Search USGS⌕ Search

USGS · 70016170

Equivalent strike-slip earthquake cycles in half-space and lithosphere-asthenosphere earth models

Abstract

By virtue of the images used in the dislocation solution, the deformation at the free surface produced throughout the earthquake cycle by slippage on a long strike-slip fault in an Earth model consisting of an elastic plate (lithosphere) overlying a viscoelastic half-space (asthenosphere) can be duplicated by prescribed slip on a vertical fault embedded in an elastic half-space. For the case in which each earthquake ruptures the entire lithosphere (thickness H ), the half-space equivalent slip rate is as follows: Depth interval 0- H , slip identical to that in lithosphere-asthenosphere model (i.e., abrupt coseismic slip and no subsequent slip); depth interval (2 n −1) H to (2 n +1)H ( n = 1,2,…), slip rate uniform in space and dependent upon time as F n ( t ) exp (− t /τ a ) where F n is a ( n - 1) degree polynomial in t , τ a is twice the asthenosphere relaxation time (η/μ), and t is measured from the instant after the preceding earthquake. The slip rate averaged over the seismic cycle in each depth interval equals the secular rate of relative plate motion. For reasonable values of τ a , slip rates below 5 H do not vary much from that mean value and can be treated as constant. Thus the surface deformation due to the earthquake cycle in the lithosphere-asthenosphere model can be calculated very simply from the half-space model with time-dependent slip in the two depth intervals H −3 H and 3 H −5 H , and uniform slip at a rate equal to the secular relative plate velocity below depth 5 H . Inversion of 1973–1988 geodetic measurements of deformation across the segment of the San Andreas fault in the Transverse Ranges north of Los Angeles for the half-space equivalent slip distribution suggests no significant slip on the fault above 30 km and a uniform slip rate of 36 mm/yr below 30 km. One equivalent lithosphere-asthenosphere model would have a 30-km thick lithosphere and an asthenosphere relaxation time greater than 33 years, but other models are possible.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

J.C. Savage. 2012-09-20. Equivalent strike-slip earthquake cycles in half-space and lithosphere-asthenosphere earth models. https://doi.org/10.1029/jb095ib04p04873

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Crustal structure along and surrounding the Hawaiian Islands: Volcanic island construction across scarred oceanic crust

The Hawaiian Ridge is a classic example of an intraplate volcanic island chain emplaced on oceanic lithosphere. We seek to constrain both the deformation from island loading around the Hawaiian Ridge and the influence of the oceanic lithosphere, including the Molokaʻi fracture zone (MFZ), on off-axis volcanic emplacement. To examine these processes, we conducted a marine geophysical experiment in 2018 that included the acquisition of eight multichannel seismic reflection lines and used a 6,600 in 3 tuned air gun array and an ultra-long hydrophone streamer cable towed behind R/V Marcus G. Langseth across and around the southern Hawaiian Ridge. We image both the top of igneous oceanic crust and the Moho, and we observe significant variations in regional crustal structure and thickness variations, Moho characteristics, the locations of the buried MFZ, and the flexure of the Pacific oceanic lithosphere under the Hawaiian Ridge. We observe up to ∼4.5 km of deflection of the igneous oceanic crust in response to the volcanic load with sediment thickness increasing to ∼3–3.4 km near the ridge but not correlating with the deflection. A systematic difference in igneous oceanic crustal thickness is found north (average ∼5.2 km) and south (average ∼5.9 km), of the MFZ that also correspond to changes in Moho characteristics. The MFZ itself is associated with the largest crustal thickness variations (∼3.7–7.6 km). Magma ascent through these different crustal regions may account for some variations of magmatic flux to the surface along the Hawaiian Ridge.

Hawaii↗

Source, migration pathways, and atmospheric release of geologic methane associated with the complex permafrost regimes of the outer Mackenzie River Delta, Arctic, Canada

Sources and fluxes of methane to the atmosphere from permafrost are significant but poorly constrained in global climate models. We present data collected from the variable permafrost setting of the outer Mackenzie River Delta, including observations of aquatic methane seepage, core determinations of in situ methane occurrence and seep gas isotope geochemistry. The sources and locations of in situ geologic methane occurrence and aquatic and atmospheric gas release appear to be controlled by the regional geology and permafrost conditions. Where permafrost is >250 m thick, thermogenic gas deposits at depth are isolated by laterally continuous, low permeability ice-bearing sediments with few through-going thawed taliks. Thus, the observed in situ methane and aquatic gas seepage appears to be dominated by microbial methane. In contrast, where permafrost is <80 m thick, taliks are more likely to be through-going, providing permeable conduits from depth and migration pathways for both thermogenic and biogenic gas. Continuous annual fluid sampling of two lakes and a river channel documents aquatic methane flux from microbial sources, more deeply buried thermogenic sources, and mixtures of both. Using estimates of in situ methane concentration from deep core samples and observations of in situ free gas occurrences, we conclude that the reservoir of in situ geologic methane within ice bonded permafrost is substantial and that this methane is presently migrating with ongoing atmospheric release. It is our assessment that the permafrost setting, and processes described are sensitive to future climate change as the permafrost warms.

Mackenzie River Delta↗

Measuring erosional and depositional patterns across Comet 67P's imhotep region

Comet 67P/Churyumov-Gerasimenko displays a pronounced hemispherical dichotomy in surface morphology, where the southern hemisphere exhibits more erosional features than the northern hemisphere due to receiving much greater solar radiation. Consequently, it is generally assumed that particles are ejected from the southern hemisphere through sublimation and a significant fraction eventually descends as airfall, covering the northern terrains. To investigate this south-to-north material transfer during the comet's perihelion passage, we used photoclinometry to measure material redistribution within its most extensive smooth terrain deposit around the Imhotep region. However, our findings do not align with this expected trend. Instead, we show that local-scale processes substantially impact the erosion and accumulation of material, with one area experiencing net erosion while another nearby region, just a few dozen meters away, sees sediment buildup. Our analysis underscores the complex interplay of processes shaping Comet 67P's surface and likely comets more generally.

Journal of Geophysical Research↗