Geology topics

Research about Sumatra

Source-linked reports with geographic coverage including Sumatra.

4 recordsLinked to original sources

USGS2024

Constraining magma storage conditions of the Toba magmatic system: A plagioclase and amphibole perspective

Silicic magma reservoirs are responsible for producing the largest explosive eruptions in the geologic record. Petrologic and geochronological data provide evidence for these systems spending substantial periods of time (10 4 –10 5 yrs) within the upper crust prior to eruption; however, the long-term thermochemical evolution of these systems is not fully understood, as existing petrologic data make it challenging to quantify the time interval a magmatic system has spent at certain temperatures, or its “thermal history”. Here, we investigate the 74 ka Youngest Toba Tuff (YTT), one of the largest explosive eruptions in the geologic record, to better constrain the long-term thermal evolution of its magmatic system. We combine forward models of Sr diffusion in plagioclase and hornblende, mineral thermometry, and pre-existing trace-element evolution models to quantify the thermochemical evolution of the YTT magmatic system. We find that plagioclase crystals record decades to centuries of storage at temperatures 750 C, while hornblende records up to 6200 years at the same temperatures. Hornblende crystallizes at temperatures around 820 C and adjusting our diffusion modeling to this temperature results in no more than 900 years at initial crystallization conditions. Combined with previous trace-element modeling work, these results indicate that although there was chemical diversity for long durations in the YTT magma system sufficient to produce unique composition eruptive products, the entire system was experiencing a relatively similar thermal history that did not allow for large bodies of eruptible magma to be present for long periods ( 10 2 –10 3 years). Rather, we suggest that magmas within the YTT magmatic system were stored for long durations at thermal conditions where they were uneruptible and only remobilized within a few centuries prior to eruption.

Sumatra↗

USGS2019

Gas and ash emissions associated with the 2010–present activity of Sinabung Volcano, Indonesia

Sinabung Volcano (Sumatra, Indonesia) awoke from over 1200 years of dormancy with multiple phreatic explosions in 2010. After a period of quiescence, Sinabung activity resumed in 2013, producing frequent explosions, lava dome extrusion, and pyroclastic flows from dome collapses, becoming one of the world's most active volcanoes and displacing over 20,000 citizens. This study presents a compilation of the geochemical datasets collected by the Indonesian Center for Volcanology and Geological Hazard Mitigation (CVGHM) from 2010 - current (2016), which provides insights into the evolution of the eruption. Based on observations of SO2 emissions, ash componentry, leachate chemistry, and bulk ash geochemistry, the eruption can be split into five distinct phases. The initial stage of phreatic summit explosions occurred from August - October 2010, during which background SO2 emissions averaged ~550 ± 180 t/d (1 s.d.). An eruptive pause (phase two) starting in October 2010 abruptly ended in September 2013 with a resumption of conduit-clearing eruptions. This third phase had a relatively modest background SO2 emission rate (avg. ~410 ± 275 t/d) and produced ash consisting entirely of accidental ejecta with high S/Cl leachate ratios (up to 30), suggestive of deep-sourced magma and the incorporation of hydrothermal sulfur-bearing phases. The most intense phase of the eruption (phase four) occurred from December 2013 to February 2014, when juvenile magma first reached the surface. This period included dozens of large eruptions per day, high SO2 emission rates (average: 1,120 ± 1,030 t/d, peak: ~3,800 t/d), the onset of lava dome extrusion, and a dramatic drop in S/Cl ash leachates to ratios < 5, all reflecting increased degassing from shallow magma and the clearing out of sulfurous phases from the old hydrothermal system. From late February 2014 through the time of writing (September 2016), Sinabung settled into a relatively steady state of lower activity (phase five). Ash emissions now consist of dominantly juvenile material, and background SO2 emission rates have been progressively decreasing to an average of ~250 - 300 t/d. Starting August 2016, SO2 emissions started being measured in a continuous manner using a network of permanent scanning DOAS instruments. We find that long-term SO2 emission rates have been gradually declining at Sinabung since early 2014, consistent with an apparent decrease in magma supply. Our degassing model suggests that large explosions and pyroclastic flows could continue in the near-term owing to conduit plugging and dome collapses, remaining a major threat until the magma supply rate decreases further and the eruption ends.

Sumatra↗

USGS2013

Seismicity of the Earth 1900-2012 Sumatra and vicinity

The plate boundary southwest of Sumatra is part of a long tectonic collision zone that extends over 8,000 km from Papua, New Guinea, in the east to the Himalayan front in the west. The Sumatra-Andaman part of the collision zone forms a subduction zone plate boundary, which accommodates convergence between the Indo-Australia and Sunda plates. This convergence is responsible for the intense seismicity in Sumatra. The Sumatra Fault, a major transform structure that bisects Sumatra, accommodates the northwest-increasing lateral component of relative plate motion. Most strain accumulation and release between the two plates occurs along the Sunda megathrust. The increasingly oblique convergence moving northwest is accommodated by crustal seismicity along several transform and normal faults, including the Sumatra Fault. Plate-boundary related deformation is also not restricted to the subduction zone and overriding plate: the Indo-Australian plate actually comprises two somewhat independent plates (India and Australia) that are joined along a broad, actively deforming region that produces seismicity up to several hundred kilometers west of the trench. This deformation is exemplified by the recent April 2012 earthquake sequence, which includes the April 11 M 8.6 and M 8.2 strike-slip events and their subsequent aftershocks. Since 2004, much of the Sunda megathrust between the northern Andaman Islands and Enggano Island, a distance of more than 2,000 km, has ruptured in a series of large subduction zone earthquakes—most rupturing the plate boundary south of Banda Aceh. These events include the great M 9.1 earthquake of December 26, 2004; the M 8.6 Nias Island earthquake of March 28, 2005; and two earthquakes on September 12, 2007, of M 8.5 and M 7.9. On October 25, 2010, a M 7.8 on the shallow portion of the megathrust to the west of the Mentawai Islands caused a substantial tsunami on the west coast of those islands.

Open-File Report↗

USGS2012

Real-time forecasting of the April 11, 2012 Sumatra tsunami

The April 11, 2012, magnitude 8.6 earthquake off the northern coast of Sumatra generated a tsunami that was recorded at sea-level stations as far as 4800 km from the epicenter and at four ocean bottom pressure sensors (DARTs) in the Indian Ocean. The governments of India, Indonesia, Sri Lanka, Thailand, and Maldives issued tsunami warnings for their coastlines. The United States' Pacific Tsunami Warning Center (PTWC) issued an Indian Ocean-wide Tsunami Watch Bulletin in its role as an Interim Service Provider for the region. Using an experimental real-time tsunami forecast model (RIFT), PTWC produced a series of tsunami forecasts during the event that were based on rapidly derived earthquake parameters, including initial location and Mwp magnitude estimates and the W-phase centroid moment tensor solutions (W-phase CMTs) obtained at PTWC and at the U. S. Geological Survey (USGS). We discuss the real-time forecast methodology and how successive, real-time tsunami forecasts using the latest W-phase CMT solutions improved the accuracy of the forecast.

Sumatra↗