Search USGS⌕ Search

Geology topics

Susan Hautala

Publications and source records attributed to Susan Hautala.

5 recordsLinked to original sources

Spatial mapping of dissolved methane using an in situ sensor in Puget Sound

Release of methane, as gas bubbles or in the dissolved phase, from the seafloor has been observed in coastal waters (< 200 m) and deep ocean basins (> 1000 m). Methane dissolution within the water column affects the geochemistry of the surrounding water, leading to localized oxygen loss and potential escape to the atmosphere, particularly from shallower sites. Traditional methods for detecting and quantifying dissolved methane rely on collecting discrete water samples for ship- or land-based ex situ analysis and post processing. Here, we report on the use of a reduced response time, in situ methane sensor, the Sensor for Aqueous Gases in the Environment (SAGE), for detecting and quantifying dissolved methane concentrations in a wide range of seafloor environments. During a Fall 2022 research cruise on the R/V Thomas G. Thompson in Puget Sound, SAGE was integrated onto a towed conductivity/temperature/depth rosette and deep-sea camera system with live-stream 1 Hz telemetry and used to spatially map the concentration of methane approximately 1 m above the seafloor. The site had been previously identified as an active methane plume field characterized by gas bubbles, fluid venting, and a faulted seabed. The widespread background dissolved concentration of methane measured by SAGE was 83 nM, and a range of 78–670 nM was observed throughout the survey. The results highlight the capacity of SAGE to map the spatial and temporal variability of dissolved methane concentrations in situ and to identify and localize sites of variable methane emissions from the seafloor.

Washington↗

Slow slip detectability in seafloor pressure records offshore Alaska

In subduction zones worldwide, seafloor pressure data are used to observe tectonic deformation, particularly from megathrust earthquakes and slow slip events (SSEs). However, such measurements are also sensitive to oceanographic circulation-generated pressures over a range of frequencies that conflate with tectonic signals of interest. Using seafloor pressure and temperature data from the Alaska Amphibious Community Seismic Experiment, and sea surface height data from satellite altimetry, we evaluate the efficacy of various seasonal and oceanographic pressure signal proxy corrections and conduct synthetic tests to determine their impact on the timing and amplitude prediction of ramp-like signals typical of SSEs. We find that subtracting out the first mode of the complex empirical orthogonal functions of the pressure records on either the shelf or slope yields signal root-mean-square error (RMS) reductions up to 73% or 80%, respectively. Additional correction with proxies that exploit the depth-dependent spatial coherence of pressure records provides cumulative variance reductions up to 83% and 93%, respectively. Our detectability tests show that the timing and amplitude of synthetic SSE-like ramps can be well constrained for ramp amplitudes ≥4 cm on the shelf and ≥2 cm on the slope, using a fully automated detector. The principal limits on detectability are residual abrupt changes in pressure that occur as part of the transition to and from summer to winter conditions but are not adequately characterized by our seasonal corrections, as well as the inability to properly account for instrumental drift, which is not readily separated from the seasonal signal.

Alaska↗

The finicky nature of earthquake shaking-triggered submarine sediment slope failures and sediment gravity flows

Since 2011, seafloor temperatures, pressures, and seismic ground motions have been measured by the seafloor cabled Dense Oceanfloor Network system for Earthquakes and Tsunamis (DONET) on the Nankai margin. These measurements, high-resolution bathymetry, and abundant contextual information make the DONET region seem ideally suited to provide constraints on seismic shaking-triggered sediment slope failures and gravity flows, particularly since numerous published studies have linked paleo- to modern earthquakes to failures and flows within the DONET. The occurrences of the local 2016 M6.0 Mie-ken and regional M7.0 Kumamoto earthquakes within and at regional distances, respectively, from the DONET data set provided an opportunity to explore this potential. We used DONET seismic recordings of the posited triggering shaking and to search for submarine slide signals and continuous temperature and pressure data to detect pulses of warm and densified water indicative of passing flows. We developed and applied a variety of analytical methods to eliminate signals generated by water column processes, while leaving slope failures and sediment gravity flow anomalies as residuals. Our explorations yielded no evidence that earthquake shaking initiated either phenomenon, which we suggest reflects the finicky nature both of the detection of and the physical processes that contribute to slope failures and flows (i.e., both require satisfying precise suites of conditions). Nonetheless, this negative result, our analyses, and the estimates of physical properties we derived for them, provide useful lessons and inputs for future studies.

Journal of Geophysical Research↗

Separating sea and slow slip signals on the seafloor

Seafloor pressure measurements hold promise for estimating vertical displacements from transient slow slip events on submarine faults. We assess the accuracy of pressure offset estimates that evolve over days to weeks and the confidence with which they may be attributed to tectonic deformation or to the ocean water column. One common approach to resolve this ambiguity assumes water column pressures vary insignificantly over the study region and are represented by stable reference site pressures. Assessing the validity of this assumption requires independent evidence. Correlations between pressures and colocated temperatures collected during the Hikurangi Ocean Bottom Investigation of Tremor and Slow Slip experiment suggest temperatures might provide a useful independent proxy for water column pressures. We compared offsets estimated using several methods, with temperature and other proxies. The use of a temperature proxy was unsuccessful, because seafloor temperatures did not track the seasonal signal that contributes significantly to seafloor pressure changes over the slow slip event period. Regardless of the estimation method, offsets varied within a few cm around some uncertain reference level. Commonly used statistical measures are shown not to be reliable indicators of offset accuracy since offsets contribute minimally to the total variance. Offsets estimated using identical methods but with seafloor pressures simulated using a regional ocean model were larger than those derived from the data but had a similar pattern. Since the model simulates only water column processes, this suggests a significant fraction of the estimated pressure offsets are due to seasonal water column signal and are not of tectonic origin.

Journal of Geophysical Research- Solid Earth↗

Sediment gravity flows triggered by remotely generated earthquake waves

Recent great earthquakes and tsunamis around the world have heightened awareness of the inevitability of similar events occurring within the Cascadia Subduction Zone of the Pacific Northwest. We analyzed seafloor temperature, pressure, and seismic signals, and video stills of sediment-enveloped instruments recorded during the 2011–2015 Cascadia Initiative experiment, and seafloor morphology. Our results led us to suggest that thick accretionary prism sediments amplified and extended seismic wave durations from the 11 April 2012 M w 8.6 Indian Ocean earthquake, located more than 13,500 km away. These waves triggered a sequence of small slope failures on the Cascadia margin that led to sediment gravity flows culminating in turbidity currents. Previous studies have related the triggering of sediment-laden gravity flows and turbidite deposition to local earthquakes, but this is the first study in which the originating seismic event is extremely distant (> 10,000 km). The possibility of remotely triggered slope failures that generate sediment-laden gravity flows should be considered in inferences of recurrence intervals of past great Cascadia earthquakes from turbidite sequences. Future similar studies may provide new understanding of submarine slope failures and turbidity currents and the hazards they pose to seafloor infrastructure and tsunami generation in regions both with and without local earthquakes.

Cascadia subduction zone↗