Search USGS⌕ Search

USGS · 70018708

Stress perturbation associated with the Amazonas and other ancient continental rifts

Abstract

The state of stress in the vicinity of old continental rifts is examined to investigate the possibility that crustal structure associated with ancient rifts (specifically a dense rift pillow in the lower crust) may modify substantially the regional stress field. Both shallow (2.0–2.6 km depth) breakout data and deep (20–45 km depth) crustal earthquake focal mechanisms indicate a N to NNE maximum horizontal compression in the vicinity of the Paleozoic Amazonas rift in central Brazil. This compressive stress direction is nearly perpendicular to the rift structure and represents a ∼75° rotation relative to a regional E‐W compressive stress direction in the South American plate. Elastic two‐dimensional finite element models of the density structure associated with the Amazonas rift (as inferred from independent gravity modeling) indicate that elastic support of this dense feature would generate horizontal rift‐normal compressional stresses between 60 and 120 MPa, with values of 80–100 MPa probably most representative of the overall structure. The observed ∼75° stress rotation constrains the ratio of the regional horizontal stress difference to the rift‐normal compressive stress to be between 0.25 and 1.0, suggesting that this rift‐normal stress may be from 1 to 4 times larger than the regional horizontal stress difference. A general expression for the modification of the normalized local horizontal shear stress (relative to the regional horizontal shear stress) shows that the same ratio of the rift‐normal compression relative to the regional horizontal stress difference, which controls the amount of stress rotation, also determines whether the superposed stress increases or decreases the local maximum horizontal shear stress. The potential for fault reactivation of ancient continental rifts in general is analyzed considering both the local stress rotation and modification of horizontal shear stress for both thrust and strike‐slip stress regimes. In the Amazonas rift case, because the observed stress rotation only weakly constrains the ratio of the regional horizontal stress difference to the rift‐normal compression to be between 0.25 and 1.0, our analysis is inconclusive because the resultant normalized horizontal shear stress may be reduced (for ratios >0.5) or enhanced (for ratios <0.5). Additional information is needed on all three stress magnitudes to predict how a change in horizontal shear stress directly influences the likelihood of faulting in the thrust‐faulting stress regime in the vicinity of the Amazonas rift. A rift‐normal stress associated with the seismically active New Madrid ancient rift may be sufficient to rotate the horizontal stress field consistent with strike‐slip faults parallel to the axis of the rift, although this results in a 20–40% reduction in the local horizontal shear stress within the seismic zone. Sparse stress data in the vicinity of the seismically quiescent Midcontinent rift of the central United States suggest a stress state similar to that of New Madrid, with the local horizontal shear stress potentially reduced by as much as 60%. Thus the markedly different levels of seismic activity associated with these two subparallel ancient rifts is probably due to other factors than stress perturbations due to dense rift pillows. The modeling and analysis here demonstrate that rift‐normal compressive stresses are a significant source of stress acting on the lithosphere and that in some cases may be a contributing factor to the association of intraplate seismicity with old zones of continental extension.

Explore related subjects

90° N90° S · 180° W ← longitude → 180° E
Source-reported bounding extent: -33.76838° to 5.24449° latitude; -73.98724° to -34.72999° longitude. This indicates report coverage, not an exact sampling location. View area on OpenStreetMap.

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Mary Lou Zoback, Randall W. Richardson. 1996-03-10. Stress perturbation associated with the Amazonas and other ancient continental rifts. https://doi.org/10.1029/95jb03256

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

High-resolution InSAR reveals localized pre-eruptive deformation inside the crater of Agung Volcano, Indonesia

During a volcanic crisis, high-rate, localized deformation can indicate magma close to the surface, with important implications for eruption forecasting. However, only a few such examples have been reported, because frequent, dense monitoring is needed. High-resolution Synthetic Aperture Radar (SAR) is capable of achieving <1 m spatial resolution and sub-weekly revisit times, but is under-used. Here we use high-resolution satellite SAR imagery from COSMO-SkyMed, TerraSAR-X, and Sentinel-1 to detect intra-crater uplift preceding the November 2017 onset of eruptive activity at Agung, Indonesia. Processing the SAR imagery with an up-to-date, accurate, high-resolution digital elevation model was crucial for preventing aliasing of the deformation signal and for accurate georeferencing. We show that >15 cm of line-of-sight shortening occurred over a 400-by-400 m area on the crater floor in September-October 2017, accompanying a deep seismic swarm and flank dyke intrusion. We attribute the deformation to the pressurization of a shallow (<200 m deep) hydrothermal system by the injection of magmatic gases and fluids. We also observe a second pulse of intra-crater deformation of 3–5 cm within 4 days to 11 hr prior to the first phreatomagmatic eruption, which is consistent with interaction between the hydrothermal system and the ascending magma. This phreatomagmatic eruption created the central pathway used during the final stages of magma ascent. Our observations have important implications for understanding unrest and eruption forecasting, and demonstrate the potential of monitoring with high-resolution SAR.

Agung Volcano, Bali↗

Identification of seismo-volcanic regimes at Whakaari/White Island (New Zealand) via systematic tuning of an unsupervised classifier

We present an algorithm based on Self-Organizing Maps (SOM) and k-means clustering to recognize patterns in a continuous 12.5-year tremor time series recorded at Whakaari/White Island volcano, New Zealand (hereafter referred to as Whakaari). The approach is extendable to a variety of volcanic settings through systematic tuning of the classifier. Hyperparameters are evaluated by statistical means, yielding a combination of “ideal” SOM parameters for the given data set. Extending from this, we applied a Kernel Density Estimation approach to automatically detect changes within the observed seismicity. We categorize the Whakaari seismic time series into regimes representing distinct volcano-seismic states during recent unrest episodes at Whakaari (2012/2013, 2016, and 2019). There is a clear separation in classification results between background regimes and those representing elevated levels of unrest. Onset of unrest is detected by the classifier 6 weeks before the August 2012 eruption, and ca. 3.5 months before the December 2019 eruption, respectively. Regime changes are corroborated by changes in commonly monitored tremor proxies as well as with reported volcanic activity. The regimes are hypothesized to represent diverse mechanisms including: system pressurization and depressurization, degassing, and elevated surface activity. Labeling these regimes improves visualization of the 2012/2013 and 2019 unrest and eruptive episodes. The pre-eruptive 2016 unrest showed a contrasting shape and nature of seismic regimes, suggesting differing onset and driving processes. The 2016 episode is proposed to result from rapid destabilization of the shallow hydrothermal system, while rising magmatic gases from new injections of magma better explain the 2012/2013 and 2019 episodes.

Whakaari, White Island↗

Microgravity change during the 2008-2018 Kı̄lauea summit eruption: Nearly a decade of subsurface mass accumulation

Results from nine microgravity campaigns from Kı̄lauea, Hawaiʻi, spanning most of the volcano's 2008–2018 summit eruption, indicate persistent mass accumulation at shallow levels. A weighted least squares approach is used to recover microgravity results from a network of benchmarks around Kı̄lauea's summit, eliminate instrumental drift, and restore suspected data tares. A total mass of 1.9 × 10 11 kg was determined from these microgravity campaigns to have accumulated below Kı̄lauea Caldera during 2009–2015 at an estimated depth of 1.3 km below sea level. Only a fraction of this mass is reflected in surface deformation, and this is consistent with previously reported discrepancies between subsurface mass accumulation and observed surface deformation. The discrepancy, amongst other independent evidence from gas emissions, seismicity, and continuous gravimetry, indicate densification of magma in the reservoirs below the volcano summit. This densification may have been driven by degassing through the summit vent. It is hypothesized that during the final years of the summit eruption, magma densification resulted in a buildup of pressure in the reservoirs that may have contributed to the lower East Rift Zone outbreak of 2018. The observed mass accumulation beneath Kı̄lauea could not have been detected through other techniques and illustrates the importance of microgravity measurements in volcano monitoring.

Hawai'i↗