Search USGSSearch

Geology topics

Y.K. Jin

Publications and source records attributed to Y.K. Jin.

3 recordsLinked to original sources

A 100-km wide slump along the upper slope of the Canadian Arctic was likely preconditioned for failure by brackish pore water flushing

Exploration of the continental slope of the Canadian Beaufort Sea has revealed a remarkable coalescence of slide scars with headwalls between 130 and 1100 m water depth (mwd). With increased depth, the scars widen and merge into one gigantic regional slide scar that is more than 100 km wide below ~1100 mwd. To understand the development of these features, five sites were investigated with an Autonomous Underwater Vehicle, which provided 1-m bathymetric grids and Chirp profiles, and surveyed with a Remotely Operated Vehicle. The morphologies are consistent with retrograde failures that occurred on failure planes located between 30 and 75 m below the modern seafloor. At issue is whether the continental slope in this area is preconditioned for failure. While rapid sedimentation during glacial periods, and the presence of shallow gas cannot be ruled out, given the geological environment, it is unclear that they are primary preconditioning factors. Evidence of widespread flushing of the slope with brackish waters, and observed flows of brackish water within slide scars, suggest fluid venting and overpressure may play a role in the development of the extensive slope failures seen along this margin. The impact of pore water salinity changes at the depth of the failure plane on slope stability has not been considered in marine settings previously.

Arctic Sea, Canadian Beaufort Sea

Gas hydrate volume estimations on the South Shetland continental margin, Antarctic Peninsula

Multi-channel seismic data acquired on the South Shetland margin, northern Antarctic Peninsula, show that Bottom Simulating Reflectors (BSRs) are widespread in the area, implying large volumes of gas hydrates. In order to estimate the volume of gas hydrate in the area, interval velocities were determined using a 1-D velocity inversion method and porosities were deduced from their relationship with sub-bottom depth for terrigenous sediments. Because data such as well logs are not available, we made two baseline models for the velocities and porosities of non-gas hydrate-bearing sediments in the area, considering the velocity jump observed at the shallow sub-bottom depth due to joint contributions of gas hydrate and a shallow unconformity. The difference between the results of the two models is not significant. The parameters used to estimate the total volume of gas hydrate in the study area were 145 km of total length of BSRs identified on seismic profiles, 350 m thickness and 15 km width of gas hydrate-bearing sediments, and 6.3% of the average volume gas hydrate concentration (based on the second baseline model). Assuming that gas hydrates exist only where BSRs are observed, the total volume of gas hydrates along the seismic profiles in the area is about 4.8 ?? 1010 m3 (7.7 ?? 1012 m3 volume of methane at standard temperature and pressure).

Antarctic Science

Relationship of gas hydrate concentration to porosity and reflection amplitude in a research well, Mackenzie Delta, Canada

Well logs acquired at the Mallik 2L-38 gas hydrate research well. Mackenzie Delta, Canada, reveal a distinct trend showing that the resistivity of gas-hydrate-bearing sediments increases with increases in density porosities. This trend, opposite to the general trend of decrease in resistivity with porosity, implies that gas hydrates are more concentrated in the higher porosity. Using the Mallik 2L-38 well data, a proportional gas hydrate concentration (PGHC) model, which states that the gas hydrate concentration in the sediment's pore space is linearly proportional to porosity, is proposed for the general habitat of gas hydrate in sediments. Anomalous data (less than 6% of the total data) outside the dominant observed trend can be explained by local geological characteristics. The anomalous data analysis indicates that highly concentrated gas-hydrate-bearing layers would be expected where sediments have high proportions of gravel and coarse sand. Using the parameters in the PGHC model determined from resistivity-porosity logs, it is possible to qualitatively predict the degree of reflection amplitude variations in seismic profiles. Moderate-to-strong reflections are expected for the Mallik 2L-38 well. ?? 2002 Elsevier Science Ltd. All rights reserved.

Marine and Petroleum Geology