Search USGSSearch

Geology topics

William J. Lutter

Publications and source records attributed to William J. Lutter.

9 recordsLinked to original sources

Application of 2-D travel-time inversion of seismic refraction data to the mid-continent rift beneath Lake Superior

The inversion technique of Nowack and Lutter (1988a) and Lutter et al. (1990) has been applied to first arrival seismic refraction data collected along Line A of the 1986 Lake Superior GLIMPCE experiment, permitting comparison of the inversion image with an independently derived forward model (Trehu et al., 1991; Shay and Trehu, in press). For this study, the inversion method was expanded to allow variable grid spacing for the bicubic spline parameterization of velocity. The variable grid spacing improved model delineation and data fit by permitting model parameters to be clustered at features of interest. Over 800 first-arrival travel-times were fit with a final RMS error of 0.045 s. The inversion model images a low velocity central graben and smaller flanking half-grabens of the Midcontinent Rift, and higher velocity regions (+0.5 to +0.75 km/s) associated with the Isle Royale and Keweenaw faults, which bound the central graben. Although the forward modeling interpretation gives finer details associated with the near surface expression of the two faults because of the inclusion of secondary reflections and refractions that were not included in the inversion, the inversion model reproduces the primary features of the forward model.

Geophysical Research Letters

Seismic reflection/refraction mapping of faulting and regional dips in the eastern Alaska Range

We present the results of a Trans‐Alaska Crustal Transect (TACT) investigation of the upper 2–5 km of the eastern Alaska Range in the vicinity of the Denali fault based on seismic reflection/refraction data, laboratory measurements of rock velocities, and structural mapping. The Denali fault is a major dextral slip structure mappable for more than 2000 km separating the Wrangellia and adjacent terranes to the south from the Yukon‐Tanana and adjacent terranes to the north. Geologic mapping suggests over 400 km of dextral slip has occurred on the fault, yet within the upper 1.5 km of the crust along the TACT corridor, basement rocks juxtaposed along the Denali fault reveal no significant seismic velocity differences, although the fault zone itself is associated with a minor lowering of velocity. The lack of seismic velocity contrast adjacent to the fault is in agreement with laboratory measurements of elastic wave velocities of samples from terranes bordering the fault. Laboratory measurements of elastic wave velocities of the metasedimentary mica‐quartz schists comprising the Yukon‐Tanana basement are highly anisotropic because of preferred orientation of mica and predict significant variations in velocity accompanying variations in foliation dip. Although other interpretations are possible, the northward shallowing of foliation dip of basement rocks in the Yukon‐Tanana terrane combined with the strong anisotropy associated with these highly foliated rocks can explain an observed northward increase in seismic velocity within this terrane. Seismic reflections from basement rocks within the Yukon‐Tanana terrane may originate from variations in anisotropy with depth and/or changes in composition reflecting different proportions of sandstone and shale in the protolith.

Alaska

Surface seismic and electrical methods to detect fluids related to faulting

In the absence of drilling, surface-based geophysical methods are necessary to observe fault zones and fault zone physical properties at seismogenic depths. These in situ physical properties can then be used to infer the presence and distribution of fluids along faults, although such observations are by nature indirect and become less exact with greater depth. Multiple observations of a range of such geophysical properties as compressional and shear seismic velocity ( V p and V s ), V p /V5 ratio (related to Poisson's ratio), resistivity and attenuation in and adjacent to fault zones offer the greatest hope of making inferences of the fault zone geometry, fluids in the fault zone, and fluid reservoirs in the surrounding crust. For simple geometries, fault zone guided waves can provide information on fault zone width and velocities for faults of the order of 200 m wide. To address the question of whether a narrow fault zone can be imaged well enough at depths of seismic rupture to infer the presence of anomalously high fluid/rock ratios, we present synthetic seismic tomography and magnetotelluric examples for an ideal case of a narrow fault zone with a simple geometry, large changes in material properties, and numerous earthquakes within the fault zone. A synthetic 0.5-km wide fault zone with 20% velocity reduction is well imaged using local earthquake tomography. When sequential velocity inversions are done, the true fault width is found, even to 9 km depth, although the calculated amplitude of the velocity reduction is lower than the actual amplitude. V p / V s is as well determined as V p . Magnetotelluric imaging of a synthetic fault zone shows that a conductive fault zone can be well imaged within the upper 10 km. Further, a narrow (1 km) very low resistivity (3 ohm m) fault core can be imaged within a broad (5 km) low resistivity (10 ohm m) fault zone, illustrating that regions of a fault containing large quantities of interconnected fluids within a broader, conductive fault zone should be detectable. Thus variations in fluid content and fluid pressure can be inferred from electrical and seismic methods but there will always be uncertainty in these inferences due to the trade-off with other factors, such as intrinsic variations in porosity, mineralogy, and pore geometry. The best approach is combined modeling of varied seismic and electrical data.

Journal of Geophysical Research Solid Earth

Report for borehole explosion data acquired in the 1999 Los Angeles Region Seismic Experiment (LARSE II), Southern California: Part I, description of the survey

The Los Angeles Region Seismic Experiment (LARSE) is a joint project of the U.S. Geological Survey (USGS) and the Southern California Earthquake Center (SCEC). The purpose of this project is to produce seismic images of the subsurface of the Los Angeles region down to the depths at which earthquakes occur, and deeper, in order to remedy a deficit in our knowledge of the deep structure of this region. This deficit in knowledge has persisted despite over a century of oil exploration and nearly 70 years of recording earthquakes in southern California. Understanding the deep crustal structure and tectonics of southern California is important to earthquake hazard assessment. Specific imaging targets of LARSE include (a) faults, especially blind thrust faults, which cannot be reliably detected any other way; and (b) the depths and configurations of sedimentary basins. Imaging of faults is important in both earthquake hazard assessment but also in modeling earthquake occurrence. Earthquake occurrence cannot be understood unless the earthquake-producing "machinery" (tectonics) is known (Fuis and others, 2001). Imaging the depths and configurations of sedimentary basins is important because earthquake shaking at the surface is enhanced by basin depth and by the presence of sharp basin edges (Wald and Graves, 1998, Working Group on California Earthquake Probabilities, 1995; Field and others, 2001). (Sedimentary basins are large former valleys now filled with sediment eroded from nearby mountains.) Sedimentary basins in the Los Angeles region that have been investigated by LARSE include the Los Angeles, San Gabriel Valley, San Fernando Valley, and Santa Clarita Valley basins. The seismic imaging surveys of LARSE include recording of earthquakes (both local and distant earthquakes) along several corridors (or transects) through the Los Angeles region and also recording of man-made sources along these same corridors. Man-made sources have included airguns offshore and borehole explosions and vibrating-truck sources onshore. The two chief LARSE transects pass near recent moderate earthquakes, including the 1971 M 6.7 San Fernando, 1987 M 5.9 Whittier Narrows, 1991 M 5.8 Sierra Madre, and 1994 M 6.7 Northridge earthquakes. The first transect extended from San Clemente Island northeastward to the Mojave Desert (Line 1, Fig. 1), passing near the epicenter of the Whittier Narrows and Sierra Madre earthquakes. The second transect extended from west of San Clemente Island northward to the western Mojave Desert (Line 2, Figs. 1, 2), passing through the epicenter of the Northridge earthquake and near the epicenter of the San Fernando earthquake. Data along Line 1 were acquired during the years 1993-1994, and data along Line 2, during the years 1994–2000. In this open-file report and that of Murphy and others (in preparation), we present the details of the October 1999 explosion survey along Line 2, which extended from Santa Monica Bay northward to the western Mojave Desert (Figs. 1, 2). This survey is referred to as LARSE II. In this survey, 93 borehole explosions were detonated along the main north-south line and along 5 auxiliary lines in the San Fernando Valley and Santa Monica areas. These explosions were recorded by ~1400 seismographs. A variety of seismic instrumentation was used in these imaging surveys and was obtained from collaborators from around the world, including the Geological Survey of Canada (Ottawa, Canada), IRIS/PASSCAL (Socorro, NM), Lamont-Doherty Earth Observatory (Palisades, NY), Stanford University (Stanford, CA), SCEC (Los Angeles, CA), USGS (Menlo Park, CA, and Woods Hole, MA), University of Texas at El Paso (El Paso, TX), GeoForschungsZentrum (Potsdam, Germany), University of Karlsruhe (Karlsruhe, Germany), and University of Copenhagen (Copenhagen, Denmark). The reader is referred to Table 1 for instrumentation used in LARSE II.

California

The "LARSE" Project - Working Toward a Safer Future for Los Angeles

The Los Angeles region is underlain by a network of active faults, including many that are deep and do not break the Earth's surface. These hidden faults include the previously unknown one responsible for the devastating January 1994 Northridge earthquake, the costliest quake in U.S. history. So that structures can be built or strengthened to withstand the quakes that are certain in the future, the Los Angeles Region Seismic Experiment (LARSE) is locating hidden earthquake hazards beneath the region to help scientists determine where the strongest shaking will occur.

California

El Proyecto Sismico "LARSE" - Trabajando Hacia un Futuro con Mas Seguridad para Los Angeles

La region de Los Angeles contiene una red de fallas activas, incluyendo muchas fallas por empuje que son profundas y no rompen la superficie de la tierra. Estas fallas ocultas incluyen la falla anteriormente desconocida que fue responsable por la devastacion que ocurrio durante el terremoto de Northridge en enero de 1994, el terremoto mas costoso en la historia de los Estados Unidos. El Experimento Sismico en la Region de Los Angeles (Los Angeles Region Seismic Experiment, LARSE), esta localizando los peligros ocultos de los terremotos debajo de la region de Los Angeles para mejorar la construccion de las estructuras que pueden apoyar terremotos que son inevitables en el futuro, y que ayudaran a los cientificos determinar donde occurira el sacudimento mas fuerte y poderoso.

Fact Sheet

Crustal velocity structure of the northern Yukon-Tanana upland, central Alaska: Results from TACT refraction/wide-angle reflection data

The Fairbanks North seismic refraction/ wide-angle reflection profile, collected by the U.S. Geological Survey Trans-Alaska Crustal Transect (TACT) project in 1987, crosses the complex region between the Yukon-Tanana and Ruby terranes in interior Alaska. This region is occupied by numerous small terranes elongated in a northeast-southwest direction. These seismic data reveal a crustal velocity structure that is divided into three upper-crustal and at least two middle- to lower-crustal domains. The upper-crustal domains are delineated by two steeply dipping low-velocity anomalies that are interpreted as signatures of the Victoria Creek fault, and the Beaver Creek fault or a fault buried by the Beaver Creek fault. This tripartite upper crust extends to 8-10 km depth where a subhorizontal interface undercuts the northern and central domains. Beneath the northern domain, this interface is interpreted as the southeastwardly dipping boundary between the Tozina and Ruby terranes. The continuation of this interface beneath the central domain suggests that it may represent the detachment or basal thrust for thin-skinned tectonic amalgamation of the terranes caught between the Yukon-Tanana and Ruby terranes. The lower crust and Moho reflection exhibit differences from north to south that define at least two lower-crustal domains, interpreted as the Yukon-Tanana and Ruby terranes. Finally, the crustal thickness along the profile is nearly uniform and ranges from 31 to 34 km. Our data suggest that after initial thin-skinned amalgamation of the various terranes, this region experienced thick-skinned tectonic reorganization via strike-slip faulting. This interpretation supports a model in which at least one strand of the Tintina fault exists in this important region of Alaska.

Alaska

Large-explosive source, wide-recording aperture, seismic profiling on the Columbia Plateau, Washington

Clear subsurface seismic images have been obtained at low cost on the Columbia Plateau, Washington. The Columbia Plateau is perhaps the most notorious of all 'bad-data' areas because large impedance contrasts in surface flood basalts severely degrade the seismic wavefield. This degradation was mitigated in this study via a large-explosive source, wide-recording aperture shooting method.The shooting method emphasizes the wide-angle portion of the wavefield, where Fermat's principle guarantees reverberation will not interfere with the seismic manifestations of crucial geologic interfaces. The basalt diving wave, normally discarded in standard common midpoint (CMP) seismic profiling, can be used to image basalt velocity structure via traveltime inversion. Maximum depth-penetration of the diving wave tightly constrains basalt-sediment interface depth. An arrival observed only at shot-receiver offsets greater than 15 km can be used to determine the velocity and geometry of basement via simultaneous inversion.The results from this study suggest that previous geologic hypotheses and hydrocarbon play concepts for the Columbia Plateau may have been in error.

Geophysics

An image of the Columbia Plateau from inversion of high‐resolution seismic data

We use a method of traveltime inversion of high‐resolution seismic data to provide the first reliable images of internal details of the Columbia River Basalt Group (CRBG), the subsurface basalt/sediment interface, and the deeper sediment/basement interface. Velocity structure within the basalts, delineated on the order of 1 km horizontally and 0.2 km vertically, is constrained to within ±0.1 km/s for most of the seismic profile. Over 5000 observed traveltimes fit our model with an rms error of 0.018 s. The maximum depth of penetration of the basalt diving waves (truncated by underlying low‐velocity sediments) provides a reliable estimate of the depth to the base of the basalt, which agrees with well‐log measurements to within 0.05 km (165 ft). We use image blurring, calculated from the resolution matrix, to estimate the aspect ratio of imaged velocity anomaly widths to true widths for velocity features within the basalt. From our calculations of image blurring, we interpret low velocity zones (LVZ) within the basalts at Boylston Mountain and the Whiskey Dick anticline to have widths of 4.5 and 3 km, respectively, within the upper 1.5 km of the model. At greater depth, the widths of these imaged LVZs thin to approximately 2 km or less. We interpret these linear, subparallel, low‐velocity zones imaged adjacent to anticlines of the Yakima Fold Belt to be brecciated fault zones. These fault zones dip to the south at angles between 15 to 45 degrees.

Geophysics