Balloon and core sampling for determining bulk density of alluvial desert soil

Abstract

Samples were collected from major strata in the upper 5 m of an alluvial soil profile in the Amargosa Desert of southern Nevada to compare rubber-balloon and drive-core bulk-density measurement methods. For strate where the fine soil was <82% sand and <15% clay, differences between total and fine-soil bulk-density values determined by the two methods were typically <10 and 15%, respectively, even where rock-fragment content was as great as 48% by volume. Outside this range of fine-soil texture, where soil consistency was either very loose or very hard, the core method appeared to sample inaccurately, resulting in bulk-density values >0.30 Mg m −3 less than those determined by the balloon method. Under the severe sampling conditions encountered, large decreases in the relative accuracy of the core method were not directly related to rock-fragment content, but were related to extremes in the cohesiveness of the strata sampled.