Search USGS⌕ Search

USGS · 70014370

The response of creeping parts of the San Andreas fault to earthquakes on nearby faults: Two examples

Abstract

Rates of shallow slip on creeping sections of the San Andreas fault have been perturbed on a number of occasions by earthquakes occurring on nearby faults. One example of such perturbations occurred during the 26 January 1986 magnitude 5.3 Tres Pinos earthquake located about 10 km southeast of Hollister, California. Seven creepmeters on the San Andreas fault showed creep steps either during or soon after the shock. Both left-lateral (LL) and right-lateral (RL) steps were observed. A rectangular dislocation in an elastic half-space was used to model the coseismic fault offset at the hypocenter. For a model based on the preliminary focal mechanism, the predicted changes in static shear stress on the plane of the San Andreas fault agreed in sense (LL or RL) with the observed slip directions at all seven meters; for a model based on a refined focal mechanism, six of the seven meters showed the correct sense of motion. Two possible explanations for such coseismic and postseismic steps are (1) that slip was triggered by the earthquake shaking or (2) that slip occurred in response to the changes in static stress fields accompanying the earthquake. In the Tres Pinos example, the observed steps may have been of both the triggered and responsive kinds. A second example is provided by the 2 May 1983 magnitude 6.7 Coalinga earthquake, which profoundly altered slip rates at five creepmeters on the San Andreas fault for a period of months to years. The XMM1 meter 9 km northwest of Parkfield, California recorded LL creep for more than a year after the event. To simulate the temporal behavior of the XMM1 meter and to view the stress perturbation provided by the Coalinga earthquake in the context of steady-state deformation on the San Andreas fault, a simple time-evolving dislocation model was constructed. The model was driven by a single long vertical dislocation below 15 km in depth, that was forced to slip at 35 mm/yr in a RL sense. A dislocation element placed in the seismogenic layer under XMM1 was given a finite breaking strength of sufficient magnitude to produce a Parkfield-like earthquake every 22 years. When stress changes equivalent to a Coalinga earthquake were superposed on the model running in a steady state mode, the effect was to make a segment under XMM1, that could slip in a linear viscous fashion, creep LL and to delay the onset of the next Parkfield-like earthquake by a year or more. If static stress changes imposed by earthquakes off the San Andreas can indeed advance or delay earthquakes on the San Andreas by months or years, then such changes must be considered in intermediate-term prediction efforts. ?? 1988 Birkha??user Verlag.

Explore related subjects

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

R.W. Simpson, S.S. Schulz, L.D. Dietz, Robert O. Burford. 1988. The response of creeping parts of the San Andreas fault to earthquakes on nearby faults: Two examples. https://doi.org/10.1007/bf00879014

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

Introduction to “Global tsunami science: Past and future, Volume I”

Twenty-five papers on the study of tsunamis are included in Volume I of the PAGEOPH topical issue “Global Tsunami Science: Past and Future”. Six papers examine various aspects of tsunami probability and uncertainty analysis related to hazard assessment. Three papers relate to deterministic hazard and risk assessment. Five more papers present new methods for tsunami warning and detection. Six papers describe new methods for modeling tsunami hydrodynamics. Two papers investigate tsunamis generated by non-seismic sources: landslides and meteorological disturbances. The final three papers describe important case studies of recent and historical events. Collectively, this volume highlights contemporary trends in global tsunami research, both fundamental and applied toward hazard assessment and mitigation.

Pure and Applied Geophysics PAGEOPH↗

Implications of Coulomb plasticity for the velocity dependence of experimental faults

Simulated fault gouges often deform more stably than initially bare surfaces of the same composition. It is important to understand why the sliding stability is enhanced because the presence of gouge on natural faults may have the same effect as seen in experiments, and thus explain the absence of earthquakes at shallow depths. Gouge stabilization in experiments has been attributed to positive contributions to velocity dependence within gouge layers from either dilation (Maroneet al., 1990) or grain fracture (Biegelet al., 1989). In this study we test the hypothesis that some aspects of gouge and initially bare surface velocity dependence are identical by measuring the time-dependent constitutive parameter b. An important result follows however from stress analysis: if both sample configurations are frictional in the Mohr-Coulomb sense, each configuration is required to deform on planes of distinctly different orientation. The measured strength and velocity dependence will reflect this geometric difference. Our observed values of b for simulated granite and quartz gouge are two to two and a half times smaller than b for initially bare surfaces. This difference is completely accounted for if gouge is represented as a cohesionless-Coulomb plastic material. The analysis demonstrates the following points: 1) gouge deformation is fully consistent with Coulomb plasticity, 2) observed gouge velocity dependence is a function of observed strength and 3) the constitutive parameter b is the same for both bare surfaces and gouge. Furthermore, the results suggest that there is no time-dependent strengthening associated with stabilizing effects in gouge. These observations provide a framework for understanding how slip on initially bare surfaces and gouge deformation are related. ?? 1995 Birkha??user Verlag.

Pure and Applied Geophysics PAGEOPH↗

The effect of fault-bend folding on seismic velocity in the marginal ridge of accretionary prisms

Fluid venting in accretionary prisms, which feeds chemosynthetic biological communities, occurs mostly on the marginal thrust ridge. New seismic data for the marginal ridge of the Cascadia prism show significantly lower velocity than that in the adjacent oceanic basin and place important constraints on the interpretations of why fluid venting occurs mostly on the marginal ridge. We employed a finite-element method to analyze a typical fault-bend folding model to explain the phenomenon. The fault in the model is simulated by contact elements. The elements are characterized not only by finite sliding along a slide line, but also by elastoplastic deformation. We present the results of a stress analysis which show that the marginal ridge is under subhorizontal extension and the frontal thrust is under compression. This state of stress favors the growth of tensile cracks in the marginal ridge, facilitates fluid flow and reduces seismic velocities therein; on the other hand, it may close fluid pathways along the frontal thrust and divert fluid flow to the marginal ridge. ?? 1995 Birkha??user Verlag.

Pure and Applied Geophysics PAGEOPH↗