Geology topics

W. Sanford

Publications and source records attributed to W. Sanford.

7 recordsLinked to original sources

USGS2013

Case study Middle Rio Grande Basin, New Mexico, USA

Chemical and isotopic patterns in groundwater can record characteristics of water sources, flow directions, and groundwater-age information. This hydrochemical information can be useful in refining conceptualization of groundwater flow, in calibration of numerical models of groundwater flow, and in estimation of paleo and modern recharge rates. This case study shows how chemical and isotopic data were used to characterize sources and flow of groundwater in the Middle Rio Grande Basin (MRGB) of New Mexico, USA. The 14 C model ages of the groundwater samples are on the tens of thousands of year timescale. These data changed some of the prevailing ideas about flow in the MRGB, and were used to improve a numerical model of the aquifer system.

New Mexico↗

USGS2013

Numerical flow models and their calibration using tracer based ages

Any estimate of ‘age’ of a groundwater sample based on environmental tracers requires some form of geochemical model to interpret the tracer chemistry (chapter 3) and is, therefore, referred to in this chapter as a tracer model age. the tracer model age of a groundwater sample can be useful for obtaining information on the residence time and replenishment rate of an aquifer system, but that type of data is most useful when it can be incorporated with all other information that is known about the groundwater system under study. groundwater fl ow models are constructed of aquifer systems because they are usually the best way of incorporating all of the known information about the system in the context of a mathematical framework that constrains the model to follow the known laws of physics and chemistry as they apply to groundwater flow and transport. It is important that the purpose or objective of the study be identified first before choosing the type and complexity of the model to be constructed, and to make sure such a model is necessary. The purpose of a modelling study is most often to characterize the system within a numerical framework, such that the hydrological responses of the system can be tested under potential stresses that might be imposed given future development scenarios. As this manual discusses dating as it applies to old groundwater, most readers are likely to be interested in studying regional groundwater flow systems and their water resource potential.

Book chapter↗

USGS2007

A new focus on groundwater-seawater interactions

In summary, the papers in this volume present research by those working from the marine and the terrestrial sides of issues related to SGD and groundwater-seawater interactions. The first part of this paper provides an introduction and background information on the subject of SGD and groundwater-seawater interactions. The second part of this paper provides an overview of the 38 symposium papers and places them in context according to the methods used to quantify SGD. The papers presented in this volume describe important contributions to the literature and document a variety of investigative approaches applied over a range of conditions at locations across the globe.

Conference Paper↗

USGS2003

Heat flow and brine generation following the Chesapeake Bay bolide impact

Calculations indicate that the impact of an asteroid or comet on the Atlantic Coastal Plain 35 million years ago created subsequent hydrothermal activity and conditions suitable for phase separation and the creation of the brine observed in the groundwater at the site today. A calculation of groundwater velocity using Darcy's law suggests flow rates are insufficient to have moved the water out of the crater within 35 million years. A similar calculation using Pick's law demonstrates that solutes cannot have escaped by molecular diffusion since the impact. Simulations from other investigators using shock-physics codes indicate that the crust would have been vaporized or melted down to at least 2 km at the time of impact. Based on these calculations, a simulation of heat conduction was made assuming a 1000 ??C initial crustal temperature. The hot crust acted as a heat source, with temperatures peaking in the overlying sediment about 10,000 years later. The pressure and temperature conditions within the sediment during that time would have been favorable for phase separation and generation of a residual brine, which may be found today in the inner crater. ?? 2003 Elsevier Science B.V. All rights reserved.

Conference Paper↗

USGS2002

Recharge and groundwater models: An overview

Recharge is a fundamental component of groundwater systems, and in groundwater-modeling exercises recharge is either measured and specified or estimated during model calibration. The most appropriate way to represent recharge in a groundwater model depends upon both physical factors and study objectives. Where the water table is close to the land surface, as in humid climates or regions with low topographic relief, a constant-head boundary condition is used. Conversely, where the water table is relatively deep, as in drier climates or regions with high relief, a specified-flux boundary condition is used. In most modeling applications, mixed-type conditions are more effective, or a combination of the different types can be used. The relative distribution of recharge can be estimated from water-level data only, but flux observations must be incorporated in order to estimate rates of recharge. Flux measurements are based on either Darcian velocities (e.g., stream base-flow) or seepage velocities (e.g., groundwater age). In order to estimate the effective porosity independently, both types of flux measurements must be available. Recharge is often estimated more efficiently when automated inverse techniques are used. Other important applications are the delineation of areas contributing recharge to wells and the estimation of paleorecharge rates using carbon-14.

Hydrogeology Journal↗

USGS2000

Numerical modelling of geothermal and reflux circulation in Enewetak Atoll: Implications for dolomitization

Two types of regional-scale seawater circulation have been proposed to explain the formation of Enewetak Atoll dolomites: geothermal and reflux circulation. We have used a finite element groundwater flow model to examine the pattern, magnitude and dynamic interaction of these two different circulation mechanisms in Enewetak Atoll. Geothermal circulation is concentrated around the atoll-margin whereas refluxing mesosaline brines flow from the atoll interior towards the margin to restrict and eventually shut off geothermal circulation. Refluxing brines of 36-80??? can account for the salinity signature recorded in dolomite fluid inclusions. Distributions of fluid flux and Mg mass-balance calculations suggest that both geothermal and reflux circulation mechanisms could account for the observed distribution of dolomite in Enewetak Atoll. Furthermore, the atoll interior may be extensively dolomitized as observed in other atolls. (C) 2000 Elsevier Science B.V. All rights reserved.Two types of regional-scale seawater circulation have been proposed to explain the formation of Enewetak Atoll dolomites: geothermal and reflux circulation. We have used a finite element groundwater flow model to examine the pattern, magnitude and dynamic interaction of these two different circulation mechanisms in Enewetak Atoll. Geothermal circulation is concentrated around the atoll-margin whereas refluxing mesosaline brines flow from the atoll interior towards the margin to restrict and eventually shut off geothermal circulation. Refluxing brines of 36-80 per mil can account for the salinity signature recorded in dolomite fluid inclusions. Distributions of fluid flux and Mg mass-balance calculations suggest that both geothermal and reflux circulation mechanisms could account for the observed distribution of dolomite in Enewetak Atoll. Furthermore, the atoll interior may be extensively dolomitized as observed in other atolls.

Conference Paper↗

USGS2000

Geothermal convection: a mechanism for dolomitization at Enewetak Atoll?

Geothermal convection in carbonate platforms could drive massive dolomitization by supplying mass transport of magnesium over long periods and at temperatures high enough to overcome kinetic limitations. Reactive-transport simulations based on Enewetak Atoll show dolomitization in a thin band at a permeability contrast near the base of the platform, which is consistent with field observations of dolomitized Eocene deposits. Dolomitization is predicted at approximately 6% per My at temperatures of 45–60°C, and complete dolomitization could be accomplished in ∼16 My. Calcium enrichment of pore fluids and upward transport of these fluids is established early, prior to 30 ky.

Book↗