Search USGS⌕ Search

Geology topics

W. D. Stanley

Publications and source records attributed to W. D. Stanley.

At least 19 recordsLinked to original sources
USGS2012

Electrical structure of Newberry Volcano, Oregon

From the interpretation of magnetotelluric, transient electromagnetic, and Schlumberger resistivity soundings, the electrical structure of Newberry Volcano in central Oregon is found to consist of four units. From the surface downward, the geoelectrical units are (1) very resistive, young, unaltered volcanic rock, (2) a conductive layer of older volcanic material composed of altered tuffs, (3) a thick resistive layer thought to be in part intrusive rocks, and (4) a lower-crustal conductor. This model is similar to the regional geoelectrical structure found throughout the Cascade Range. Inside the caldera, the conductive second layer corresponds to the steep temperature gradient and alteration minerals observed in the USGS Newberry 2 test hole. Drill hole information on the south and north flanks of the volcano (test holes GEO N-1 and GEO N-3, respectively) indicates that outside the caldera the conductor is due to alteration minerals (primarily smectite) and not high-temperature pore fluids. On the flanks of Newberry the conductor is generally deeper than inside the caldera, and it deepens with distance from the summit. A notable exception to this pattern is seen just west of the caldera rim, where the conductive zone is shallower than at other flank locations. The volcano sits atop a rise in the resistive layer, interpreted to be due to intrusive rocks. The intrusive material has served as a heat source to produce enhanced hydrothermal alteration and, perhaps in the case of the west-flank anomaly, elevated fluid temperatures. While no public drill hole information is available to confirm this hypothesis, the west-flank anomaly appears to be a good geothermal target. In addition to the possibility that a region on the west side of the volcano could be favorable for prospecting, part of the resistive structure under the center of the volcano could be due to a vapor-dominated environment with temperatures above 300°C. In other parts of the Cascades, pervasive alteration has produced mixed layer clays and zeolites, resulting in low-resistivity anomalies. Low resistivities cannot be assumed to indicate high-temperature pore fluids. The use of electrical methods that measure resistivity as a function of excitation frequency, such as spectral induced polarization, may provide a way of obtaining information about the type and extent of alteration.

Journal of Geophysical Research Solid Earth↗
USGS1999

Active tectonics of the Seattle fault and central Puget sound, Washington - Implications for earthquake hazards

We use an extensive network of marine high-resolution and conventional industry seismic-reflection data to constrain the location, shallow structure, and displacement rates of the Seattle fault zone and crosscutting high-angle faults in the Puget Lowland of western Washington. Analysis of seismic profiles extending 50 km across the Puget Lowland from Lake Washington to Hood Canal indicates that the west-trending Seattle fault comprises a broad (4–6 km) zone of three or more south-dipping reverse faults. Quaternary sediment has been folded and faulted along all faults in the zone but is clearly most pronounced along fault A, the northernmost fault, which forms the boundary between the Seattle uplift and Seattle basin. Analysis of growth strata deposited across fault A indicate minimum Quaternary slip rates of about 0.6 mm/yr. Slip rates across the entire zone are estimated to be 0.7–1.1 mm/yr.

Washington↗
USGS1998

Tectonic controls on magmatism in the Geysers-Clear Lake region: Evidence from new geophysical models

In order to study magmatism and geothermal systems in The Geysers–Clear Lake region, we developed a detailed three-dimensional tomographic velocity model based on local earthquakes. This high-resolution model resolves the velocity structure of the crust in the region to depths of approximately 12 km. The most significant velocity contrasts in The Geysers–Clear Lake region occur in the steam production area, where high velocities are associated with a Quaternary granitic pluton, and in the Mount Hannah region, where low velocities occur in a 5-km-thick section of Mesozoic argillites. In addition, a more regional tomographic model was developed using traveltimes from earthquakes covering most of northern California. This regional model sampled the whole crust, but at a lower resolution than the local model. The regional model outlines low velocities at depths of 8–12 km in The Geysers–Clear Lake area, which extend eastward to the Coast Range thrust. These low velocities are inferred to be related to unmetamorphosed Mesozoic sedimentary rocks. In addition, the regional velocity model indicates high velocities in the lower crust beneath the Clear Lake volcanic field, which we interpret to be associated with mafic underplating. No large silicic magma chamber is noted in either the local or regional tomographic models. A three-dimensional gravity model also has been developed in the area of the tomographic imaging. Our gravity model demonstrates that all density contrasts can be accounted for in the upper 5–7 km of the crust. Two-dimensional magnetotelluric models of data from a regional, east-west profile indicate high resistivities associated with the granitic pluton in The Geysers production area and low resistivities in the low-velocity section of Mesozoic argillites near Mount Hannah. No indication of midcrustal magma bodies is present in the magnetotelluric data. On the basis of heat flow and geologic evidence, Holocene intrusive activity is thought to have occurred near the Northwest Geysers, Mount Hannah, Sulphur Bank Mine, and perhaps other areas. The geophysical data provide no conclusive evidence for such activity, but the detailed velocity model is suggestive of intrusive activity near Mount Hannah similar to that in the “felsite” of The Geysers production area. The geophysical models, seismicity patterns, distribution of volcanic vents, heat flow, and other data indicate that small, young intrusive bodies that were injected along a northeast trend from The Geysers to Clear Lake probably control the thermal regime.

Geological Society of America Bulletin↗
USGS1996

Tectonics and seismicity of the southern Washington Cascade range

Geophysical, geological, and seismicity data are combined to develop a transpressional strain model for the southern Washington Cascades region. We use this model to explain oblique fold and fault systems, transverse faults, and a linear seismic zone just west of Mt. Rainier known as the western Rainier zone. We also attempt to explain a concentration of earthquakes that connects the northwest-trending Mount St. Helens seismic zone to the north-trending western Rainier zone. Our tectonic model illustrates the pervasive effects of accretionary processes, combined with subsequent transpressive forces generated by oblique subduction, on Eocene to present crustal processes, such as seismicity and volcanism.

Washington↗
USGS1996

Axial structures within the Reelfoot Rift delineated with magnetotelluric surveys

In the winter of 1811-12, three of the largest historic earthquakes in the United States occurred near New Madrid, Mo. Seismicity continues to the present day throughout a tightly clustered pattern of epicenters centered on the bootheel of Missouri, including parts of northeastern Arkansas, northwestern Tennessee, western Kentucky, and southern Illinois. In 1990, the New Madrid seismic zone/Central United States became the first seismically active region east of the Rocky Mountains to be designated a priority research area within the Natural Earthquake Hazards Reduction Program (NEHRP). This Professional Paper is a collection of papers, some published separately, presenting results of the newly intensified research program in this area. Major components of this research program include tectonic framework studies, seismicity and deformation monitoring and modeling, improved seismic hazard and risk assessments, and cooperative hazard mitigation studies.

Professional Paper↗
USGS1995

The Geysers-Clear Lake geothermal area, California - An updated geophysical perspective of heat sources

The Geysers-Clear Lake geothermal area encompasses a large dry-steam production area in The Geysers field and a documented high-temperature, high-pressure, water-dominated system in the area largely south of Clear Lake, which has not been developed. Both systems have been extensively studied with geophysical techniques, drilling, and geological mapping during the past 20 years. An updated view is presented of the geological/geophysical complexities of the crust in The Geysers-Clear Lake region in order to address key unanswered questions about the heat source and tectonics. Early geophysical interpretations used a gravity low centered in the area between Clear Lake and The Geysers to suggest that a large magma chamber existed at depths starting at about 7 km. This first-order assumption of a large magma chamber expressed in the gravity data was used as a guide in subsequent geophysical and geological interpretations. Drill-hole temperature evidence is strongly suggestive of a shallow, hot-intrusive body, but in this paper the complexities are documented of the geological and geophysical data sets that make it difficult to pinpoint the location of “magma” or hot, solidified intrusive material. Forward modeling, multidimensional inversions, and ideal body analysis of the gravity data, new electromagnetic sounding models, and arguments made from other geophysical data sets suggest that many of the geophysical anomalies have significant contributions from rock property and physical state variations in the upper 7 km and not from ”magma“ at greater depths. Regional tectonic and magmatic processes are analyzed to develop an updated scenario for pluton emplacement that differs substantially from earlier interpretations. In addition, a rationale is outlined for future exploration for geothermal resources in The Geysers-Clear Lake area.

Geothermics↗
USGS1993

New geophysical models related to heat sources in the geysers-clear lake region, California

We present an updated view of the geological and geophysical complexities of the upper crust in The Geysers-Clear Lake region in order to provide additional information regarding local structures and possible heat sources. New models and ideal-body analysis of the gravity data, new electromagnetic sounding models, and arguments made from other geophysical data sets suggest that many of the geophysical anomalies may be significantly affected by rock-property and physical-state variations in the upper 7 km, and not just to 'magma' at greater depths. We developed the new geophysical models in order to better understand constraints on the location of magma bodies.

Conference Paper↗
USGS1992

The southern Washington Cascades conductor: A previously unrecognized thick sedimentary sequence?

Geophysical studies in the southern Washington Cascades have outlined a possible, previously unrecognized sequence of sedimentary rocks. These postulated sedimentary units are interpreted to correspond to at least the upper section of a low-resistivity (high-conductivity) assemblage of rocks at depths of 1-10 km and with thicknesses up to 15 km that called the southern Washington Cascades conductor. Structure on the upper surface of this conductive assemblage correlates in some places with anticlines that bring Tertiary marine rocks near the surface. The geometry of the conductive rocks consists of a east-dipping, low-angle wedge that thickens to the north and with an undulating upper surface corresponding to the anticlines. Geothermal fluids may be a contributing factor to low resistivities in the deeper parts of the conductive section. -from Authors

Washington↗
USGS1990

The Denali fault system and Alaska Range of Alaska: Evidence for underplated Mesozoic flysch from magnetotelluric surveys

Regional magnetotelluric surveys recently completed across the central and eastern Alaska Range of Alaska provide evidence for large volumes of conductive rocks beneath the core of the range. These conductive rocks may represent a formerly extensive, but now collapsed, Mesozoic flysch basin formed on the leading edge of the Talkeetna superterrane (amalgamated Wrangellia, Peninsular, and Alexander terranes). The docking of the Talkeetna superterrane caused large-scale oblique thrusting, folding, and metamorphism in the flysch basin, and formation of a megasuture along which the Cenozoic strike-slip Denali fault system developed. The deep magnetotelluric soundings and seismic reflection data suggest the possibility that the highly conductive rocks were tectonically emplaced beneath the thin crystalline sheet constituting the southern Yukon-Tanana terrane over a broad region of the Alaska Range. The conductive rocks are locally correlated with surface outcrops of Mesozoic black shales that are part of Upper Jurassic and Cretaceous flysch but may be composed of Paleozoic carbonaceous shales as well. In either case, their extremely low resistivities make them a valuable marker horizon for tectonic studies. The conductive rocks are interpreted to extend to depths of greater than 20 km and were mapped north and northeast of the Denali fault for more than 50 km. The magnetotelluric surveys represent the first large-scale surveys done in Alaska, but the structures mapped are similar to those observed in large, compressed flysch basins in the eastern Alps and Carpathian Mountains of Europe. The results of these surveys bear on several key tectonic questions, including development of the ancestral Denali fault, and collapse and possible underplating of an extensive Mesozoic flysch system and associated igneous arc.

Alaska↗
USGS1989

Comparison of geoelectrical/tectonic models for suture zones in the western U.S.A. and eastern Europe: are black shales a possible source of high conductivities?

Large-scale geoelectrical anomalies have been mapped with geomagnetic depth sounding (GDS) and magnetotelluric (MT) surveys in the Carpathian Mountains region. These anomalies are associated with the zone of closure between stable Europe and a complex of microplates in front of the converging African plate. The zone of closure, or suture zone, is largely occupied by an extensive deformed flysch belt. The models derived to fit the observed geoelectrical data are useful in the study of other suture zones, and Carpathian structures have been compared with areas currently being studied in the western Cordillera of the U.S.A. Models derived for a smaller-scale suture zone mapped in western Washington State have features that are similar to the Carpathian models. The geoelectrical models for both the Carpathian and Washington anomalies require dipping conductive slabs of 1-5 ?? m material that extends to depths > 20 km. In both instances there is evidence that these materials may merge with lower crustal-mantle conductors along the down-dip margins of the slab. The main conductive units are interpreted to be sedimentary rocks that have been partially subducted due to collisional processes. Heat flow is low in both regions and it is difficult to explain fully the deep conduction mechanisms; however, evidence suggests that the conduction at depth may include electronic conduction in sulfide mineral or carbon films as well as ionic conduction in fluids or partial melt. ?? 1989.

Physics of the Earth and Planetary Interiors↗
USGS1983

Mineral resource potential map of the Great Rift Instant Study Area, Blaine, Butte, Minidoka, and Power counties, Idaho

A high potential exists for development of decorative building stone resources from slabby, glassy-surfaced pahoehoe lava flows, particularly in the Wapi lava field where the largest volume and variety of stone occurs. The unique appearance of the Blue Dragon flow material from the Craters of the Moon lava field may enhance its potential as a decorative stone resource. Locating speculative resources (uraniferous sediment, auriferous gravel, and geothermal reservoirs) and hypothetical resources (oil and gas) that may underlie the geologically young lava flows of the study area would require extensive geophysical exploration and drilling.

Idaho↗