Geology topics

Research about Salton Trough

Source-linked reports with geographic coverage including Salton Trough.

3 recordsLinked to original sources

USGS2017

Thermal and petrologic constraints on lower crustal melt accumulation under the Salton Sea Geothermal Field

In the Salton Sea region of southern California (USA), concurrent magmatism, extension, subsidence, and sedimentation over the past 0.5 to 1.0 Ma have led to the creation of the Salton Sea Geothermal Field (SSGF)—the second largest and hottest geothermal system in the continental United States—and the small-volume rhyolite eruptions that created the Salton Buttes. In this study, we determine the flux of mantle-derived basaltic magma that would be required to produce the elevated average heat flow and sustain the magmatic roots of rhyolite volcanism observed at the surface of the Salton Sea region. We use a 2D thermal model to show that a lower-crustal, partially molten mush containing < 20 – 40 % "> <20–40% interstitial melt develops over a ∼ 10 5 "> ∼105 -yr timescale for basalt fluxes of 0.008 to 0.010 m 3 / m 2 / yr "> 0.010m3/m2/yr (∼0.0008 to ∼0.001 km / 3 yr "> /3yr injection rate) given extension rates at or below the current value of ∼0.01 m/yr ( Brothers et al., 2009 ). These regions of partial melt are a natural consequence of a thermal regime that scales with average surface heat flow in the Salton Trough, and are consistent with seismic observations. Our results indicate limited melting and assimilation of pre-existing rocks in the lower crust. Instead, we find that basalt fractionation in the lower crust produces derivative melts of andesitic to dacitic composition. Such melts are then expected to ascend and accumulate in the upper crust, where they further evolve to give rise to small-volume rhyolite eruptions (Salton Buttes) and fuel local spikes in surface heat flux as currently seen in the SSGF. Such upper crustal magma evolution, with limited assimilation of hydrothermally altered material, is required to explain the slight decrease in δ 18 O "> δ18O values of zircons (and melts) that have been measured in these rhyolites.

California↗

USGS2016

Fault zone characteristics and basin complexity in the southern Salton Trough, California

Ongoing oblique slip at the Pacific–North America plate boundary in the Salton Trough produced the Imperial Valley (California, USA), a seismically active area with deformation distributed across a complex network of exposed and buried faults. To better understand the shallow crustal structure in this region and the connectivity of faults and seismicity lineaments, we used data primarily from the Salton Seismic Imaging Project to construct a three-dimensional P-wave velocity model down to 8 km depth and a velocity profile to 15 km depth, both at 1 km grid spacing. A V P = 5.65–5.85 km/s layer of possibly metamorphosed sediments within, and crystalline basement outside, the valley is locally as thick as 5 km, but is thickest and deepest in fault zones and near seismicity lineaments, suggesting a causative relationship between the low velocities and faulting. Both seismicity lineaments and surface faults control the structural architecture of the western part of the larger wedge-shaped basin, where two deep subbasins are located. We estimate basement depths, and show that high velocities at shallow depths and possible basement highs characterize the geothermal areas.

California↗

USGS2001

Very different crustal response to extreme extension in the southern Basin and Range and Colorado Plateau transition

Clustered about the southwest edge of the Colorado Plateau lie many highly extended terranes. Among these are metamorphic core complexes, distinguished by low-angle normal faults with sufficient offset to expose middle crustal rocks at higher elevation relative to the surrounding areas. About 150 km to the southwest, strong extension in the Salton Trough manifests itself very differently; high-angle normal faults form deep basins, with the strongest extension causing subsidence beneath sea level. We ask why strong extension takes such different forms, and, to help answer the question, we take advantage of seismic and gravity profiles that cross through the Salton Trough, metamorphic core complexes, and the Colorado Plateau. We propose that the relative rate of extension vs. intrusion of crust by magmatism and crustal flow controls the extensional style. We further show that conditions may have been ideal for core complex formation along the edges of the Colorado Plateau because its thick crust and high elevation provided a source of crustal flow and the pressure gradient to drive the flow.

California↗