radiogenic isotopes, 14 C and 3 H, are significantly elevated in both landfill leachate and methane. The 14 C values range between approximately 120 and 170 pMC and can be explained by the input of organic material that was affected by the increased 14 C content of atmospheric CO2 caused by atmospheric testing of nuclear devices. The tritium measured in leachate, however, is often too high to be explained by previous atmospheric levels and must come from material buried within the landfill. The unique isotopic characteristics observed in landfill leachates and gases provide a very useful technique for confirming whether contamination is from a municipal landfill or some other local source.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Keith C. Hackley, Chao-Li Liu, D.D. Coleman. 2005-08-04. Environmental Isotope Characteristics of Landfill Leachates and Gases. https://doi.org/10.1111/j.1745-6584.1996.tb02077.x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Computing flow-field distortion coefficients from well-construction and formation properties

Direct measurements of groundwater velocity made with borehole flowmeters in screened wells must be compensated for the effects of flow-field distortion (also known as borehole acceleration). A theoretical equation developed by Drost et al. (1968) and simple inputs describing hydraulic properties of well construction and geologic formation were programmed into an Excel workbook to facilitate computation by groundwater-flowmeter users. Tables describing the physical and hydraulic properties for well constructions and gravel pack media are provided with an example to facilitate use of the workbook. Groundwater flowlines converge or diverge as they pass from a geologic formation, through a gravel pack and well screen. The extent of flowline convergence or divergence and the value of the flow-field distortion coefficient is related to the relative changes in hydraulic conductivity of the well screen, gravel pack, and geologic formation. Convergence or divergence is accompanied by acceleration or deceleration of groundwater. Direct measurements of groundwater velocity at the center of the monitoring well can be adjusted to provide a more accurate estimate of velocity in the formation by applying a correction for flow-field distortion. Variables required to compute the flow-field distortion coefficient include the hydraulic conductivity of the gravel pack, well screen, and the geologic formation surrounding the well screen; the borehole radius, and the inside radius and outside radius of the well screen.

Groundwater

Deep groundwater total dissolved solids mapping in the Dakota Group, Williston Basin, USA

Growing concern about the quantity of available freshwater around the world has led to interest in surveying groundwater total dissolved solids (TDS) below water well depths. Deep TDS has not been systematically mapped, and there is much to learn about the distribution and controls on deeper groundwater. In sedimentary basins across the United States, groundwater resources often overlie hydrocarbon resources, providing an opportunity to use borehole geophysical data collected for hydrocarbons to characterize groundwater and pore space resources. This study adapts a recently developed subsurface geostatistical and geophysical modeling approach to continuously map groundwater TDS, porosity, and temperature in the Dakota Group of the Williston Basin—an undercharacterized regional aquifer system overlying deeper hydrocarbon reservoirs. Groundwater TDS in the Dakota Group ranges from approximately 4800 to 26,900 mg/L. TDS patterns are stratified with higher TDS in the lower and upper Dakota Group, and relatively lower TDS in the middle Dakota Group. The lower TDS in the middle zone may represent a preferential regional flow path for lower-TDS meteoric recharge from the west. The alternating pattern of TDS may also be evidence of higher-TDS inflows into the Dakota Group from underlying and potentially from overlying aquifers. Porosity is lower near the center of the Williston Basin and tends to be higher to the east, which may be related to grain size distributions. The new regional TDS and porosity modeling serves as a quantitative reference for water users and provides supporting evidence for hypotheses on Dakota Group recharge.

Montana, North Dakota, South Dakota