Shear and tension hydraulic fractures in low permeability rocks

P. Solberg; D. Lockner; J. Byerlee

doi:10.1007/bf01637103

Home/Archive/USGS

USGS · 70001079

Shear and tension hydraulic fractures in low permeability rocks

P. Solberg·D. Lockner·J. Byerlee

View original source ↗Export metadata ↓

Abstract

Laboratory hydrofracture experiments were performed on triaxially stressed specimens of oil shale and low-permeability granite. The results show that either shear or tension fractures could develop depending on the level of differentials stress, even in specimens containing preexisting fractures. With 1 kb of confining pressure and differential stress greater than 2kb, hydraulic fluid diffusion into the specimens reduced the effective confining pressure until failure occurred by shear fracture. Below 2kb of differential stress, tension fractures occurred. These results suggest that hydraulic fracturing in regions of significant tectonic stress may produce shear rather than tension fractures. In this case in situ stress determinations based on presumed tension fractures would lead to erroneous results. ?? 1977 Birkha??user Verlag.

Explore related subjects

Pure and Applied Geophysics PAGEOPH Article

Keep this discovery

Explore connections, maps & timelines

BibTeX RIS

P. Solberg, D. Lockner, J. Byerlee. 1977. Shear and tension hydraulic fractures in low permeability rocks. https://doi.org/10.1007/bf01637103

Cite the original work for its findings. Save a collection to share your selection of sources.

KEEP EXPLORING

Related USGS reports

USGS2016

Introduction to “Global tsunami science: Past and future, Volume I”

Twenty-five papers on the study of tsunamis are included in Volume I of the PAGEOPH topical issue “Global Tsunami Science: Past and Future”. Six papers examine various aspects of tsunami probability and uncertainty analysis related to hazard assessment. Three papers relate to deterministic hazard and risk assessment. Five more papers present new methods for tsunami warning and detection. Six papers describe new methods for modeling tsunami hydrodynamics. Two papers investigate tsunamis generated by non-seismic sources: landslides and meteorological disturbances. The final three papers describe important case studies of recent and historical events. Collectively, this volume highlights contemporary trends in global tsunami research, both fundamental and applied toward hazard assessment and mitigation.

Pure and Applied Geophysics PAGEOPH↗

USGS1995

Implications of Coulomb plasticity for the velocity dependence of experimental faults

Simulated fault gouges often deform more stably than initially bare surfaces of the same composition. It is important to understand why the sliding stability is enhanced because the presence of gouge on natural faults may have the same effect as seen in experiments, and thus explain the absence of earthquakes at shallow depths. Gouge stabilization in experiments has been attributed to positive contributions to velocity dependence within gouge layers from either dilation (Maroneet al., 1990) or grain fracture (Biegelet al., 1989). In this study we test the hypothesis that some aspects of gouge and initially bare surface velocity dependence are identical by measuring the time-dependent constitutive parameter b. An important result follows however from stress analysis: if both sample configurations are frictional in the Mohr-Coulomb sense, each configuration is required to deform on planes of distinctly different orientation. The measured strength and velocity dependence will reflect this geometric difference. Our observed values of b for simulated granite and quartz gouge are two to two and a half times smaller than b for initially bare surfaces. This difference is completely accounted for if gouge is represented as a cohesionless-Coulomb plastic material. The analysis demonstrates the following points: 1) gouge deformation is fully consistent with Coulomb plasticity, 2) observed gouge velocity dependence is a function of observed strength and 3) the constitutive parameter b is the same for both bare surfaces and gouge. Furthermore, the results suggest that there is no time-dependent strengthening associated with stabilizing effects in gouge. These observations provide a framework for understanding how slip on initially bare surfaces and gouge deformation are related. ?? 1995 Birkha??user Verlag.

Pure and Applied Geophysics PAGEOPH↗

USGS1995

The effect of fault-bend folding on seismic velocity in the marginal ridge of accretionary prisms

Fluid venting in accretionary prisms, which feeds chemosynthetic biological communities, occurs mostly on the marginal thrust ridge. New seismic data for the marginal ridge of the Cascadia prism show significantly lower velocity than that in the adjacent oceanic basin and place important constraints on the interpretations of why fluid venting occurs mostly on the marginal ridge. We employed a finite-element method to analyze a typical fault-bend folding model to explain the phenomenon. The fault in the model is simulated by contact elements. The elements are characterized not only by finite sliding along a slide line, but also by elastoplastic deformation. We present the results of a stress analysis which show that the marginal ridge is under subhorizontal extension and the frontal thrust is under compression. This state of stress favors the growth of tensile cracks in the marginal ridge, facilitates fluid flow and reduces seismic velocities therein; on the other hand, it may close fluid pathways along the frontal thrust and divert fluid flow to the marginal ridge. ?? 1995 Birkha??user Verlag.

Pure and Applied Geophysics PAGEOPH↗