Search USGS⌕ Search

Geology topics

Research about Lemhi County, Idaho

Source-linked reports with geographic coverage including Lemhi County, Idaho.

15 recordsLinked to original sources

Stratigraphy and depositional environments of middle Proterozoic rocks, northern part of the Lemhi Range, Lemhi County, Idaho

Geologic mapping shows Middle Proterozoic strata form two packages of strata north and south of the Tertiary Lem Peak normal fault. Strata north of the fault, the main focus of this report, contain thicknesses and lithofacies of the Big Creek and Apple Creek formations of the Lemhi Group that contrast with those south of the fault. Strata south of the fault, examined mainly in reconnaissance, may have been thrust eastward prior to being downdropped.

Idaho↗

Geology and phosphate resources of the Hawley Creek area, Lemhi County, Idaho

Phosphate resources occur within the Retort Phosphatic Shale Member of the Permian Phosphoria Formation in the Hawley Creek area, near Leadore, in east-central Idaho. About 12 square miles (31 km 2 ) of the Retort Member and enclosing rocks were mapped at a scale of 1:12,000 to evaluate the leasable Federal mineral resources. The Retort has an average thickness of 73 feet (22.3 m) and 12.9 linear miles (20.8 linear km) of outcrop within the area mapped. Rock samples taken from a bulldozer trench were analyzed for phosphate content and for minor trace elements. Analyses show a cumulative thickness of 8.7 feet ( 2.7 m) of medium-grade phosphate rock ( 24 to 31 percent P 2 O 5 ) and 33.4 feet (10.2 m) of low-grade phosphate rock (16 to 24 percent P 2 O 5 ). Minor elements in the Retort include uranium, vanadium, fluorine, cadmium, chromium, nickel, molybdenum, silver, and rare earths. These minor elements are potential byproducts of any future phosphate production in the Hawley Creek area. In addition, analyses of six phosphate rock samples taken from a prospect trench show a cumulative thickness of 14.9 ft (4.5 m) at 17.6 percent P 2 O 5 . Indicated phosphate resources are calculated for phosphate beds under less than 600 feet (183.0 m) of overburden. Approximately 36.5 feet (11.1 m), representing 50 percent of the total Retort Member, were measured in trench CP-71. There are 80.42 million short tons (72.96 million metric tons) of medium-grade phosphate rock, and 308.76 million short tons ( 280.10 million metric tons) of low-grade phosphate rock in the Retort Member within the map area. Because the thickness and grade of the phosphate beds for each block are based on the recovered section from CP-71, the calculated phosphate resource estimates represent a minimum. Other mineral resources in the area are thorium (35 ppm) in a Precambrian (?) granite body located immediately west of the Hawley Creek area; oil and gas accumulations may occur beneath the Medicine Lodge thrust system in this part of the Beaverhead Mountains. Paleozoic, Mesozoic, and Cenozoic rocks are present in the Hawley Creek area. Fold axes and thrust faults have a dominant northwest trend. These thrusts and folds are probably associated with the northeast-oriented stress field that existed in Late Cretaceous time. Evidence of younger, high-angle normal and reverse faults in the area also exists.

Idaho↗

Preliminary report on the geology and deposits of monazite, thorite, and niobium-bearing rutile of the Mineral Hill district, Lemhi County, Idaho

Deposits of minerals containing niobium (columbium), thorium, and rare earths occur in the Mineral Hill district, 30 miles northwest of Salmon, Lemhi County, Idaho. Monazite, thorite, allanite, and niobium-bearing rutile form deposits in metamorphic limestone layers less than 8 feet thick. The known deposits are small, irregular, and typically located in or near small folds. Minor faults are common. Monazite generally is coarsely crystalline and contains less than one percent thorium. Rutile forms massive lumps up to 3 inches across; it contains between 5 and 10 percent niobium. Rutile occurs in the northwestern half of the district, thorite in the central and southeastern parts. Monazite occurs in all deposits. Allanite is locally abundant and contains several percent thorium. Magnetite and ilmenite are also locally abundant. A major thrust fault trending northwest across the map-area separates moderately folded quartzite and phyllitic rocks of Belt age, on the northeast, from more intensely metamorphosed and folded rocks on the southwest. The more metamorphosed rocks include amphibolite, porphyroblastic feldspar gneiss, quartzite, and limestone, all probably of sedimentary origin, and probably also of Belt (late Precambrian) age. The only rocks of definite igneous origin are rhyolite dikes of probable Tertiary age. The more metamorphosed rocks were formed by metasomatic metamorphism acting on clastic sediments, probably of Belt age, although they may be older than Belt. Metamorphism doubtless was part of the episode of emplacement of the Idaho batholith, but the history of that episode is not well understood. The rare-element deposits show no evidence of fracture-controlled hydrothermal introduction, such as special fracture systems, veining, and gangue material. They may, however, be of hydrothermal type. More likely they are metamorphic segregations or secretions, deposited in favorable stratigraphic and structural positions during regional metamorphism.

Idaho↗

Metamorphic differentiates in the blackbird mining district, Lemhi County, Idaho

Quartz pods and quartz veins devoid of economic minerals occur in the cobalt-copper mineralized Blackbird mining district in Lemhi County , Idaho . These barren quartz bodies are found in regionally and thermally metamorphosed rocks of the Yellowjacket formation (Belt series) of Pre-cambrian age and are believed to be derived from the enclosing quartz-biotite and quartz-biotite-garnet-chloritoid schists by metamorphic differentiation. Other rocks that possibly are products of metamorphic differentiation are discussed. Two zones of regional metamorphism are recognized, a biotite zone and a garnet zone. Contact metamorphism associated with the granitic intrusive rocks of the Idaho batholith is recognized adjacent to the batholith.

Idaho↗

Cobalt-copper deposits of the Blackbird district, Lemhi County, Idaho

The Blackbird district is in east-central Idaho, about 20 miles west-southwest of Salmon. The area is one of deeply weathered, flat-topped upland surfaces cut by several steep-walled valleys, which are tributary to the canyon of Panther Creek. Most of the area has a heavy vegetative cover and outcrops are relatively scarce except in the walls of the steeper valleys. The rocks of the district consist mostly of metamorphosed sedimentary rocks of the pre-Cambrian Yellowjacket formation (Belt series); a part of the Cretaceous Idaho batholith cuts across the northern part of the district, and acid porphyry dikes and metamorphosed basic rocks cut the Yellowjacket rocks. Structurally, the sedimentary rocks are divided by faults into three, roughly north-south blocks. The center one (Blackbird structural block) appears to have been more tightly squeezed than the others into relatively tight folds, with the development of widespread schistosity (flow cleavage). The rocks of the two outside blocks are in more open folds. In general they are nonschistose, except for the north end of the western block, where there are schistose rocks cut by several north-dipping thrust faults. The northern parts of the central and western blocks contain considerable garnet, chloritoid, and cordierite. The Blackbird structural block is cut by a number of mineralized shear zones. Those dipping moderately northeast and striking northwest, and those dipping steeply and striking north and northeast; appear to be most important. The mineralized rock contains chalcopyrite, cobaltite, pyrite, and pyrrhotite into a gangue of quartz, biotite, tourmaline, ankerite, and muscovite; the deposits were formed mostly by replacement of the shear zones. In addition, the block is cut by north-dipping thrust faults of west to northwest strike, and a number of high-angle faults. The district was first prospected about 1893; considerable developmont was done at the Brown Bear mine in 1899-1902, at the Haynes-Stellite in l917-1920, and at the Uncle Sam mine in 1938-1941, During World War II, the U.S. Bureau of Mines explored in the district with bulldozer and diamond drill., and the U.S. Geological Survey mapped the district and logged the drill cores. The Howe Sound Co. also did some diamond drilling in the district, and in 1945 the Calera Mining Co., Blackbird Division (subsidiary of Howe Sound Co.), started underground development at the Calera adit. Although the district has had very little production to the present, it is believed that a large tonnage of copper-cobalt ore exists in the district which should permit mining to be continued over a long period. The report contains brief descriptions of all the accessible workings in the district, of which the most important are Calera, Brown Bear, Uncle Sam, and Hawkeye mines. In the Calera adit, about 1,700 feet of the mineralized zone, ranging in width from 3 feet to 40 feet and averaging about 15 feet; have been explored (August 1946); the zone lies on a wide northwest-striking shear zone dipping moderately ( 60° ±) northeast. The Brown Bear adit is in a wide, mineralized, north-south shear zone in which are higher-grade pods plunging 25° to 35° north. The Uncle Sam mine explores a relatively narrow north-south shear zone in which are two or three north-plunging ore shoots. The Hawkeye mine is in a broad zone of mineralized schist in which are several north-plunging lenses of ore.

Idaho↗