Search USGS⌕ Search

Geology topics

Research about Napa Valley

Source-linked reports with geographic coverage including Napa Valley.

6 recordsLinked to original sources
USGS2026

Distributed faulting of the northern West Napa Fault Zone in Napa Valley, California

Mapped surface ruptures from the 24 August 2014 M w 6.0 South Napa earthquake in the Napa Valley, California, show a 2‐km‐wide zone of distributed faulting in the southern and central West Napa fault zone (WNFZ). In the northern WNFZ at Hendry Winery (HW), however, the mapped 2014 surface ruptures encompass an ∼100‐m‐wide zone, implying significant narrowing of the near‐surface fault zone to the north. We present a tomographic shear‐wave velocity ( ⁠⁠ V S ) model and guided‐wave data that indicate the northern WNFZ is at least 400‐m wide, with multiple near‐surface fault traces. Our V S model shows that the 2014 surface ruptures are underlain by discrete low‐velocity zones (LVZs), and coincident guided‐wave data show that the LVZs carry fault‐zone guided waves. If nearby (<500 m) mapped faults to the east of HW are part of the WNFZ, the entire WNFZ is more than 1 km wide in the northern Napa Valley. WNFZ guided waves travel up to 38% slower than S body waves, and low‐strain guided‐wave shaking is up to five times stronger than the associated body‐wave shaking. Our data suggest that guided waves, traveling along distributed faults, may result in an increased shaking hazard over a 1‐km‐wide area of the northern Napa Valley during future significant earthquakes. In places, the 2014 surface ruptures were difficult to find one year after the earthquake, and paleoseismic trenching showed only weak evidence for faulting, which may not have been identified in trenches if the locations of the 2014 surface ruptures had not been previously mapped ( Prentice et al. , 2015 ). Guided‐wave and V S tomography data, however, show strong evidence for faulting beneath the 2014 surface ruptures and at locations to the east. Although paleoseismic trenching is the gold standard for identifying near‐surface faulting, methods such as peak ground velocities of guided waves may better identify immature near‐surface fault traces.

California↗
USGS2015

Rates and patterns of surface deformation from laser scanning following the South Napa earthquake, California

The A.D. 2014 M6.0 South Napa earthquake, despite its moderate magnitude, caused significant damage to the Napa Valley in northern California (USA). Surface rupture occurred along several mapped and unmapped faults. Field observations following the earthquake indicated that the magnitude of postseismic surface slip was likely to approach or exceed the maximum coseismic surface slip and as such presented ongoing hazard to infrastructure. Using a laser scanner, we monitored postseismic deformation in three dimensions through time along 0.5 km of the main surface rupture. A key component of this study is the demonstration of proper alignment of repeat surveys using point cloud&ndash;based methods that minimize error imposed by both local survey errors and global navigation satellite system georeferencing errors. Using solid modeling of natural and cultural features, we quantify dextral postseismic displacement at several hundred points near the main fault trace. We also quantify total dextral displacement of initially straight cultural features. Total dextral displacement from both coseismic displacement and the first 2.5 d of postseismic displacement ranges from 0.22 to 0.29 m. This range increased to 0.33&ndash;0.42 m at 59 d post-earthquake. Furthermore, we estimate up to 0.15 m of vertical deformation during the first 2.5 d post-earthquake, which then increased by &sim;0.02 m at 59 d post-earthquake. This vertical deformation is not expressed as a distinct step or scarp at the fault trace but rather as a broad up-to-the-west zone of increasing elevation change spanning the fault trace over several tens of meters, challenging common notions about fault scarp development in strike-slip systems. Integrating these analyses provides three-dimensional mapping of surface deformation and identifies spatial variability in slip along the main fault trace that we attribute to distributed slip via subtle block rotation. These results indicate the benefits of laser scanner surveys along active faults and demonstrate that fine-scale variability in fault slip has been missed by traditional earthquake response methods.

California↗
USGS2015

The Mw6.0 24 August 2014 South Napa earthquake

The M w 6.0 South Napa earthquake, which occurred at 10:20 UTC 24 August 2014 was the largest earthquake to strike the greater San Francisco Bay area since the M w 6.9 1989 Loma Prieta earthquake. The rupture from this right‐lateral earthquake propagated mostly unilaterally to the north and up‐dip, directing the strongest shaking toward the city of Napa, where peak ground accelerations (PGAs) between 45% g and 61% g were recorded and modified Mercalli intensities (MMIs) of VII&ndash;VIII were reported. Tectonic surface rupture with dextral slip of up to 46 cm was observed on a 12.5 km long segment, some of which was along a previously mapped strand of the West Napa fault system, although the rupture extended to the north of the mapped Quaternary strand. Modeling of seismic and geodetic data suggests an average coseismic slip of 50 cm, with a maximum slip of about 1 m at depths of 10&ndash;11 km. We observed up to 35 cm of afterslip along the surface trace in the week following the mainshock, primarily along the southern half of the surface rupture that experienced relatively little coseismic offset. Relocation of the sparse aftershock sequence suggests en echelon southwest‐ and northeast‐dipping fault planes, reflective of the complex fault geometry in this region. The Napa basin and historic and late Holocene alluvial flood deposits in downtown Napa amplified the ground motions there. Few ground failures were mapped, reflecting the dry season (as well as a persistent drought that had lowered the groundwater table) and the short duration of strong shaking in the epicentral area.

California↗
USGS1973

Ground-water hydrology of northern Napa Valley, California

The alluvium of northern Napa Valley is the principal aquifer of the area and is capable of yielding as much as 3,000 gallons per minute to wells. Generally the larger-yielding wells are along the Napa River where the alluvium is thickest and most permeable. Recharge to the alluvium is chiefly by percolation from streams and infiltration of precipitation. Discharge is chiefly flow to the Napa River, evapotranspiration, and pumpage from wells. Both recharge to, and discharge from, the alluvial aquifer are sensitively influenced by rainfall. About 190,000 acre-feet of water is presently (1972) stored in the alluvium of northern Napa Valley. Future annual water use in the project area will probably vary between 12,000 and 35,000 acre-feet and, for most purposes, can be supplied by the alluvial aquifer even during extended periods of limited rainfall. Generally low transmissivities in the alluvium, however, limit the opportunity for obtaining sustained, large yields from wells in much of the valley and require that large-scale development and operation of wells in much of the area be planned and synchronized. Sustained drought conditions in the Napa Valley accompanied by expected increases in the use of ground water will probably cause significant reductions in the base flow of the Napa River and cause many shallow wells in the area to dry up. Sodium chloride ground water occurs near Calistoga and in the vicinity of Oakville and in some places is not suitable for irrigation. Model studies indicate that limited migration of sodium chloride water into intensively pumped parts of the aquifer probably will not be a serious problem.

California↗