Geology topics

Research about Cascade Arc

Source-linked reports with geographic coverage including Cascade Arc.

3 recordsLinked to original sources

USGS2017

Volcano geodesy in the Cascade arc, USA

Experience during historical time throughout the Cascade arc and the lack of deep-seated deformation prior to the two most recent eruptions of Mount St. Helens might lead one to infer that Cascade volcanoes are generally quiescent and, specifically, show no signs of geodetic change until they are about to erupt. Several decades of geodetic data, however, tell a different story. Ground- and space-based deformation studies have identified surface displacements at five of the 13 major Cascade arc volcanoes that lie in the USA (Mount Baker, Mount St. Helens, South Sister, Medicine Lake, and Lassen volcanic center). No deformation has been detected at five volcanoes (Mount Rainier, Mount Hood, Newberry Volcano, Crater Lake, and Mount Shasta), and there are not sufficient data at the remaining three (Glacier Peak, Mount Adams, and Mount Jefferson) for a rigorous assessment. In addition, gravity change has been measured at two of the three locations where surveys have been repeated (Mount St. Helens and Mount Baker show changes, while South Sister does not). Broad deformation patterns associated with heavily forested and ice-clad Cascade volcanoes are generally characterized by low displacement rates, in the range of millimeters to a few centimeters per year, and are overprinted by larger tectonic motions of several centimeters per year. Continuous GPS is therefore the best means of tracking temporal changes in deformation of Cascade volcanoes and also for characterizing tectonic signals so that they may be distinguished from volcanic sources. Better spatial resolution of volcano deformation can be obtained through the use of campaign GPS, semipermanent GPS, and interferometric synthetic aperture radar observations, which leverage the accumulation of displacements over time to improve signal to noise. Deformation source mechanisms in the Cascades are diverse and include magma accumulation and withdrawal, post-emplacement cooling of recent volcanic deposits, magmatic-tectonic interactions, and loss of volatiles plus densification of magma. The Cascade Range thus offers an outstanding opportunity for investigating a wide range of volcanic processes. Indeed, there may be areas of geodetic change that have yet to be discovered, and there is good potential for addressing a number of important questions about how arc volcanoes work before, during, and after eruptions by continuing geodetic research in the Cascade Range.

Cascade Arc↗

USGS2017

Using mineral geochemistry to decipher slab, mantle, and crustal input in the generation of high-Mg andesites and basaltic andesites from the northern Cascade Arc

To better understand the role of slab melt in the petrogenesis of North Cascades magmas, this study focuses on petrogenesis of high-Mg lavas from the two northernmost active volcanoes in Washington. High-Mg andesites (HMA) and basaltic andesites (HMBA) in the Cascade Arc have high Mg# [molar Mg/(Mg+Fe 2+ )] relative to their SiO 2 contents, elevated Nd/Yb, and are Ni- and Cr-enriched. The rock units examined here include the Tarn Plateau HMBA (51.8–54.0 wt% SiO 2 , Mg# 68–70) and Glacier Creek HMA (58.3–58.7 wt% SiO 2 , Mg# 63–64) from the Mount Baker Volcanic Field, and the Lightning Creek HMBA (54.8–54.6 SiO 2 , Mg# 69–73) from Glacier Peak. This study combines major and trace element compositions of minerals and whole rocks to test several petrogenetic hypotheses and to determine which, if any, are applicable to North Cascades HMA and HMBA. In the Tarn Plateau HMBA, rare earth element (REE) equilibrium liquids calculated from clinopyroxene compositions have high Nd/Yb that positively correlates with Mg#. This correlation suggests an origin similar to that proposed for Aleutian adakites, where intermediate, high Nd/Yb slab-derived melts interact with the overlying mantle to become Mg-rich, and subsequently mix with low Nd/Yb, mantle-derived mafic magmas with lower Mg#. In the Glacier Creek HMA, elevated whole-rock MgO and SiO 2 contents resulted from accumulation of xenocrystic olivine and differentiation processes, respectively, but the cause of high Nd/Yb is less clear. However, high whole-rock Sr/P (fluid mobile/fluid immobile) values indicate a mantle source that was fluxed by an enriched, hydrous slab component, likely producing the observed high Nd/Yb REE signature. The Lightning Creek HMBA is a hybridized rock unit with at least three identifiable magmatic components, but only one of which has HMA characteristics. Cr and Mg contents in Cr-spinel and olivine pairs in this HMA component suggest that its source is a strongly depleted mantle, and high whole-rock Sr/P values indicate mantle melting that was induced through hydration, likely adding the component responsible for the observed high Nd/Yb REE pattern. The elevated SiO 2 contents (54.6 wt%) of the HMA component resulted from differentiation or high degrees of partial melting of ultramafic material through the addition of H 2 O. Therefore the Lightning Creek HMBA is interpreted to have originated from a refractory mantle source that underwent melting through interaction with an enriched slab component. Our results indicate that in addition to slab-derived fluids, slab-derived melts also have an important role in the production of HMA and HMBA in the north Cascade Arc.

American Mineralogist↗

USGS2015

Slab melting beneath the Cascades Arc driven by dehydration of altered oceanic peridotite

Water is returned to Earth’s interior at subduction zones. However, the processes and pathways by which water leaves the subducting plate and causes melting beneath volcanic arcs are complex; the source of the water—subducting sediment, altered oceanic crust, or hydrated mantle in the downgoing plate—is debated; and the role of slab temperature is unclear. Here we analyse the hydrogen-isotope and trace-element signature of melt inclusions in ash samples from the Cascade Arc, where young, hot lithosphere subducts. Comparing these data with published analyses, we find that fluids in the Cascade magmas are sourced from deeper parts of the subducting slab—hydrated mantle peridotite in the slab interior—compared with fluids in magmas from the Marianas Arc, where older, colder lithosphere subducts. We use geodynamic modelling to show that, in the hotter subduction zone, the upper crust of the subducting slab rapidly dehydrates at shallow depths. With continued subduction, fluids released from the deeper plate interior migrate into the dehydrated parts, causing those to melt. These melts in turn migrate into the overlying mantle wedge, where they trigger further melting. Our results provide a physical model to explain melting of the subducted plate and mass transfer from the slab to the mantle beneath arcs where relatively young oceanic lithosphere is subducted.

Cascade Arc↗