Search USGSSearch

Geology topics

Weijun Gan

Publications and source records attributed to Weijun Gan.

6 recordsLinked to original sources

Slip maxima at fault junctions and rupturing of barriers during the 2008 Wenchuan earthquake

The disastrous 12 May 2008 Wenchuan earthquake in China took the local population as well as scientists by surprise. Although the Longmen Shan fault zonewhich includes the fault segments along which this earthquake nucleatedwas well known, geologic and geodetic data indicate relatively low (<3 mm yr -1 ) deformation rates. Here we invert Global Positioning System and Interferometric Synthetic Aperture Radar data to infer fault geometry and slip distribution associated with the earthquake. Our analysis shows that the geometry of the fault changes along its length: in the southwest, the fault plane dips moderately to the northwest but becomes nearly vertical in the northeast. Associated with this is a change in the motion along the fault from predominantly thrusting to strike-slip. Peak slip along the fault occurs at the intersections of fault segments located near the towns of Yingxiu, Beichuan and Nanba, where fatalities and damage were concentrated. We suggest that these locations represent barriers that failed in a single event, enabling the rupture to cascade through several fault segments and cause a major moment magnitude (M w ) 7.9 earthquake. Using coseismic slip distribution and geodetic and geological slip rates, we estimate that the failure of barriers and rupture along multiple segments takes place approximately once in 4,000 years. ?? 2009 Macmillan Publishers Limited. All rights reserved.

Nature Geoscience

Strain accumulation across the Coast Ranges at the latitude of San Francisco, 1994-2000

A 66-monument geodetic array spanning the Coast Ranges near San Francisco has been surveyed more than eight times by GIPS between late 1993 and early 2001. The measured horizontal velocities of the monuments are well represented by uniform, right-lateral, simple shear parallel to N29°W. (The local strike of the San Andreas Fault is ∼N34°W.) The observed areal dilatation rate of 6.9 ± 10.0 nstrain yr −1 (quoted uncertainty is one standard deviation and extension is reckoned positive) is not significantly different from zero, which implies that the observed strain accumulation could be released by strike-slip faulting alone. Our results are consistent with the slip rates assigned by the Working Group on California Earthquake Probabilities [2003] to the principal faults (San Gregorio, San Andreas, Hayward-Rodgers Creek, Calaveras-Concord-Green Valley, and Greenville Faults) cutting across the GPS array. The vector sum of those slip rates is is 39.8 ± 2.6 mm yr −1 N29.8°W ± 2.8°, whereas the motion across the GPS array (breadth 120 km) inferred from the uniform strain rate approximation is 38.7 ± 1.2 mm yr −1 N29.0°W ± 0.9° right-lateral shear and 0.4 ± 0.9 mm yr −1 N61°E ± 0.9° extension. We interpret the near coincidence of these rates and the absence of significant accumulation of areal dilatation to imply that right-lateral slip on the principal faults can release the accumulating strain; major strain release on reverse faults subparallel to the San Andreas Fault within the Coast Ranges is not required.

California

Initiation of deformation of the Eastern California Shear Zone: Constraints from Garlock fault geometry and GPS observations

We suggest a 2-stage deformation model for the Eastern California Shear Zone (ECSZ) to explain the geometry of the Garlock fault trace. We assume the Garlock fault was originally straight and then was gradually curved by right-lateral shear deformation across the ECSZ. In our 2-stage deformation model, the first stage involves uniform shear deformation across the eastern part of the shear zone, and the second stage involves uniform shear deformation across the entire shear zone. In addition to the current shape of the Garlock fault, our model incorporates constraints on contemporary deformation rates provided by GPS observations. We find that the best fitting age for initiation of shear in eastern part of the ECSZ is about 5.0 ?? 0.4 Ma, and that deformation of the western part started about 1.6 Myr later.

Geophysical Research Letters

Strain accumulation and rotation in the Eastern California Shear Zone

Although the Eastern California Shear Zone (ECSZ) (strike ∼N25°W) does not quite coincide with a small circle drawn about the Pacific-North America pole of rotation, trilateration and GPS measurements demonstrate that the motion within the zone corresponds to right-lateral simple shear across a vertical plane (strike N33°W±5°) roughly parallel to the tangent to that local small circle (strike ∼N40°W). If the simple shear is released by slip on faults subparallel to the shear zone, the accumulated rotation is also released, leaving no secular rotation. South of the Garlock fault the principal faults (e.g., Calico-Blackwater fault) strike ∼N40°W, close enough to the strike of the vertical plane across which maximum right-lateral shear accumulates to almost wholly accommodate that accumulation of both strain and rotation by right-lateral slip. North of the Garlock fault dip slip as well as strike slip on the principal faults (strike ∼N20°W) is required to accommodate the simple shear accumulation. In both cases the accumulated rotation is released with the shear strain. The Garlock fault, which transects the ECSZ, is not offset by north-northwest striking faults nor, despite geological evidence for long-term left-lateral slip, does it appear at the present time to be accumulating left-lateral simple shear strain across the fault due to slip at depth. Rather the motion is explained by right-lateral simple shear across the orthogonal ECSZ. Left-lateral slip on the Garlock fault will release the shear strain accumulating there but would augment the accumulating rotation, resulting in a secular clockwise rotation rate ∼80 nrad yr −1 (4.6° Myr −1 ).

California

Crustal deformation rates in Central and Eastern U.S. inferred from GPS

Analysis of continuous GPS observations between 1996 and 2000 at 62 stations distributed throughout the central and eastern United States suggests that the area is generally stable. Seven of the 62 stations show anomalous velocities, but there is reason to suspect their monument stability. Assuming the remaining 55 stations are stable with respect to interior North America, we have found the North America-ITRF97 Euler vector (-1.88 o ± 1.04 o N, 77.67 o ± 0.39 o W, 0.201 o ± 0.004 o Myr -1 ) that minimizes the RMS station velocity. Referred to fixed North America, all of these velocities are less than 3.2 mm yr-1. Motion of several stations suggests the Mississippi embayment may be moving southward away from the rest of the continent at a rate of 1.7±0.9 mm yr -1 . The motion of the embayment produces a large gradient in velocity which, in turn, implies the highest seismic moment accumulation rate that we found. Although the highest rate is only marginally significant, the fact that it occurs near New Madrid, where earthquake risk is thought to be high, argues that the anomaly may be real. Nevertheless, the identification of the anomaly remains tentative.

Geophysical Research Letters

Strain accumulation across the Eastern California Shear Zone at latitude 36°30'N

The motion of a linear array of monuments extending across the Eastern California Shear Zone (ECSZ) has been measured from 1994 to 1999 with the Global Positioning System. The linear array is oriented N54&deg;E, perpendicular to the tangent to the local small circle drawn about the Pacific-North America pole of rotation, and the observed motion across the ECSZ is approximated by differential rotation about that pole. The observations suggest uniform deformation within the ECSZ (strike N23&deg;W) (26 nstrain yr &minus;1 extension normal to the zone and 39 nstrain yr &minus;1 simple right-lateral shear across it) with no significant deformation in the two blocks (the Sierra Nevada mountains and southern Nevada) on either side. The deformation may be imposed by right-lateral slip at depth on the individual major fault systems within the zone if the slip rates are: Death Valley-Furnace Creek fault 3.2&plusmn;0.9 mm yr &minus;1 , Hunter Mountain-Panamint Valley fault 3.3&plusmn;1.6 mm yr &minus;1 , and Owens Valley fault 6.9&plusmn;1.6 mm yr &minus;1 . However, this estimate of the slip rate on the Owens Valley fault is 3 times greater than the geologic estimate.

Journal of Geophysical Research B: Solid Earth