Search USGS⌕ Search
Home/Archive/USGS

USGS · 70013800

The feasibility of using sequential extraction techniques for As and Se in soils and sediments

Karen A. Gruebel·James A. Davis·James O. Leckie
View original source ↗Export metadata ↓

Abstract

Laboratory experiments were conducted with well-characterized minerals to test the applicability of selective extraction schemes for Se and As partitioning in soils and sediments. Two specific steps were tested: the reductive dissolution of amorphous iron oxides and the oxidation of organic material. Selenium and As associated with amorphous iron oxides were usually not found in solution after reductive dissolution, due to readsorption onto other minerals unaffected by the extractant. Oxidants intended to dissolve organic material also oxidized Se(IV) adsorbed on a mineral to Se(VI), causing the release of Se(VI) to the extractant solution.

Explore related subjects

Soil Science Society of America JournalArticle

Keep this discovery

Explore connections, maps & timelines

BibTeXRIS

Karen A. Gruebel, James A. Davis, James O. Leckie. 1988-03-01. The feasibility of using sequential extraction techniques for As and Se in soils and sediments. https://doi.org/10.2136/sssaj1988.03615995005200020016x

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2023

Forming regional soil carbon networks to support effective climate change solutions

Sequestration and storage of organic carbon (C) in soil is an essential component of climate change mitigation and fundamental in promoting the health and climate resilience of soils. Sources of available soil C data are increasing, which complicates efforts to consolidate the data in forms that can be readily used by stakeholders. Spatial and temporal gaps in data availability also limit the quantification of changes in soil C through space and time. Improved coordination among producers and users of soil C data would provide data compatibility at the spatial and temporal resolution required for C monitoring, accounting, and verification of policy implementation. These challenges can be addressed by forming regional-scale networks to coordinate the collection and use of soil C data by promoting consistency in methods, collecting new data to fill critical gaps, integrating existing data from multiple sources, and providing data interpretation to stakeholders in readily usable forms. Forming networks in regions such as the Northeastern United States would require close coordinationwith existing programs that are involved in collecting or aggregating soil C within that region. Network formation could be accomplished by (1) producing a planning document, (2) designing a network structure tailored to the region, and (3) acquiring the institutional support to establish and operate the network. Increasing the availability and usage of soil C data through regional networks would support the development of climate change solutions and increased ecosystem services through land management efforts that increase soil C storage.

Soil Science Society of America Journal↗
USGS2021

The processes of preferential flow in the unsaturated zone

Preferential flow, a major influence in unsaturated soil and rock almost everywhere, occurs by multiple phenomenologically distinct hydraulic processes. For the mode known as funneled flow, concentrated in particularly conductive portions of the medium, the surface-tension/viscous-flow processes of traditional unsaturated flow theory predominate. Fingered flow, through conductive paths of higher water content than surrounding material, requires amendments to traditional theory concerning instabilities and dynamic flow-regime boundaries. Macropore flow, the most recognized preferential flow mode, poses unanswered questions and major difficulties in practice. Accumulated evidence shows that water flows preferentially mostly through macropores that are (a) only partially filled with water, and (b) surrounded by matrix material that is drier, sometimes much drier, than saturation. With partial filling, geometric characteristics such as aperture have much less influence than was previously thought, and the intra-macropore configuration of the flowing water phase, about which little is conclusively known, is then a dominant controlling influence. With unsaturated surroundings, macropore/matrix exchange interactions control, for given input and medium, the initiating circumstances, conveyed flux, and duration of macropore flow. The multiple processes in play during such interactions have different sensitivities to the matrix water state and different directions of influence. The net influence of matrix water content on macropore flow is thus highly complex and a major research need. Additional high-priority topics are: flowpath connectivity, for watersheds as well as small scales; intra-macropore processes, to discern their importance and possible means of quantification; and the identification of measurable soil and rock properties that can be utilized predictively.

Soil Science Society of America Journal↗
USGS2020

A hybrid approach for predictive soil property mapping using conventional soil survey data

Soil property maps are important for land management and earth systems modeling. A new hybrid point-disaggregation predictive soil property mapping strategy improved mapping in the Colorado River Basin, and can be applied to other areas with similar data (e.g. conterminous United States). This new approach increased sample size ~6-fold over past efforts. Random forests related environmental raster layers representing soil forming factors to samples to predict 15 soil properties (pH, texture fractions, rock, electrical conductivity, gypsum, CaCO3, sodium adsorption ratio, available water capacity, bulk density, erodibility, organic matter) at 7 depths, depth to restrictive layer, and surface rock size and cover. Cross-validations resulted in coefficient of determinations averaging 0.52, with a range of 0.20 to 0.76; and mean absolute errors ranged from 3% to 98% of training data averages with a mean of 41%. Uncertainty estimates were also developed by creating relative prediction intervals (RPIs) for the entire study area, which allow end users to evaluate uncertainty relative to original data distributions. Average error increased with higher RPI values (higher uncertainty), and areas with the highest RPI are consistently under-sampled, suggesting that additional sampling in these areas may improve prediction accuracy. Greater uncertainty was also observed in areas with shale parent materials and physiographic settings uncommon relative to the broader study area.

New Mexico, Colorado, Wyoming, Utah, Nevada, Arizo↗