Geology topics

Stephen M. Wiele

Publications and source records attributed to Stephen M. Wiele.

11 recordsLinked to original sources

USGS2015

Continuous slope-area discharge records in Maricopa County, Arizona, 2004–2012

Continuous slope-area (CSA) streamgages have been developed and implemented by the U.S. Geological Survey (USGS) to enable the recording of discharge hydrographs in areas where direct discharge measurements cannot be made. The flashy nature of streamflow in parts of the arid Southwest and remote location of many sites make discharge measurements difficult or impossible to obtain. Consequently, available discharge measurements may be insufficient to develop accurate rating curves, which relate discharge to continuously recorded stage measured at standard streamgages. Nine CSA streamgages have been installed in Maricopa County, Arizona, since 2004 in cooperation with the Flood Control District of Maricopa County. This report presents the data and analysis of computed discharges from those streamgages, along with descriptions of the streamgage site and stream properties. Analyses of sources of errors and the impact stage data errors have on calculated discharge time series are considered, along with issues in data reduction. Steeper, longer stream reaches are generally less sensitive to measurement error. Other issues considered are pressure transducer drawdown, capture of flood peaks with discrete stage data, selection of stage record for development of rating curves, and minimum stages for the calculation of discharge.

Arizona↗

USGS2015

csa2sac—A program for computing discharge from continuous slope-area stage data

Introduction Continuous Slope-Area (CSA) gages were developed by the Arizona Water Science Center to enable the estimation of hydrographs when direct measurements of discharge cannot be made (Smith and others, 2010). CSA gages extend standard U.S. Geological Survey (USGS) methods for determining peak discharges to mid and high flows over a hydrograph computed at regular intervals with indirect measurement methods (Benson and Dalrymple, 1967; Dalrymple and Benson, 1967). CSA gages combine continuous stage records at two or more (typically three or four) cross sections with crosssection surveys and estimates of channel roughness to compute discharge over a range of flows. With standard indirect methods of determining peak discharge, water-surface elevation in the study reach at the peak flow is estimated from surveys of debris associated with the peak-flow water line. With CSA gages, stages are continuously measured at the cross sections, at regular and synchronized intervals (typically 5 minutes) over a flow event, and discharge can be calculated at each interval. Calculation of discharge using indirect methods has been automated with the slope-area computation (SAC) program (Fulford, 1994). SAC is a widely used program within the USGS; it is easily run and displays output in a clear and convenient format, which includes flags that alert the user to shortcomings in the calculation. Use of SAC has been facilitated by SACGUI (Bradley, 2012; SACGUI uses a version of SAC called SAC7), a user interface that directly reads and displays survey data, allows for specification of water-surface slope and channel roughness, writes the input file for SAC7, runs SAC7, and displays SAC7 output. csa2sac is a program (appendix 1) that repeatedly runs SAC7 using stage data and a SAC7 input template file to compute the discharge at CSA gages. It is written in the C programming language, and is compatible with 64-bit Windows operating systems. The program reads a SAC7 input file and a file containing stage-data time series. It writes a new version of the SAC7 input file with the stage data for one time step, runs SAC7, then extracts computed discharges from the SAC7 output file and collates the discharges and stages to a separate file. It repeats these steps for each time interval in the stage file to produce a discharge time series from the stage data. csa2sac has been tested with two, three, four, and six cross sections and found to operate successfully. By running SAC7, csa2sac maintains consistency and comparability of both discharges calculated from CSA gages and of standard USGS methods for computing discharges indirectly. Brown and Metcalfe (2014) have made available alternative software for producing CSA discharges. In addition to csa2sac, the SAC7 program is required. It is the same as the original SAC program, except that it is compiled for 64-bit Windows operating systems and has a slightly different command line input. It is available online (http://water.usgs.gov/software/SAC/) as part of the SACGUI installation program. The program name, “SAC7.exe,” is coded into csa2sac, and must not be changed.

Open-File Report↗

USGS2015

A comparison of estimates of basin-scale soil-moisture evapotranspiration and estimates of riparian groundwater evapotranspiration with implications for water budgets in the Verde Valley, Central Arizona, USA

Population growth in the Verde Valley in Arizona has led to efforts to better understand water availability in the watershed. Evapotranspiration (ET) is a substantial component of the water budget and a critical factor in estimating groundwater recharge in the area. In this study, four estimates of ET are compared and discussed with applications to the Verde Valley. Higher potential ET (PET) rates from the soil-water balance (SWB) recharge model resulted in an average annual ET volume about 17% greater than for ET from the basin characteristics (BCM) recharge model. Annual BCM PET volume, however, was greater by about a factor of 2 or more than SWB actual ET (AET) estimates, which are used in the SWB model to estimate groundwater recharge. ET also was estimated using a method that combines MODIS-EVI remote sensing data and geospatial information and by the MODFLOW-EVT ET package as part of a regional groundwater-flow model that includes the study area. Annual ET volumes were about same for upper-bound MODIS-EVI ET for perennial streams as for the MODFLOW ET estimates, with the small differences between the two methods having minimal impact on annual or longer groundwater budgets for the study area.

Arizona↗

USGS2012

Biotic, water-quality, and hydrologic metrics calculated for the analysis of temporal trends in National Water Quality Assessment Program Data in the Western United States

The U.S. Geological Survey's National Water-Quality Assessment (NAWQA) Program was established by Congress in 1991 to collect long-term, nationally consistent information on the quality of the Nation's streams and groundwater. The NAWQA Program utilizes interdisciplinary and dynamic studies that link the chemical and physical conditions of streams (such as flow and habitat) with ecosystem health and the biologic condition of algae, aquatic invertebrates, and fish communities. This report presents metrics derived from NAWQA data and the U.S. Geological Survey streamgaging network for sampling sites in the Western United States, as well as associated chemical, habitat, and streamflow properties. The metrics characterize the conditions of algae, aquatic invertebrates, and fish. In addition, we have compiled climate records and basin characteristics related to the NAWQA sampling sites. The calculated metrics and compiled data can be used to analyze ecohydrologic trends over time.

Open-File Report↗

USGS2011

Discharge and sediment concentration in the Bill Williams River and turbidity in Lake Havasu during and following high releases from Alamo Dam, Arizona, in March and April 2010

Discharges higher than are typically released from Alamo Dam in west-central Arizona were planned and released in 2005, 2006, 2007, 2008 and 2010 to study the effects of these releases on the Bill Williams River. The Bill Williams River Wildlife Refuge is located above the mouth of the Bill Williams River on Lake Havasu, and the river is the subject of ongoing ecological studies. Sediment concentrations and water discharges were measured in the Bill Williams River and turbidity, water temperature, specific conductance, pH, dissolved oxygen, and Secchi depth were measured in Lake Havasu during and after experimental releases in 2005 and 2006 from Alamo Dam. Additional measurements of the same parameters in the Bill Williams River and Lake Havasu were made during releases in 2010, and these are the subject of this report.

Open-File Report↗

USGS2010

The continuous slope-area method for computing event hydrographs

The continuous slope-area (CSA) method expands the slope-area method of computing peak discharge to a complete flow event. Continuously recording pressure transducers installed at three or more cross sections provide water-surface slopes and stage during an event that can be used with cross-section surveys and estimates of channel roughness to compute a continuous discharge hydrograph. The CSA method has been made feasible by the availability of low-cost recording pressure transducers that provide a continuous record of stage. The CSA method was implemented on the Babocomari River in Arizona in 2002 to monitor streamflow in the channel reach by installing eight pressure transducers in four cross sections within the reach. Continuous discharge hydrographs were constructed from five streamflow events during 2002-2006. Results from this study indicate that the CSA method can be used to obtain continuous hydrographs and rating curves can be generated from streamflow events.

Scientific Investigations Report↗

USGS2009

Sediment Transport in the Bill Williams River and Turbidity in Lake Havasu During and Following Two High Releases from Alamo Dam, Arizona, in 2005 and 2006

Discharges higher than are typically released from Alamo Dam in west-central Arizona were planned and released in 2005, 2006, 2007, and 2008 to study the effects of these releases on the Bill Williams River and Lake Havasu, into which the river debouches. Sediment concentrations and water discharges were measured in the Bill Williams River, and turbidity, temperature, and dissolved oxygen were measured in Lake Havasu during and after experimental releases in 2005 and 2006 from Alamo Dam. Data from such releases will support ongoing ecological studies, improve environmentally sensitive management of the river corridor, and support the development of a predictive relationship between the operation of Alamo Dam and downstream flows and their impact on Lake Havasu and the Colorado River. Elevated discharges in the Bill Williams River mobilize more sediment than during more typical dam operation and can generate a turbidity plume in Lake Havasu. The intakes for the Central Arizona Project, which transfers Colorado River water to central and southern Arizona, are near the mouth of the Bill Williams River. Measurement of the turbidity and the development of the plume over time consequently were important components of the study. In this report, the measurements of suspended sediment concentration and discharges in the Bill Williams River and of turbidity in Lake Havasu are presented along with calculations of silt and sand loads in the Bill Williams River. Sediment concentrations were varied and likely dependent on a variable supply. Sediment loads were calculated at the mouth of the river and near Planet, about 10 km upstream from the mouth for the 2005 release, and they indicate that a net increase in transport of silt and a net decrease in the transport of sand occurred in the reach between the two sites.

Scientific Investigations Report↗

USGS2008

Update of the Accounting Surface Along the Lower Colorado River

The accounting-surface method was developed in the 1990s by the U.S. Geological Survey, in cooperation with the Bureau of Reclamation, to identify wells outside the flood plain of the lower Colorado River that yield water that will be replaced by water from the river. This method was needed to identify which wells require an entitlement for diversion of water from the Colorado River and need to be included in accounting for consumptive use of Colorado River water as outlined in the Consolidated Decree of the United States Supreme Court in Arizona v. California. The method is based on the concept of a river aquifer and an accounting surface within the river aquifer. The study area includes the valley adjacent to the lower Colorado River and parts of some adjacent valleys in Arizona, California, Nevada, and Utah and extends from the east end of Lake Mead south to the southerly international boundary with Mexico. Contours for the original accounting surface were hand drawn based on the shape of the aquifer, water-surface elevations in the Colorado River and drainage ditches, and hydrologic judgment. This report documents an update of the original accounting surface based on updated water-surface elevations in the Colorado River and drainage ditches and the use of simple, physically based ground-water flow models to calculate the accounting surface in four areas adjacent to the free-flowing river.

Scientific Investigations Report↗

USGS2007

Flow Velocity and Sediment Data Collected During 1990 and 1991 at National Canyon, Colorado River, Arizona

During 1990 and 1991, a series of research flows were released from Glen Canyon Dam. Data collected at the streamflow-gaging station on the Colorado River above National Canyon near Supai from that period have been compiled and entered into the U.S. Geological Survey database. The data consist of measurements of suspended-sediment concentration and sand sizes in suspension, sand sizes of streambed sediment, and velocity of the Colorado River above National Canyon near Supai streamflow-gaging site. Velocity and sediment data are available upon request from the Arizona Water Science Center and from the U.S. Geological Survey water-quality database (http://waterdata.usgs.gov/az/nwis/qw).

Data Series↗

USGS2007

Streamflow and Sediment Data Collected to Determine the Effects of Low Summer Steady Flows and Habitat Maintenance Flows in 2000 on the Colorado River between Lees Ferry and Bright Angel Creek, Arizona

The low summer steady flows (LSSF) experiment of 2000 further demonstrated that spike flows released from Glen Canyon Dam redistribute sand from the channel bed and lower elevation parts of eddy sandbars to channel-margin deposits and the higher elevation parts of eddy sandbars. Unfortunately, summer 2000 was a period of unusually low tributary influx of sediment and there was little fine sediment (i.e., sand and finer material) available for redistribution. Nevertheless, the low steady flows, which held releases from the dam steady at 230 m3/s (8,100 ft3/s), during the summer of 2000 effectively retained on the channel bed the little sediment that was supplied by tributaries, and a subsequent 4-day, 870 m3/s (30,700 ft3/s) spike flow caused modest increases in the area of the mid-elevation zone of eddy sandbars.

Open-File Report↗

USGS2003

A stage-normalized function for the synthesis of stage-discharge relations for the Colorado River in Grand Canyon, Arizona

A method was developed to construct stage-discharge rating curves for the Colorado River in Grand Canyon, Arizona, using two stage-discharge pairs and a stage-normalized rating curve. Stage-discharge rating curves formulated with the stage-normalized curve method are compared to (1) stage-discharge rating curves for six temporary stage gages and two streamflow-gaging stations developed by combining stage records with modeled unsteady flow; (2) stage-discharge rating curves developed from stage records and discharge measurements at three streamflow-gaging stations; and (3) stages surveyed at known discharges at the Northern Arizona Sand Bar Studies sites. The stage-normalized curve method shows good agreement with field data when the discharges used in the construction of the rating curves are at least 200 cubic meters per second apart. Predictions of stage using the stage-normalized curve method are also compared to predictions of stage from a steady-flow model.

Arizona↗